Ion implantation effect on atomic structure of deformed Si, Ir, W, Ni and Cu

It has been revealed, that in Ir subjected to severe plastic deformation, an ultrafine grained structure (UFG) is formed (the grain size of 20-30 nm). Practically no defects have been detected within the grains, while, in the case of Ar⁺ implantation, the subgrain structure with characteristic sizes of about 3-5 nm is formed; defects have been detected within subgrains.The subgrain structure was also revealed in UFG Ni and Cu after severe plastic deformation (SPD) (subgrain size of 3-15 nm), but in the latter case the observed boundary region is broader and subgrain is highly disoriented.     

核材料检测仪的研制

在原来只适于检测(射线的苯基塑料闪烁体上涂以ZnS薄层，使之对γ射线也有很高的灵敏度。根据光电转换原理，采用PC为主控，并用单片机作为数据预处理器，通过标准串口通讯，构成硬件冗余模式；另外，将传统的直通道设计成直角形，使之既能检测金属容器，又能识别强放射性物质；同时，在出口端加装了限速／位阻拦装置，从而解决了γ射线-金属双重识别，反辐射屏蔽和防高速闯关等难题，大大提高了检测系统的可靠性。PC的数据库操作和远程通信等功能使得本仪器能满足现代高端应用的要求。实测表明，本仪器灵敏度高，可靠性好。对应于3mg的U^235仪器报警响应时间小于0．6s，而拦截动作响应时间不大于2s。     

X-Ray Measurement of Residual Stress in Plastic Bonded Explosives

The X-ray diffractive technology was adopted for tentative study of plastic bonded explosive. The datum of some new diffractive peaks in standard PDF cards were added. The effects of strain to interplanar distance and crystal size of the explosive were studied. The results show that grain size of plastic bonded explosive is decreasing with the increasing of the pressure, and the residual stress of the explosive is draw stress.     

对ADSL接入方式铜缆可用线对率的分析

指出了为发展ADSL而提高市话音频铜线电缆的传输质量和维护水平的必要性,分析了铜线电缆线对有关指标参数低劣的原因和对传输ADSL的影响,并提出了一些改进的意见。     

钢筋砼框架非线性分析的简化单元模式

介绍一种用于钢筋混凝土框架二阶弹塑性分析的简化单元模式。它考虑了轴力的二阶效应、横截面的塑化和塑性区长度等非线性因素的影响。利用杆件截面的弯矩—曲率关系,可以直接由弹性杆件的转角—位移方程建立单元的非线性刚度矩阵。经与试验结果比较,说明计算结果是正确的。     

无间隙原子钢的微观结构特征和塑性应变比

采用Ｘ射线衍射的ＯＤＦ和ＬＰ分析技术，ＳＥＭ电子通道花样和蚀坑技术观测，研究了超深冲无间隙原子钢板的微观结构特征。结果表明：控制化学成分、保证基体纯净、优选工艺参数，促进强的γ－〈１１１〉∥Ｎ．Ｄ纤维织构的形成是获得优异成型性的关键。用ＣＭＴＰ方法，由ＯＤＦ织构数据从理论计算了塑性应变比（ｒ），表明ｒｍ值高达３．１８。文中讨论了再结晶织构形成机制。     

Influence of Storage Time and Temperature on Absorption of Flavor Compounds from Solutions by Plastic Packaging Materials

ABSTRACT: Linear low-density polyethylene (LLDPE), oriented polypropylene (OPP), polycarbonate (PC), polyethylene terephthalate (PET film and PET bottle), and polyethylene naphthalate (PEN) were stored in a model solution containing 10 flavor compounds at 4, 20, and 40 °C and flavor absorption by the plastic materials was followed in time. The absorption rate and/or total amount absorbed increased considerably with temperature from 4 to 40 °C. Depending on storage temperature, total flavor absorption by the polyolefins (LLDPE and OPP) was 3 to 2400 times higher than by the polyesters (PC, PET, and PEN). Therefore, in the factor of flavor absorption, polyesters are preferred over polyolefins as packaging material.     

N.m.r. study of the ferroelectric phase transition in a 7030mol% copolymer of vinylidene fluoride (VF2) and trifluoroethylene (TrFE)

Nuclear magnetic resonance (n.m.r.) studies of ¹⁹F nuclei in a $\text{70}\text{30}\text{mol}\text{\%}$ random copolymer of vinylidene fluoride and trifluoroethylene were performed at 9.14 MHz and 20.0 MHz. The free induction decays (FIDs) were analysed in terms of two T₂ components attributed to the amorphous and crystalline portions of the polymer. The changes in crystallinity as well as the effects of the ferroelectric transition were observed during cycles of heating and cooling between 20°C and 140°C. The crystalline component of the FID lengthens by a factor of 2 at 100°C on heating and decreases by this factor at 60°C on cooling, thus exhibiting the thermal hysteresis of this ferroelectric transition. The spin-lattice relaxation was also investigated. From measurements at 9.14 MHz the observed longitudinal relaxation time T₁ appears to be dominated by the dynamics of the amorphous phase and exhibits no anomaly through the phase transition. However, from measurements at 20 MHz, well defined minima of T₁ were observed, which are associated with the ferroelectric transition (especially after repeated annealing of the samples). Results are discussed in terms of the crystalline phase structure, which appears dynamically disordered above the ferroelectric phase transition. An analogy is considered with the plastic phase transitions encountered in molecular crystals.