地方热电联产企业发展对策的探讨

介绍了泰州热电企业的运行情况，分析了各热电厂在技术改造、扩大热用户和强化内部考核管理方面的措施，探讨了地方热电企业应采取的对策和发展思路。     

Design and Characterization of the CLIMPAQ,Chamber for Laboratory Investigations of Materials,Pollution and Air Quality*

A test chamber has been developed in order to provide a small and simple emission testing facility capable of testing construction products in a climate where the important climatic parameters such as temperature, ventilation rate and air velocity can be varied independently around typical indoor values. The test chamber CLIMPAQ is made of panes of window glass. Other main surface materials are stainless steel and eloxated aluminium. The chamber has a volume of 50.9 litres and is designed to meet the requirements for quantifying air pollution. In this investigation human subjects acted as air pollution judges, and chemical characterization of the air pollution was carried out. Carpet, linoleum, wall paint and seal- ant were tested simultaneously in the CLIMPAQ and in four other chambers ranging from a full-scale chamber of 28 m³ to a field and laboratory emission cell of 3.5· 10^?5m³. Product ranking is the same in all chambers for the sensory measurements. Emission rates based on sensory measurements differ for all products less than 100 % except for tests in a 3-litre chamber where emission rates were higher. Chemical measurements differ up to approximately 10 times for the same product in different chambers. Deviations appear to be the result of different environmental parameters in the various chambers. Low air concentrations or high specific ventilation rates seem to increase emissions, while differences in air velocities and sink properties may also be the cause of differences in emission rates.     

Hydrogen and Calcium Ion Concentrations Affect Volume of CO2 Puffed Diced Green Bell Peppers

Diced green bell peppers were soaked in a solution of hydrochloric acid or calcium chloride, air-dried to 50% moisture, held in CO₂ at 5.8 MPa for 1, 3 or 5 min, and puffed by abruptly releasing the CO₂ pressure. Treatment with 1% CaCl₂ increased the size of puffed-dried products as compared to a control; however, HCl treatments did not. The treatment with 1 or 2% CaCl₂ reduced shrinkage as compared to the control. The 1% CaCl₂ treatment may have increased the CO₂ saturation rate.     

Series resonant ZCS‐PFM DC‐DC power converter with high‐frequency high‐voltage transformer link for high‐power magnetron drive

This paper presents a single lossless inductive snubber‐assisted ZCS‐PFM series resonant DC‐DC power converter with a high‐frequency high‐voltage transformer link for industrial‐use high‐power magnetron drive. The current flowing through the active power switches rises gradually at a turned‐on transient state with the aid of a single lossless snubber inductor, and ZCS turn‐on commutation based on overlapping current can be achieved via the wide range pulse frequency modulation control scheme. The high‐frequency high‐voltage transformer primary side resonant current always becomes continuous operation mode, by electromagnetic loose coupling design of the high‐frequency high‐voltage transformer and the magnetizing inductance of the high‐frequency high‐voltage transformer. As a result, this high‐voltage power converter circuit for the magnetron can achieve a complete zero current soft switching under the condition of broad width gate voltage signals. Furthermore, this high‐voltage DC‐DC power converter circuit can regulate the output power from zero to full over audible frequency range via the two resonant frequency circuit design. Its operating performances are evaluated and discussed on the basis of the power loss analysis simulation and the experimental results from a practical point of view. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 153(3): 79–87, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20126     

The Danish Twin Apartment Study – Part II: Mathematical modeling of the relative strength of sources of indoor air pollution

Abstract This study deals with the modeling of air pollution in apartments from laboratory measurements of source strengths, using formaldehyde and Total Volatile Organic Compounds (TVOCs) as model pollutants. The sources in two test apartments were grouped into two: building-related sources and occupant-related sources. The measured source strengths and ventilation rates were used for the prediction of concentrations expected in the apartments. These predictions were compared to measurements in the apartment over 12 months. The conclusions were that the model predictions based on emission rates measured in the laboratory can be used to predict the long-term concentration of the two model pollutants in the apartments. Considering the measured differences in ventilation between the apartments, an occupant emission rate of between 0.2 and 0.3 mg/h/kg body weight could be estimated. Based on previous suggested limits of acceptable exposures of humans to VOCs, an acceptable average emission rate of VOCs from building materials in general was estimated to be about 30 (μ/m²/h. The modeling showed that during the first 200 days, building materials dominated the emissions. After this, sources relating to the occupants dominated. On average about half of the VOC pollution originated from the building materials.     

Expert system for dispatch control in restoration of ehv power system after complete blackout

Present-day power systems operate with high reliability, and it is rare that a blackout will extend over an entire system swiftly and securely. This paper considers automatic power supply to loads after a complete blackout of a system. First, taking into account characteristics of generators, loads, and initial power sources, a method is proposed of allocating several generators to each load in parallel to the system and supplying power to the load sequentially. Second, to remove the imbalance between supply and demand of power, a method is proposed of adjusting the amount of supply and generation according to a present imbalance and the sum of past ones. Third, to automatically issue orders for start-up, parallel, follow-up, stand-by, and stoppage of generators, several rules for each power station are set and an expert system is made based on them. Finally, the expert system is applied to a model power system, and it is verified that it can restore loads without any trouble for a complete blackout which occur at any time of a day and in any restoration pattern.     

Monitoring water quality in reservoirs with IRS-1A-LISS-I

An attempt has been made to quantify the relationship between the variation in IRS-IA-LISS-I (Indian Remote Sensing Satellite-1A Linear Imaging Self-Scanning System) radiance data and field measured change in secchi disc depth. Secchi disc depth was measured for 47 predetermined sampling locations on reservoir surface water. At extinction depth (secchi depth), water samples were collected from all the sampling locations. Suspended sediments of eight locations representing various reaches of the reservoir were selected for mineralogical, particle size and optical properties analysis. The LISS-I radiance value in band 1 (0.45–0.52µm) band 2 (0-52–0.59 µm) and band 3 (0.62–0.68 µm) were used in a regression analysis. The absorption infrared band 4 (0.77–0.86 µm) was not included in the analysis. In these, the dependable variable was secchi depth (SD) and the LISS-I-radiance data was the estimator variable. Forty-seven data sets of 20 October 1988 from Tawa reservoir surface water were used to obtain an estimator equation for SD. The verification of the estimator equation was tested by applying it to a data set of 21 measurements of 28 September 1988 for this reservoir. The coefficient of correlation between observed and estimated values for the 28 September 1988 data set wasr=0.92 for SD, indicating that the equation could accurately predict the water clarity (SD) for this reservoir on new occasions from IRS-IA-LISS-I spectral data. It is shown that mineral composition and optical properties of suspended sediments influence the reflected radiance of water quality. It is concluded that IRS-IA-LISS-I data provide a useful means of mapping water quality in reservoir.     

压力容器材料质量控制的几个重要环节

针对压力容器材料方面存在的问题,从设计、采购、检验、制造等环节进行了分析,根据实际情况确定材料的质量控制要点。材料使用前要通过各种检测手段,判断材料的真实性,确保所用材料合格;并应从设计、选材、采购、计划、填报内容和选择可靠的供应方等方面加以控制,确保材料的正确使用,为压力容器产品的材料控制提供借鉴。     

浅议轨道交通直流牵引供电系统的构成及保护配置

介绍了城市轨道交通直流牵引供电系统的构成,详细叙述了直流牵引供电系统的主要电气设备及其连接方法,以及系统的运行方式.另外,还简单介绍了系统配置的直流保护以及保护原理和保护作用.