Effect of surfactants and liquid hydrocarbons on gas hydrate formation rate and storage capacity

Hydrate formation rate plays an important role in making hydrates for the storage and transport of natural gas. Micellar surfactant solutions were found to increase gas hydrate formation rate and storage capacity. With the presence of surfactant, hydrate could form quickly in a quiescent system and the energy costs of hydrate formation reduced. Surfactants (an anionic surfactant, a non‐ionic surfactant and their mixtures) and liquid hydrocarbons (cyclopentane and methylcyclohexane) were used to improve hydrate formation. The experiments of hydrate formation were carried out in the pressure range 3.69–6.82 MPa and the temperature range 274.05–277.55 K. The experimental pressures were kept constant during hydrate formation in each experimental run. The effect of anionic surfactant (sodium dodecyl sulphate (SDS)) on natural gas storage in hydrates is more pronounced compared to a non‐ionic surfactant (dodecyl polysaccharide glycoside (DPG)). The induction time of hydrate formation was reduced with the presence of cyclopentane (CP). Cyclopentane and methylcyclohexane (MCH) could increase hydrate formation rate, but reduced hydrate storage capacity The higher methylcyclohexane concentration, the lower the hydrate storage capacity. Copyright © 2003 John Wiley & Sons, Ltd.     

镍氢电池负极用低成本储氢合金的研究

研究了ABS型储氢合金在低Co含量条件下，随B组元替代元素Co，Al，Si等含量的变化对合金电化学性能的影响规律，同时研究了A组元中不同La／Ce比对合金电化学性能的影响情况。结果表明，随合金中Co含量的降低，合金的活化性能和放电容量得以改善，但合金的循环寿命下降也比较明显；在试验范围内，随Al元素的加入，合金的循环寿命得以改善，但材料的放电容量和活化性能均有所下降；随合金La／Ce比的降低，合金的放电容量略有下降，但其循环寿命和放电电压平台有较大提高。     

Fabrication of a poly-Si thin-film transistor with storage capacitor

The fabrication process of a low-temperature poly-Si thin-film transistor (TFT) with a storage capacitor was studied. The atmospheric-pressure chemical-vapour deposited SiO₂ protected the buried indium tin oxide (ITO) from reduction by a pure H₂ plasma treatment that was essential for the effective improvement of the poly-Si TFT characteristics. Thus, a storage capacitor with an ITO (picture electrode)-SiO₂-ITO (buried common electrode) structure was successfully fabricated. The poly-Si TFT with a channel width/length W/L ratio of 5 drove a 3 pF storage capacitor in 2 μs, and it showed superior driverability for LCD use. The TFT also had good hold characteristics under illumination for the realization of grey-scale representation.     

Computer analysis,design and simulation of horizontal ground heat exchangers

This paper presents a new computerized procedure for dealing with the design of horizontal ground heat exchangers (HGHE). The computer program is based on the transient model of coupled nonlinear partial differential equations governing heat and mass flow in soils. The model is two-dimensional and delineates the operation of ground heat storage with the HGHE and such phenomena as freezing/thawing and drying/rewetting of soil moisture. Comprehensive climatological data, such as ambient temperature, solar radiation, wind velocity, rainfall, snowfall, snow characterstics, and water vapour pressure is used to simulate conditions at the ground surface over any required length of time. The package can be applied to any geographical location by changing climatic and soil data input. The designer has the possibility of selecting any of 12 types of soils from sand to clay, 12 commercial heat pumps, nine different configurations of the HGHE, 16 plastic pipes for ground coils, and 13 ground coil fluids. The program, however, does not calculate the length of the HGHE but it evaluates the thermodynamic performance of a ground heat pump system and provides comprehensive data on thermal and hydraulic conditions in ground heat storage. The length of the ground heat exchanger is obtained from a line source theory model or from site dimensions and pipe spacing. Computed results for ground heat exchanger operation correlate fairly well with experimental data. Simulation of temperature and moisture content in the ground for natural conditions (no heat extraction/deposition) showed a fair agreement with field data. The entire computer program is user-friendly, interactive, menu-driven, and written in FORTRAN 77.     

A portable cryo-storage system for low-temperature scanning electron microscopy,suitable for international transport of cryo-specimens

A cryo-specimen storage system for low-temperature scanning electron microscopy (LTSEM) specimens is described, which: liberates multi-specimen experiments from sampling restrictions imposed by the rate at which LTSEM specimens can be examined in the SEM; provides security against experiment loss resulting from breakdown of the SEM or cryo-system; enables collection of specimens in the field or in laboratories remote from the SEM laboratory; and facilitates international air transport of LTSEM specimens. The components of the system, which has a capacity of 98 stub-mounted specimens, are readily made in a laboratory workshop. The details of the design may be altered to suit particular specimen types or experimental approaches.     

RAID的存储信道分析

本文从冗余磁盘阵列的信道模型出发，研究各部分组成的理论与技术。文中在给出系统的模型描述之后，着重分析了冗余信息元生与检纠错、数据分割与同步。还研究了系统中的负荷平衡问题，指出了磁盘优化调度的方向。     

变井储系数的确定方法及其在反褶积分析中的应用

中针对变井储试井分析问题，给出了确定变井储系数及计算续流量的方法，并用反褶积分析积分析方法解释了未出现径向流的早期测压数据，给出了解决早期试井资料分析问题的有效方法。     

浅谈抽水蓄能电站的特点及其优越性

本文介绍了国外抽水蓄能电站的发展过程与现状，修建抽水蓄能电站的八大优点。为了改善我省电力系统的运行条件，提出了在我省修建抽水蓄能电站的四点建议。     

广播电视中心发展新趋势——多媒体化初探

本文讨论了多媒体技术所需的软硬件基础和网络传输技术，及其在数字化广播电视中心节目制作中的应用，展望了无磁带广播电视中心有美好前景，在此基础上提出了完整的广播电视中心多媒体系统结构图。