Bi2—xPbxSr2Ca2Cu3Oy系高Tc超导体相变的研究

用DSC研究了高T_e超导体B_(2-r)Pb_rSr_2Ca_2Cu_sO_v(x=0,0.2,0.4,0.6)从室温至600℃范围内的相变。在320℃和440℃附近有二个吸热蜂,每一个峰对应一个相变过程。440℃附近的相变是不可递的,其原子激活能为1.37eV,是由高T_e相向低T_e相的转变。而320℃附近的相变则与超结构的形成有关。     

Carbonaceous adsorbents from sewage sludge and their application in a combined activated sludge-powdered activated carbon (AS-PAC) treatment

In this study, waste biological sludge is converted to an adsorbent by chemical activation with sulphuric acid. The adsorbent obtained is then applied to the aerated vessel of an activated sludge process treating glucose and phenol to improve the quality of the treated effluent. The sludge-based carbonaceous adsorbent was found to be mesoporous in nature, with a good adsorption capacity for large molecular weight compounds and limited removal efficiency for smaller molecules such as phenol. The addition of carbon, either sludge-based or commercial, enhanced phenol removal from 58% to 98.7% and from 87% to 93% the organic matter removal as measured by the chemical oxygen demand (COD) when operated with feed concentrations of 100 mg phenol/l and 2500 mg COD/l. No differences were found between the activated sludge-activated carbon bench scale continuous reactors operating with either commercial or sludge-based adsorbents in spite of the higher adsorption capacity of the former. It is suggested that powdered adsorbent bioregeneration in the combined AS-PAC system may be impaired by the obstruction of pores due to bacterial growth, the effect being more important for the commercial activated carbon with a narrower pore size distribution.     

碳纤维经氧等离子/KH550处理后的表面形态和结构

碳纤维(CF)表面经氧等离子、KH550和 LiAlH_4处理后,其物理和化学性能得以改善.由于提高了 CF 和树脂间的联结,使 CF 复合材料的层间剪切强度提高50%以上,在湿热下的强度保留率达94%以上.使用纤维接触角测定仪,SEM 和 XPS 等对 CF 表面的浸润性、形态和化学组成进行了研究.实验指出:CF 经等离子和 KH550处理后,其临界表面能有了提高;CF 本身仅受氧离子刻蚀,故其拉伸强度的损失小于其他处理方法.     

炭黑填充硬聚氯乙烯的改性

为使聚氯乙烯具有抗静电性能,采用加入具有导电性填料的方法,但加入大量的填料,会使硬聚氯乙烯的冲击性能降低,加工性能变差。本文是在以炭黑为填料的基础上,研究不同的改性剂和加工助剂改进硬聚氯乙烯的效果,结果表明,加入冲击改性剂和加工助剂后,大大增加了硬聚氯乙烯的冲击强度,且加工性能也得到改善,同时由于炭黑具有补强效果,其拉伸强度和弯曲强度在加入改性剂后也能满足使用要求。     

飞机碱性电瓶充放电参数测量仪的设计与研究

电瓶是民航飞机可靠供电的最后保证。飞机制造厂家提高了对电瓶的性能和容量检测要求,传统的电瓶充放电装置已经无法满足新的要求。利用单片机技术研制的飞机电瓶参数测试仪,实现了对电瓶各种参数的实时侧量和分析,为飞机电瓶维护和检测提供依据。     

炭分子筛概述

阐述了炭分子筛分离的原理，并分别从其制备原料、制备方法、产品用途等方面综述了近年来炭分子筛的新进展。     

SOLUBILITY OF CO2 AND H2S IN A HINDERED AMINE SOLUTION

The solubility of H₂S and CO₂ in aqueous solutions of the sterically hindered amine, 2-amino-2-methyl-1-propanol (AMP), was determined at 40 and 100°C. Partial pressures of C)₂ ranged from approximately 2 to 6000 kPa and of H₂S from 2 to 2200 kPa. The solubility results were compared with previously reported acid gas solubilities in aqueous monoethanolamine (MEA) solutions.     

Cinétique de dégagement des matières volatiles lors de la pyrolyse d'électrodes de carbone industrielles

In aluminium plants, the anode baking process is associated with an important release of volatile combustible matter. It is the purpose of this study to investigate the kinetics of the evolution of these volatiles. A large thermogravimetry set-up has been designed in such a way that it could simulate real plant conditions. Samples of two distinct masses have been subjected to pyrolysis at different heating regimes. The loss of weight together with the concentrations of the released gases were recorded on a continuous basis during the temperature rise. Kinetic results were found for methane, hydrogen and tar. No variation of the order of reaction with the heating rate was observed, whereas the activation energy and the pre-exponential factor increased. Furthermore, for the range of sample dimensions studied, it was found that the mass of the solid had no significant influence on the kinetic parameters.     

Adsorption isotherms of sesame oil in a concentrated miscella system

The adsorption of peroxides, unsaturated carbonyls, free fatty acids and carotenoids from unrefined sesame oil on vegetable carbon (5%, w/w) in a miscella system was studied. Three different solvent conditions (hexane/ethanol, 100:0, 95:5 and 75:25, vol/vol), combined in a factorial design with five levels of solvent (0, 10, 20, 30 and 40%, w/w), were used to develop the miscella. Equilibrium adsorption was not achieved during the 100 min of adsorption, mainly because the oil components were involved in oxidation reactions during the adsorption process. However, for a given solvent concentration, adsorption of the oil components showed a significant linear regression on their respective initial concentration in the miscella (C_i). Peroxides and carbonyls showed, at all solvent levels investigated, an affinity for the carbon more independent of their C_i than free fatty acids and carotenoids. In general, at the same C_i, a higher adsorption was achieved as solvent concentration increased. The results indicated that free fatty acid adsorption may depend on competitive adsorption based on molecule hydrophobicity. However, in spite of the higher hydrophobicity of carotenoids, compared with free fatty acids, they might not be competing for the same adsorbing sites. Ethanol showed a prooxidant effect that increased peroxide production during adsorption but did not affect the reaction involved in carbonyl production.