Evaluation of influence of external magnetic disturbance on superconducting magnet taking conservation of linkage flux into account

External magnetic disturbance influences the quality of the image obtained with a magnetic resonance imaging (MRI) system because it causes magnetic resonance frequency drift. When a superconducting magnet in persistent current mode operation is exposed to external magnetic disturbance coil current varies to keep linkage flux constant. Conventional analysis is usually formulated with constant current and does not provide correct evaluation of drift of magnetic field in the magnet. This paper proposes a method of numerical analysis of magnetic field considering conservation of linkage flux in a superconducting magnet under a persistent current mode operation. This method is applied to evaluate drift of the magnetic field in a superconducting magnet for magnetic resonance imaging due to external magnetic disturbance. Analysis results show good agreement with the experimental results.     

三峡工地高压供电线路故障判断方法的探讨

高压供电设备故障特别是输电线路的高压接地故障对工地的影响是相当大的。由于接地故障为隐性故障，没有明显的物理现象，且若是长期接地可能会发展成较为严重的两相或三相短路故障，使系统解列运行直至崩溃；由于工地流动人员较多，还易造成电击事故。利用高压一相接地时在线路中产生零序电压这一特性来迅速判断和切除接地的用电设备，可以保证各项施工的顺利进行。     

Use of ultrafiltration for preparing improved tomato pulp

The characteristics of high-quality tomato pulp (commercial def.: crushed or diced tomatoes with about 30% tomato juice as packing medium) canned with tomato juice pulp enriched by ultrafiltration as packing medium were compared with those covered with conventional vacuum-concentrated juice.
Both hot- and cold-break products were prepared and those containing 20% serum-reduced packing juice proved to be the best, showing no signs of syneresis on storage and with improvements in sensory properties, colour and non-enzymatic browning; some volatile components were reduced.     

Dough mixing and breadmaking properties of quinoa-wheat flour blends

Flour blends of quinoa-wheat containing 0, 5, 10, 15, and 20% of manually dehulled quinoa meal or flour were evaluated for dough mixing and breadmaking properties and liking of the bread by a small panel. Increasing amounts of quinoa meal or flour increased farinograph absorption and dislike of bread for most of the panel. Dough development time increased with increase in meal but decreased with increase in quinoa flour. At 10% inclusion levels differences in liking from control 100% wheat flour bread were smaller for flour or water extracted meal to most of the panel, than with 10% non-extracted meal. This suggests that 10% inclusion of flour or water extracted meal may have potential for further investigation.     

Development of cable fault location method using fiber optic distributed temperature sensor

When ground-fault problems occur on a cable line, immediate fault location and restoration are required. Therefore, various new methods to locate the fault point instantaneously have been investigated to replace such conventional methods as the Murray loop method and the pulse radar method [1]. These methods require a long time to locate the fault point. One possible fault location method is to sense the temperature rise following a ground fault using a fiber optic distributed temperature sensor. Application of this method was found feasible through sensing the temperature rise at a ground-fault test using a thermocouple as a temperature sensor with test cables [4]. A power/optical composite cable was prepared experimentally and after verifying its thermal mechanical performance, the temperature rise at an incidence of a fault was determined and the anticipated performance was demonstrated in a ground-fault test. This article describes the outline of the test.     

An economic and environmental assessment of biomass utilization in lignite‐fired power plants of Greece

The environmental and socio‐economic impacts of biomass utilization by co‐firing with brown coal in an existing thermoelectric unit in Greece or through its pure combustion in a new plant were studied and evaluated in this work. The 125 MW_e lignite‐fired power plant in Ptolemais Power Station (Western Macedonia) was used as reference system. The environmental benefits of the alternative biomass exploitation options were quantified based on the life cycle assessment methodology, as established by SETAC, while the BIOSEM technique was used to carry out socio‐economic calculations. The obtained results showed clear environmental benefits of both biomass utilization alternatives in comparison with the reference system. In addition, co‐firing biomass with lignite in an existing unit outperforms the combustion of biomass exclusively in a new plant, since it exhibits a better environmental performance and it is a low risk investment with immediate benefits. A biomass combustion unit requires a considerably higher capital investment and its benefits are more evident in the long run. Copyright © 2005 John Wiley & Sons, Ltd.     

A new voltage control equipment using fuzzy inference

Power system control equipment needs higher sensitivity and operational reliability. Advanced voltage control equipment is needed for reducing the frequency of tap changes and improving the characteristics (the relationship between the actual voltage and reference voltage) of the voltage to meet today's power system requirements. However, these objectives are in a trade-off relationship. Studies of voltage control derived from a knowledge base suitable for electric power systems can satisfy these objectives using fuzzy inference. Compared with corresponding conventional equipment, the new equipment improved the deviation of 30 min average voltage of 30 percent. This paper describes the design concept of new voltage control equipment using fuzzy inference. In addition, field test results are described along with rules of fuzzy inference, membership functions, and the deviation of 30 min average voltage through detailed simulation.     

隧道工程施工中应注意的问题

通过对海南省东线高速公路大茅山隧道施工的全程监理,阐明了在施工中应重点注意的几个问题,在此基础上,总结出隧道工程质量监督中必须做到的几点,以确保隧道工程施工安全及工程质量.     

永州电力通信交换网集中操作和维护的实现

分析实现永州电力通信交换网集中操作和维护的必要性，介绍了实现程控交换机远程操作和维护的两种方式，总结在实践过程中所得到的经验和教训。