Influence of a Jump in the Power of Laser Radiation on Its Measurement

Simulation and investigation of the effect of an isolated jump on realization of the unit of power of laser radiation and dissemination of the size of the unit are considered. Results are obtained by means of a newly developed algorithm that characterizes the behavior of the mean value of a signal and the standard deviation of a system as functions of the parameters of a jump in the power of laser radiation and the length and amplitude of the jump. If information concerning the time when a jump occurs is available, the proposed algorithm makes it possible to take into account how a jump affects the ultimate result of a measurement.     

液动旋冲接头冲击功测试方法研究

液动旋冲接头性能参数是旋冲接头设计的主要依据之一，如何对液动旋冲接头的参数进行检测是非常重要的工作。在分析和比较了测试液动旋冲接头性能参数各种方法的基础上，选择了冲击力法来进行破岩液动旋冲接头的性能参数测试，以YD系列测力传感器为检测元件，建立了一套比较完善的自动检测系统。分析了影响单次冲击功测试的因素，得出了测试旋冲接头的性能参数的影响规律。     

电源设备的功率因数校正技术

功率因数校正(PFC)技术能提高电源设备的电源利用率，减少谐波。文中介绍了功率因数的定义，功率因数校正技术及其应用实例。     

供电器可供放大器最大级数的计算

有线电视电缆网采用供电器进行集中供电，要计算一个额定容量的供电器可供放大器的最大级数，算式是很复杂的，而用VisaulFOXPRO6．0编写一个小程序，利用电脑对上述问题进行处理，就变得简单易用。     

TOPSwitch集成电路在DC/DC电源设计中的应用

文章介绍了PWM／MOSFET二合一的TOPSwitch系列集成电路及其在DC／DC电源设计中的应用，还介绍了基本反馈方式的DC／DC拓扑结构及其改进措施，并对由TOPSwitch集成电路构成的DC／DC电源进行了抗中子实验。     

大型石油化工企业供配电系统

根据大型石油化工企业供配电特点 ,介绍了石油化工企业内三种主要的供配电方式 ,并对其进行了较详细的分析比较     

高功率固体激光器

本文详细讨论了设计高平均功率固体激光器的有关问题,包括激光材料性质、棒状和板条状几何结构,聚光器和光学谐振腔等。分析表明,板条状几何结构固体激光器提供了达到千瓦级功率水平同时又保持良好光束质量的可能性。     

Reduction of low-frequency pressure fluctuations in wind tunnels

The determination of dynamic wind loads on buildings, i.e. pressure and deflection, has gained increasing interest (European Prestandard ENV 1991-2-4, Eurocode 1: basis of design and actions on structures—Part 2-4: actions on structures—wind actions, European Committe for Standardization, Brussels, 1995; DIN 1055 Teil 4 Lastannahmen für Bauten, Verkehrslasten, Windlasten bei nicht schwingungsanfälligen Bauwerken, 1991; N. Hölscher, M. Hortmanns, J. Sahlem, Praxisnahe Erfassung von Windwirkung an Industrie- und Hochbauten, Windwirkung im Bauwesen, Braunschweig, 7, Dreiländertagung D-A-CH 2001, Windtechnologische Gesselschaft, 2001 [1], [2] and [3]). Therefore, the spectral distributions of velocity and pressure fluctuations in wind tunnels are an important quality aspect. While velocity fluctuations can be manipulated by the obstacles used to create the turbulence, pressure fluctuations are influenced by acoustic noise as well. Especially, the first eigenfrequency of the longitudinal mode of the wind tunnel tends to disturb the pressure spectrum.In this paper, a solution for the reduction of low-frequency acoustic pressure fluctuation is presented and its application in the atmospheric boundary layer wind tunnel at the IAG is shown.     

Development of cable fault location method using fiber optic distributed temperature sensor

When ground-fault problems occur on a cable line, immediate fault location and restoration are required. Therefore, various new methods to locate the fault point instantaneously have been investigated to replace such conventional methods as the Murray loop method and the pulse radar method [1]. These methods require a long time to locate the fault point. One possible fault location method is to sense the temperature rise following a ground fault using a fiber optic distributed temperature sensor. Application of this method was found feasible through sensing the temperature rise at a ground-fault test using a thermocouple as a temperature sensor with test cables [4]. A power/optical composite cable was prepared experimentally and after verifying its thermal mechanical performance, the temperature rise at an incidence of a fault was determined and the anticipated performance was demonstrated in a ground-fault test. This article describes the outline of the test.     

用于泵浦固体激光器的激光二极管线阵的输出特性

从实验上测量了激光二极管线阵的输出特性,研究了温度、电流对输出功率、光谱特性,以及偏振特性的影响,为设计全固态激光器提供有益的参考。