油气微运移的烃类相态

微运移机制是目前油气化探等非地震直接找油的理论基础,只有研究清楚油气微运移的相态,才可能进一步研究微运移的机制;含油气水相是油气发生微运移最普遍和优先起作用的相态;在特定的地质条件下,不排除油气以其它相态发生渗漏的可能。     

HPMBP与伯胺N_(1923)对希土元素(Ⅲ)的协同萃取

本文研究了HPMBP与伯胺N_(1923)的二甲苯溶液,从盐酸介质中协同萃取希土(Ⅲ)的机理。用斜率法、恒摩尔法确定了协萃配合物的组成为:RNH_3Ln(PMBP)_4。求得关于Pr(Ⅲ)协萃反应的平衡常数及协萃配合物的生成常数分别为:logK_(12)=-1.95;logβ_(12)=3.94。实验发现,协萃系数(R)随希土元素的原子序数(Z)递变而呈现“双峰效应”。还研究了协萃配合物的IR,NMR谱。     

Mg_(0.15)Zn_(0.85)O:Tb合金薄膜的阴极射线发光性质研究

采用溶胶凝胶方法成功地制备了掺杂稀土铽离子的 Zn O和 Mg0 .1 5Zn0 .85薄膜。通过对 X射线衍射结果的分析表明 ,稀土离子替代了 Zn2 +的格位 ,进入了半导体基质的晶格中。从阴极射线发光结果可以发现 ,在Mg0 .1 5Zn0 .85O基质中 ,可以观察到来源于稀土铽离子各能级的发射 ,而 Zn O:Tb的薄膜只能观察到较强的铽离子 5D4 — 7F5能级的跃迁。这可能是由于 Mg0 .1 5Zn0 .85O基质的能隙 (3 .65 e V)比 Zn O更宽 (3 .3 e V) ,其对铽离子的能量传递更有效的缘故。     

液晶显示驱动电路中Fibonacci型电荷泵单元

本文中所设计的电荷泵将用于手机液晶显示驱动模块中.通过对Fibonacci型电荷泵上升时间的估算,对减小上升时间和动态功耗进行折中考虑,本文提出优化开关频率的方法.用1.2μm CMOS双阱工艺参数对所设计的电荷泵进行模拟,结果表明这个电荷泵具有较快的上升速度和较高的效率.通过提高V_GS电平和保证开关管的衬底始终接在最高电位上,文中提出了一种新型Fibonacci电荷泵,它可以正常工作在从1.2V到5V变化的多种电源电压下.     

固定电话网的新趋势——固网信息服务系统

本文首先讨论了中国电信开展固网短信业务的必要性，然后分析了开展固网短信业务存在的问题，最后介绍了固网短信系统的构成。     

Generation of Technology-Independent Retargetable Analog Blocks

This paper introduces a complete methodology for retargeting of analog cells to different sets of specifications. This methodology is technology-independent, thus allowing the migration, from one technology to another, of the circuit under retargeting. Careful integration of the device sizing and layout generation tasks via the incorporation of layout constraints during the sizing process allows to generate fully functional designs in a few minutes. The methodology is illustrated via the retargeting of a fully-differential Miller-compensated two-stage operational amplifier for a new set of specifications and two different technological processes.An erratum to this article can be found at     

Interfacial reactions in In-Sn/Ni couples and phase equilibria of the In-Sn-Ni system

The In-Sn-Ni alloys of various compositions were prepared and annealed at 160°C and 240°C. No ternary compounds were found; however, most of the binary compounds had extensive ternary solubility. There was a continuous solid solution between the Ni₃Sn phase and Ni₃In phase. The Sn-In/Ni couples, made of Sn-In alloys with various compositions, were reacted at 160°C and 240°C and formed only one compound for all the Sn-In alloys/Ni couples reacted up to 8 h. At 240°C, Ni₂₈In₇₂ phase formed in the couples made with pure indium, In-10at.%Sn and In-11at.%Sn alloys, while Ni₃Sn₄ phase formed in the couples made of alloys with compositions varied from pure Sn to In-12at.%Sn. At 160°C, except in the In/Ni couple, Ni₃Sn₄ formed by interfacial reaction.     

Application of annexation principle of thermodynamic property of In-Pb-Sb and In-Bi-Pb melts

Based on the principle of annexation and phase diagrams, the structural units of In-Pb-Sb and In-Bi-Pb melts were determined, and their calculating models of mass action concentrations were formulated. Calculated results agree well with practical values, which in turn show that the models deduced can reflect the structural realities of corresponding melts and the principle of annexation is applicable not only to some binary metallic melts, but also to ternary metallic melts.     

基于IP核复用技术的SoC设计

概述了国内外IP产业的发展情况,论述了我国发展IP核复用技术SoC设计的可能性和必要性,指出我国急需发展的关键芯片及IP核种类.     

气压传动与控制在电子专用设备上的应用

气压传动与控制已成为电子专用设备研制过程中一项不可缺少的内容 ,必须进行合理的气动系统设计及其控制 ,选择相应的气动元件以满足设备的功能要求。概述了气压传动与控制在电子专用设备上的应用。