预测水驱油田开发动态的一种方法

水驱曲线法和数学模型法都是油藏工程中的重要方法，前者主要用于在一定的经济含水条件下预测水驱油田的可采储量和采收率，后者主要用于预测不同类型油田的产量、累积产量和一定经济极限产量下的可采储量。然而，前者与时间序列无关，后者与含水率序列无关，都有局限性。提出丙型水驱曲线公式与ＨＣＺ数学模型公式联解预测法，不但可以预测水驱油田产量、累积产量、含水率随时间的变化，还可预测可采储量、可动油储量和水驱波及体积系数的变化。图３表１参１２（陈志宏摘）     

双重孔隙介质油藏中的吸渗排油作用

利用美国SSI公司研制的COMPN模拟软件对双重孔隙介质油藏一种重要的开采机理 吸渗排油进行了模拟研究,考察了一个基质岩块为四周裂缝所包围时.在驱动压力和毛管压力的不同平衡(驱动压力和毛管压力的相对大小)关系下的水驱油采收率和水驱油效率的变化规律.     

低温粉碎系统中旋风分离器设计

旋风分离器是一种应用离心力进行粉体分离的设备。低温粉碎系统应用它分离粉体并起集粉作用。它的效率决定了物质回收率。本文从离心加速度与重力加速度的比值，筒体的高低，筒体直径，进口速度叙述对分离器效率的影响。着重叙述筒体直径确定方法，以及我们设计造长筒形旋风分离器的具体结构和令人满意的试验结果。     

碱性氰化物防渗碳光亮镀铜工艺的研究

本文介绍了一种高效率，高韧性，防渗碳底铜工艺，可以大辐度提高镀层的沉积速度，降低铜层孔隙率，提高产品合格率，具有显著的经济效益和社会效益。     

太钢4号高炉喷煤站应用MFD—Ⅲ型布袋除尘器的实践

太钢４号高炉喷煤站从１９９０年起采用ＭＦＤ－Ⅲ型脉动反吹式布袋除尘器。这种除尘器采用脉动式反吹清灰设施，合理布置布袋间距，布袋支撑骨架及选用针呢材质的布袋，过滤面积大，反吹清灰效果好，设备运行平稳，除尘效率高达９９．８％，排放浓度小于１０ｍｇ／ｍ＾３，故障率低。     

发展我国电动汽车的对策

本文根据目前国内外的最新资料，论述了电动汽车的优缺点，介绍了我国电动汽车发展状况，文章从当前电动汽车已达到的技术水平和我国环境污染、能源短缺的实际需要出发，提出了发展我国电动汽车的对策．     

一种双光束自动测试光栅绝对与相对光谱衍射效率的原理性方案

提出了一种快速自动测试光栅光谱衍射效率的新方法。重点推导了测试平面光栅绝对光谱衍射效率与相对光谱衍射效率公式，介绍了双光束高精度自动测试光栅光谱衍射效率曲线的基本原理、方案与方法，并分析了测试精度。研究表明，本方案的测试速度和精度均比一般测试方法提高一倍，并能有效地消除光源波动对测量结果的影响，测量误差小于５×１０－３。     

GIC－4117／HC1．7MV Tandetron上的MeV离子注入系统

利用通用离子公司（ＧＩＣ）的４１１７型１．７ＭＶＴａｎｄｅｔｒｏｎ离子束分析设备进行ＭｅＶ级离子注入。所注入的离子能量范围由５００ｋｅＶ到１０ＭｅＶ，离子的质量在２４０ｕ以下，某些元素的负离子束流强度在１５０μＡ以上。双向机械扫描技术可将离子均匀地注入样片。     

Comparison of mass transfer efficiency in horizontal rotating packed beds and rotating biological contactors

In this study, the mass transfer efficiencies of a novel horizontal rotating packed (h‐RPB) bed and the conventional disc‐type rotating biological contactor (RBC) were studied at four speeds and seven submergences. Pall rings of two different sizes (25, 38 mm), superintalox saddles and a wiremesh spiral bundle were used as packings in the h‐RPB. Volumetric gas–liquid mass transfer coefficients were determined by unsteady state absorption of atmospheric oxygen in de‐aerated water. Power consumption per unit liquid volume has been found for all geometries tested. The oxygen transfer efficiency values for the h‐RPB were found to be 2–5 kg kWh^?1 and for the disc RBC were found to be 1–2 kg kWh^?1. The performance of the h‐RPB was also compared with other gas–liquid contactors such as surface aerators. The study proves that the h‐RPB is a energy efficient alternative to conventional contactors. Copyright © 2005 Society of Chemical Industry     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry