热释电红外摄像机斩波调制电路的设计

本文提出了热释电红外摄像机斩波调制的电路模型，并对此电路模型进行了具体的电路设计和分析。     

测量输入光窗台阶指标的指示表的选择

阐述了对近贴聚焦型微通道板像增强管中输入光窗台阶高度和平整度指标进行测量时，所用指示仪表的选择依据，并详细分析了指示表在检定过程中的误差来源，进一步计算出其合成标准不确定度和扩展不确定度，从而选定可用于测试的指标表。     

有梭织机光电探纬系统的改进

依据红外反射式光电探纬的组成和工作原理，对有梭织机光电探纬系统进行了改进。将反光装置（膜）固定在梭芯上，减少了反光装置的数量，无需改动梭子和纬管，系统探纬准确，减少了换梭时纡脚回丝。     

轻型钢结构吊车梁设计方法及节点构造

通过分折和研究单层门式刚架轻型钢结构厂房中的吊车梁设计，总结了轻型钢结构吊车梁的设计方法和节点连接构造，对合理设计吊车梁，降低用钢量提出了设计建议。     

Hybrid gas-to-particle conversion and chemical vapor deposition for the production of porous alumina films

Porous alumina films can be found in a wide variety of materials, including filters, thermal insulation components, dielectrics, biomedical and catalyst supports, coatings and adsorbents. Production methods for these films are as equally diverse as their applications. In this work, a hybrid process based upon chemical vapor deposition and gas-to-particle conversion is presented as an alternative technique for producing porous alumina films, with the main advantages of solvent-free, low substrate-temperature operation. In this process, nanoparticles were produced in the vapor phase by reaction of aluminum acetylacetonate in the presence of oxygen. Downstream of this reaction zone, these nanoparticles were collected via thermophoresis onto a cooled substrate, forming a porous film. Some deposited films were subjected to post-processing in the form of annealing in air. Fourier-transform infrared spectra and X-ray energy-dispersive spectroscopy analysis confirmed the production of alumina at processing temperatures above 973 K. X-Ray diffraction revealed that the films were amorphous. Film thickness, ranging from 30 to 250 μm, and the average deposition rate were determined from scanning electron microscopy results. From transmission electron microscopy, the average primary particle size was determined to be approximately 18 nm and the formation of nanoparticle aggregates was evident. Annealing of the films at temperatures ranging from 523 to 1173 K in the presence of air did not have an effect on particle size. The specific surface area of the powder composing the films ranged from 10 to 185 m² g⁻¹, as determined from nitrogen gas adsorption by the Brunauer–Emmett–Teller method.     

轻质油中C1—C7轻烃的地球化学特征

作者对5个盆地18个轻质油样品作了C_1—C_7轻烃分析,检测出29种单体轻烃。通过轻烃组成特征研究,认识到石蜡指数(PI_1)和庚烷值(PI_2)作为成熟度的指标,不受沉积盆地类型影响;C_6,C_7烃类族组分受母质类型影响较大。陆相(含煤地层)有机质生成轻质芳烃(苯)的含量比海相有机质要高。新疆塔里木盆地沙参2井原油的轻烃分析资料表明,该井油源岩为海相沉积。     

雅克拉凝析气田高压脱水工艺的成功应用

雅克拉凝析气田位于新疆阿克苏境内，2005年11月29日建成投运的260×10⁴m³/d雅克拉集气处理站是目前中石化最大的高压凝析气处理装置。该站的高压分子筛脱水工艺为两塔流程，采用差压再生（吸附压力5.9 MPa、再生压力2.8 MPa）、再生气自动回收工艺技术，并采用时序控制程序自动切换，具有工艺简单可靠、自动化程度高、热能利用率高、脱水露点深度高、操作维护简单、投资较少、运行成本低等优点，自建成投产以来运行稳定，效果十分显著。该工艺装置的成功应用，对类似脱水装置设计、操作具有一定参考价值。     

Identification of gaps in mangrove forests with airborne LIDAR

Mangrove forests change frequently due to disturbances from tropical storms, frost, lightning, and insects. It has been suggested that the death and regeneration of trees in small gaps due to lightning may play a critical role in mangrove forest turnover; however, the large-scale quantification of spatial pattern and areas of gaps is lacking for investigating this issue. Airborne light detection and ranging (LIDAR) technology provides an effective way for identifying gaps by remotely obtaining direct measurements of ground and canopy elevations. A method based on an alternative sequential filter and black top-hat mathematical morphological transformation was developed to extract gap features. Comparison of identified gap polygons with raw LIDAR measurements and field surveys shows that the proposed method successfully extracted gap features in mangrove forests in Everglades National Park. There are 400–500 lightning gaps per square kilometer in mangrove forests at the study sites. The distribution of gap sizes follows an exponential form and the area of gaps with sizes larger than 100 m² account for 55–61% of the total area of gaps. The area of gaps in the mangrove forest in Everglades National Park is about 4–5% of the total forest area and the average gap formation rate is about 0.3% of the total forest area per year, indicating that lightning gaps play an important role in mangrove forest dynamics.     

住宅电气设计中应注意的细节问题

就住宅电气设计中，常常被忽略的细节问题进行阐述，提出了在住宅室内几个功能区内，如何使灯具和插座的布置更合理，以最大限度地满足居住者的需求。     

源气体流量比对F-DLC薄膜结构的影响

以高纯石墨作靶，CHF3/Ar作源气体采用反应磁控溅射法制备出了氟化类金刚石（F-DLC）薄膜。拉曼光谱表明，CHF3相对流量的增加会引起薄膜的D峰与G峰强度之比I（D）/I（G）减小，晶粒增大，芳香环结构出例下降。红外吸收光谱分析证实了这些推论，指出这是由于薄膜中氟含量上升的结果。