非金属电镀用导电漆的研制

介绍了导电漆、作为导电填料的片状镀银铜粉的制备工艺流程。分别研究了漆膜表面单位电阻与镀银铜粉的含量及其粒径以及钛酸酯偶联剂的含量之间的关系。结果表明,当镀银铜粉的粒径为400目、质量分数在57%~65%之间,钛酸酯偶联剂的质量分数为10%时,所得涂膜的导电性能最佳。加入含C-18的油酸可以使导电漆长期贮存而电阻值不变。经检测,所得涂膜具有良好的性能:附着力1级,硬度1 H,柔韧性1 mm,冲击强度50 kg/cm2,膜厚10~15μm,漆膜表面每厘米电阻0.15Ω,每分米电阻0.47Ω。指出了导电漆应用过程中的注意事项。     

α-Tocopherol alteration of soybean antiherbivory toTrichoplusia ni larvae

The antioxidant vitamin E, -tocopherol, was tested as a candidate elicitor of alterable antiherbivory in soybean plants against cabbage looper larvae. Although a nonspecific antioxidant, vitamin E proved elicitory to the involved sulfhydryl-dependent receptor-energy transducer protein in soybean plasma membrane. Effects of -tocopherol were dependent on dosage, time, and space in the plant. The observed elicited effects were all decreases in herbivory. The best negative phytochemical correlate of looper feeding was the percentage of increased total HPLC peak area of extractables from elicited as compared to nonelicited leaves. Some specific compounds, e.g., glyceollins, were quantitatively major components of the total profile of secondary metabolites.     

Rheology of cementitious paste with silica fume or limestone

The rheological behaviour of cementitious pastes where cement has increasingly been replaced by densified silica fume (SF), untreated SF or limestone has been studied. The effect of SF on the flow resistance, taken as the area under the flow curve, was found to depend on the dispersing ability of the plasticizer as illustrated by pastes with naphtalene sulphonate-formaldehyde condensate (SNF) and polyether grafted polyacrylate (PA).The gel strengths increased with increasing SF replacement of cement independently of plasticizer type. The cementitious gel strength was, however, depending on the type of SF since pastes with densified SF developed lower gel strengths than pastes with untreated SF. This phenomenon was attributed to agglomerates in the densified SF which remained unbroken by the mixing and measurement sequence.Both flow resistance and gel strength decreased with increasing limestone replacement. Thus, silica fume may have an advantage over limestone filler as stabilizing agent for self-compacting concrete preventing segregation upon standing and reduced form pressure due to a more rapid gel formation.     

Effect of puerarin on the P13K pathway for glucose transportation and insulin signal transduction in adipocytes

To explore the effect of puerarin on insulin receptor (IR), insulin receptor substrate-1 (IRS-1) and protein expression of protein kinase B(PKB) in the P13K pathway of the glucose consumption, transportation and insulin signal transduction in 3T3-L1 adipocytes with insulin resistance. The insulin resistance 3T3-L1 adipocytes model was established by free fatty acid induction. The model cells were managed with puerarin in different concentrations. Glucose consumption was detected with glucose oxidase method, glucose transportation rate was determined by 2-deoxy-3H glucose ingesting method, and the IR, IRS-1 and PKB expression were determined by Western blot. Glucose consumption and transportation were significantly decreased in the model adipocytes, but increased after treated with puerarin (P<0.01). Moreover, the level of tyrosine phosphorylation of IR subunit β was higher in the puerarin treated groups, and that of IRS-1 was higher in the group treated with low dose puerarin than that in the model group. The 3T3-L1 adipocytes of insulin resistance model could be induced by free fatty acid successfully, puerarin could promote the glucose utilization in them to alleviate the insulin resistance, which may be related with the action in advancing the tyrosine phosphorylation of IR and IRS-1.     

Expression of green fluoscrescent protein gene in Sclerotinia sclerotiorum

Protoplasts of the pathogenic plant fungus,Sclerotinia sclerotiorum,were transformed using the pPGF plasmid,which contains green fluorescent protein gene,under the control of Aspergillus nidulans regulatory sequences. The pPGF plasmid was introduced by PEG/CaCl2 treatment. Positive transformants were harvested with hygromycin B (HYG) resistance as selective marker,and then were observed with green fluorescence phenomena in response to blue light,which suggested that GFP gene was cloned into genome DNA of S. sclerotiorum. The transformants were verified mitotically stable by Southern blotting analysis and passage culturing. This study is developed as an initial step for further research into infection mechanisms of S. sclerotiorum to plants and interactions with bio-control fungus.     

定向MWNTs/PMMA的原位聚合制备及耐磨损性

采用原位聚合方法制备了定向碳纳米管/聚甲基丙烯酸甲酯复合材料,并且研究了该复合物的耐磨损性.对定向碳纳米管及其复合物进行了傅立叶红外吸收光谱分析、扫描电镜及光学显微镜观察.采用砝码质量法评价了复合物的耐磨损性.分析结果表明,混酸处理后定向碳纳米管附带了-OH、-COOH基等极性基团.混酸处理后定向碳纳米管束状结构被破坏,定向碳纳米管可以单管形态分散于基体中,碳纳米管表面包覆着PMMA.砝码质量法耐磨损性测试结果表明,定向碳纳米管的加入可提高PMMA复合物的耐磨损性和耐划痕性,当定向碳纳米管用量为0.7%时,复合物的耐磨损性能提升了54%.     

世界溶液丁苯橡胶的主要技术进展

评述了溶液丁苯橡胶的技术现状和主要技术进展。介绍了新型锡锂引发剂和用其制备的溶液丁苯橡胶的性能特点，特别是其突出的滚动阻力特性和在不损失湿牵引性下的优异耐磨性。分析了世界，特别是美国、欧洲和日本的溶液丁苯橡胶的需求现状及发展趋势。     

On the oxidation kinetics and mechanisms of various SiC-coated carbon-carbon composites

SiC coatings on the surface of C-C were produced by either silicone resin impregnation/ pyrolysis or reaction sintering. Cycles of resin impregnation/pyrolysis produced an SiC coating, on the walls of fine open pores, which was effective in reducing the oxidation rate of C-C and in shifting the transition temperature to a higher value. Unless it is pre-coated with a pyrocarbon layer before sintering, plain reaction sintered SiC has oxidation behaviors similar to those of the above-mentioned SiC. The dense pyrocarbon film deposition on the surface of C-C could form a better SiC film than others. The carbon film homogenized the surface of C-C and a dense SiC film was established. The oxidation of the coated C-C can be modelled by a set of “oxidation resistors” in series and/or in parallel, with each resistor corresponding to an oxidation element. The controlling mechanism can be resolved from the activation energy. A combined resistant layer, consisting of resin impregnation, pyrocarbon film and reaction sintering SiC, showed the best oxidation resistance of any single-layer coated C-C composite.     

用双层辉光等离子法在钛表面制备的Ti-Pd合金层性能研究

采用双层辉光等离子冶金技术在纯钛表面制备了Ti—Pd合金层。其深度大约为90μm，Pd含量呈梯度变化，并出现了TiPd3，TiPd2，Ti2Pd3，Ti3Pd5，TiPd，Ti4Pd等6种化合物相和Pd相。合金层在100℃的NaCl饱和溶液＋HCl溶液以及40℃的8．6％H2SO4溶液中的耐缝隙腐蚀性能优于Ti0．2Pd合金；在室温80％H2SO4的溶液中，腐蚀速率仅为0．682mm／a，是Ti0．2Pd合金的18．2％：在室温30％HCl的溶液中，表面Ti—Pd的腐蚀速率仅为0．004mm／a，是Ti0．2Pd合金的12．5％。     

高耐蚀性热镀锌板的钝化处理工艺探讨

介绍了热镀锌板钝化膜的形成机理 ;针对攀钢热镀锌板出现白锈、黑斑等问题 ,分析了钝化液pH值、添加剂及操作条件对钝化膜质量的影响 ,同时提出了改进热镀锌板耐蚀性能的措施