BC—1型白平衡仪的原理与实践

ＢＣ－１型白平衡仪是一种光电积分式测色仪器，它通过颜色传感器获取屏幕的红，绿，蓝三条色信号，与预先存储在仪器中的标准信号值相比较通过ＬＥＤ条形显示器显示两者之偏差，用以直接指导彩电生产线的白平衡调整，仪器采用Ｉｎｔｅｌ１８０９８单片微机为系统核心，内藏信号发生器，仪器可任选红，绿，蓝作为基准色，具有基色亮度自动调整功能，该仪器的定标方法简单，快捷，可方便地存储８套基准白场标准数据，该仪器已可靠在应     

The role of forest and bioenergy strategies in the global carbon cycle

Forest and bioenergy strategies offer the prospect of reduced CO₂ emissions to the atmosphere. Such strategies can affect the net flux of carbon to the atmosphere through 4 mechanisms: storage of C in the biosphere; storage of C in forest products; use of biofuels to displace fossil-fuel use; use of wood products which often displaces other products that require more fossil fuel for their production. We use the mathematical model GORCAM (Graz/Oak Ridge Carbon Accounting Model) to examine these mechanisms for 16 land-use scenarios. Over long time intervals the amount of C stored in the biosphere and in forest products reaches a steady state and continuing mitigation of C emissions depends on the extent to which fossil fuel use is displaced by the use of bioenergy and wood products. The relative effectiveness of alternative forest and bioenergy strategies and their impact on net C emissions strongly depend, for example, on the productivity of the site, its current usage, and the efficiency with which the harvest is used. When growth rates are high and harvest is used efficiently, the dominant opportunity for net reduction in C emissions is seen to be fossil-fuel displacement. At the growth rates and efficiencies of harvest utilization adopted in many of our base scenarios, the net C balance at the end of 100 years is very similar whether trees are harvested and used for energy and traditional forest products, or reforestation and forest protection strategies are implemented. The C balance on a plantation system that provides a constant output of biomass products can look different than the balance of a single parcel of land.     

武钢 3×10~4m~3/h 空分手动变负荷生产的探索与实践

对武钢引进的两台３×１０４ｍ３／ｈ空分设备，为改变其自动变负荷生产调节范围小、时间长的问题，采用了人工手动变负荷的操作方法。实践表明：扩大了增减产范围，缩短了调节时间，有十分明显的综合经济效益，可供大型空分变负荷生产借鉴参考。     

二滩电厂双缸液压启闭机原理及故障分析

二滩电厂表孔采用弧形门,启闭形式为双缸液压启闭机.自投入运行以来,运行状况良好.汛期启闭方式已由原来的现地手动操作过渡到远方控制自动启闭.在闸门起落的过程中,由于工况的不同,两缸会出现不同步现象,因此设计中考虑了纠偏回路.本文简单介绍了二滩电厂表孔液压启闭机的原理和故障情况.     

紧凑 Tokamak(球形环)聚变堆第一壁及中心导体柱上中子负荷及核热计算与分析

采用通用蒙特卡罗粒子输运程序ＭＣＮＰ／３８计算低环径比Ｔｏｋａｍａｋ（紧凑环或球形环）聚变堆第一壁及中心导体上的中子壁负荷分布和核热沉积分布，并与常规Ｔｏｋａｍａｋ堆第一壁上中子壁负荷分布和核热沉积分布进行比较、分析。结果表明，在中子壁负荷归一化为１ＭＷ／ｍ２时，与常规Ｔｏｋａｍａｋ相比，在低环径比Ｔｏｋａｍａｋ堆第一壁及中心柱表面上中子壁负荷分布峰值并不比常规Ｔｏｋａｍａｋ堆第一壁上的峰值高，而且低于低环径比Ｔｏｋａｍａｋ堆整个第一壁上的平均值，而中心柱上的核热沉积峰值稍高于常规Ｔｏｋａｍａｋ堆第一壁上的核热沉积峰值，但对较高中子壁负荷情况，中心导体柱上的核热沉积和辐照损伤仍可能是比较严重和值得特别研究的问题。     

Multiobjective dynamic load-dispatching method for optimal operation of power systems

A new practical method is proposed which gives a quasi-optimal solution of the dynamic load-dispatching problem formulated by a multiconstraint multiobjective optimization problem. Here, the multiple constraints are rate reserve constraints and power flow ones, and the multiple objectives are fuel cost and CO₂ emission. The proposed method is an integration of the following three techniques: (1) “Group Dispatch Scheme,” which is developed by the authors, is used to satisfy a violated constraint easily. This scheme consists of three steps. The first step is to classify all generators into two groups. One is the group which should be more loaded to satisfy the violated constraint, and the other is the should-be less loaded group. The second step is to add some load to the former group, and to subtract the same load from the latter. The third step is to dispatch each group load to each groups generators, respectively; (2) the dynamic load-dispatching algorithm is used which provides, in practical time, quasi-optimal generation trajectories; (3) the conventional weighting parametric method is used to obtain a Pareto optimal solution of multiobjective problems. The effectiveness of the method is clarified by a computer simulation on the actual power system of Kansai Electric Power Company.     

太钢3#高炉重力除尘器大件吊装

太钢3#高炉大修改造是集团公司重点外部工程项目之一，工程量大，工期紧，施工场地狭小，而质量要求较高。如何采取科学、经济的设备吊装方案，对整个项目经济指标的实现，意义重大。文章详细介绍了太钢3#高炉重力除尘器大件整体吊装方案。通过实际采用，取得良好的经济效果。     

本钢7号高炉中控室10kV供电系统技术分析及改进方案实施

根据7号高炉中控室供电状况，进行了供电平衡分析。调整两段负荷，使供电平衡安全。     

应力、强度呈非正态分布时可靠度公式的推导

介绍一种当应力、强度呈非正态分布时的可靠度的计算方法,以用来进行机械可靠性设计,并以一个地震载荷的直立压力容器为例加以说明。     

水轮机调速器与电网负荷频率控制

在现代电力系统中，水轮机调速器已成为水轮机控制系统的控制核心。文中叙述了水轮机调速器与电网负荷频率控制之间的关系，分析了调速器在电网一次调频、二次调频中的作用、静态特性和动态特性;通过建模、仿真及现场试验，提出了机组并联于大电网工况下的调速器PID参数整定范围和应有的机组功率控制模式。