Simulation of Temperature Distribution in Stored Wheat without Aeration

A neural-deterministic simulation model applied for calculating distributions of temperatures and moisture content in a bed of wheat stored in a steel silo without aeration is presented in the article. The model consists of differential equations of heat and moisture transfer, initial and boundary conditions, and three artificial neural networks used during simulated ambient air conditions. Experiments and computer simulations were carried out in order to determine temperature fields in wheat grain stored in a steel silo for two months. The computer simulations were carried using MATLAB and FEMLAB software. The difference between measured and simulated temperature in grain near the silo wall at a height of 2.5 m from the bottom was less than 3.0°C. On the basis of the analysis performed it was concluded that the temperature distributions obtained with the model were consistent with the measured results obtained for grain stored in a steel silo without aeration.     

储层石蜡沉积预测技术研究与应用

在油田开发过程中 ,由于油藏温度、压力等条件的变化 ,高含蜡原油在近井带容易产生石蜡沉积 ,堵塞地层孔隙或裂缝 ,严重影响油田开采 ,尤其对于低渗油田 ,伤害特别严重。文中应用理想溶液理论、质量守恒和能量守恒等基本原理 ,建立更符合油田实际情况的油藏中石蜡沉积预测数学模型 ,开发一套方便实用的油藏中石蜡沉积预测软件系统FPOS1 0。在此基础上 ,应用室内实验数据和现场数据对吉林新民油田油井石蜡沉积情况进行预测和现场拟合 ,确定新民油田临界石蜡沉积半径为 2 5m ,快速、准确地为现场清防蜡措施提供理论依据。     

Lyapunov‐stable discrete‐time model reference adaptive control

Discrete‐time model reference adaptive control (MRAC) is considered with both least squares and projection algorithm parameter identification. For both cases complete Lyapunov proofs are given for stability and convergence. The results extend the approach of Johansson (Int. J. Control 1989; 50 (3):859–869) to include Lyapunov stability for MRAC when the normalized projection algorithm is used for parameter identification. Copyright © 2005 John Wiley & Sons, Ltd.     

DRYING OF GRANULAR PARTICLES IN A MULTISTAGE INCLINED FLUIDIZED BED WITH MECHANICAL VIBRATION

A mathematical model for the drying rate of granular particles in a multistage inclined fluidized bed(IFB) is presented from the standpoint of simultaneous heat and mass transfer, with taking the effect of mechanical vibration added vertically into consideration.

Steady-state distributions for the temperatures and concentrations of the particles and the heating gas, and for the moisture content of the particles are numerically calculated based on the present model. The calculated results show fairly good agreement with the experimental data, which were obtained from the drying experiments of brick particles in a three-stage IFB using comparatively low temperature air(40-60°C) as the heating gas.

It has been found within the range of the experimental conditions employed that, the mechanical vibration added vertically enhances the over-all drying rate of the particles and its effect can be considered equivalent to an increase in the air velocity.     

The influence of the ion content of whey on the pH-activity profile of the β-galactosidase from Aspergillus oryzae

The pH-dependence of the reaction kinetics of lactase (β-galactosidase) from Aspergillus oryzae in different reaction media is presented in terms of a two-parameter model. The lactase from A. oryzae seems to have replaced the A. niger lactase on the market owing to a better activity/price ratio and may be utilised for lactose hydrolysis in acid as well as in neutral milk products. Its pH optimum is around pH 4.5. However, in the neutral pH-range its activity depended strongly on the salt content of the substrate solution. For example, its activity in whey (pH 6.5) fell to only 30% of its expected activity in a pure lactose solution at the same pH. The whey effect was the same for both soluble and immobilised lactase. The two parameter kinetic model, which included a term for competitive product inhibition gave excellent agreement with experimental data, and may thus be useful for the prediction of reactor performance with this enzyme.     

Alternating,all-trans polyenynes: Model compounds for poly(diacetylene)s with defined conjugation length

The syntheses of polyenynes as model compounds for poly(diacetylene)s (PDAs) are described. Variation of properties (UV–VIS, Raman, NMR and bond geometries) as a function of the chain length was investigated. After extrapolation to infinite chain length these data were compared to those for PDAs. From UV–VIS spectra a value of λ = 551 nm (2.25 eV) was calculated corresponding to the electronic transition of a single polyenyne chain. This energy is located at the low energy end of a yellow PDA solution spectrum. From Raman scattering v_(C?C) = 2108–2128 cm^?1 and v_(C?C) = 1505–1532 cm^?1 were calculated after extrapolation. Similarly sp-C¹³C NMR data yielded a shift of δ = 100 ppm. These data are almost identical to data known for yellow PDA solutions. Bond geometries are almost identical to those of poly(diacetylene)s and theoretical data.     

Adaptive predictive control algorithm based on Laguerre Functional Model

Laguerre Functional Model has many advantages such as good approximation capability for the variances of system time‐delay, order and other structural parameters, low computational complexity, and the facility of online parameter identification, etc., so this model is suitable for complex industrial process control. A series of successful applications have been gained in linear and non‐linear predictive control fields by the control algorithm based on Laguerre Functional Model, however, former researchers have not systemically brought forward the theoretical analyses of the stability, robustness, and steady‐state performance of this algorithm, which are the keys to guarantee the feasibility of the control algorithm fundamentally. Aimed at this problem, we introduce the principles of the Incremental Mode Linear Laguerre Predictive Control (IMLLPC) algorithm, and then systemically propose the theoretical analyses and proofs of the stability and robustness of the algorithm, in addition, we also put forward the steady‐state performance analysis. At last, the control performances of this algorithm on two different physical industrial plants are presented in detail, and a number of experimental results validate the feasibility and superiority of IMLLPC algorithm. Copyright © 2005 John Wiley & Sons, Ltd.     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

Simulation of water and nitrogen dynamics in soils during wastewater applications by using a finite-element model

A mathematical model was developed to simulate water movement, mass transport, and nitrogen transformations in soils during wastewater applications. The model is one-dimensional and based on the Galerkin finite-element method. The submodel of mass transport of nitrogen incorporates the convection-dispersion processes of ammonium and nitrate nitrogen, nitrification, denitrification, ammonium exchange and uptake of ammonium and nitrate ions. The accuracy and validity of the proposed model was examined by comparison with an explicit-implicit finite-difference model results. The model was used for simulation of water and nitrogen dynamics during wastewater application in homogeneous and multi-layered soils under different N concentration, rate, duration and scheduling of application.     

A micromechanics model for the prediction of static strength of off-axis unidirectional laminates

In this paper a micromechanics model using the concentric cylinder assemblage model and the Mori-Tanaka average stress scheme is used to predict the static strength of unidirectional angle ply laminates. The predicted strengths agree with experimental results for Glass/Epoxy and Graphite/Epoxy systems.