焊前处理方式对LF6铝合金扩散焊的影响

利用Ｇｌｅｅｂｌｅ－１５００热／力模拟试验机，研究了ＬＦ６铝合金的扩散焊工艺，通过对焊接温度、压力、时间的调整和选用不同的料前处理方法，确定了最佳的扩散规范，研究结果表明：在一定的温度和时间范围内，ＬＦ６５铝合金扩散焊接头的剪切哟度随焊接温度和时间的增加而提高；化学浸蚀法比机械打磨法能更有效的去除铝合金表面的氧化膜；在现有试验条件下，得到ＬＦ６铝合金扩散焊的最佳规范参数，搭接试扩散焊接头的剪切强度     

折反光学系统最佳红外像面位置的研究

较深入地研究了折反光学系统的红外像面,为确定实际的红外像面提出了一个新方法—计算从可见光边缘无色的弥散圆到红外最佳像面的距离。实践证明,这是确定这类光学系统最佳像面的一个方便、可靠的方法。     

动态毛吸法测定纤维表面能

本文用浸润测定仪对玻璃纤维和Kevlar-49芳纶纤维进行了表面能测定,讨论了纤维束柱末端沾湿量的影响,提出了浸润仪测试数据的正确处理方法,求得了Kevlar-49纤维的表面能并对其色散分量和非色散分量进行了解析.     

高效辐射换热器的研制

本文所介绍的高效辐射换热器是指在其环缝通道中安装有网状二次传热面的辐射换热器，用对比实验方法研究了它们在空气预热温度、给热系数和阻力系数上的差别．实验表明：高效辐射换热器可强化空气侧的传热，其综合传热系数达５９Ｗ／（ｍ２·℃），而阻力系数可控制在３０００Ｐａ以内．     

一种新的纸基微流开关及其活跃方法

提出了一种新的、基于声表面波的纸基微流开关。通过软光刻技术制作内含两个微孔的聚二甲基硅氧烷(PDMS)微架,其上固定经折叠、长度可变的纸通道。PDMS微架贴附于压电基片之上,并在待连接的两微通道之下方,折叠纸通道最低端离压电基片间距为2 mm。压电基片上采用微电子工艺光刻一对叉指换能器和反射栅。当足够强度的电信号加到叉指换能器对时,激发两相向声表面波,使得压电基片上微流体输运到折叠纸通道,改变其长度,连接其上待连通的两纸基微通道,完成开关功能。对可编程微流器件提供了一种新的编程和开关控制方法。     

抛光液温控装置结构设计及温度场分析

为精确控制超光滑表面抛光过程中抛光液的温度,根据温控基本原理设计温控装置结构.将用UG建立的温控装置模型导入GAMBIT中进行温度场分析.针对装置内部温度分布不均匀问题,对其结构进行优化：在装置内加入导热隔板将其分为工作区和调温区,制冷器被置于调温区内;将温控装置的外形结构加入过渡圆角.结果表明：优化后的温控装置形成内外环流,工作区温度波动范围为±0.01℃,温度分布均匀对称,满足高精度温控的恒温和匀温要求.     

神东网络现状及解决思路

神东煤炭公司信息网络发展至今已经形成规模,在整个神华集团广域网中神东也是重要节点之一,肩负着周边各兄弟公司的广域网接入以及旗下众多煤矿和分公司业务数据的传输。由于神东网络属于自然发展型网络,在网络规模建设初期,问题容易规避,在形成规模以后,各种潜在的问题都可能导致网络故障从而影响整体网络的正常运行。分别从神东煤炭集团公司局域网、宽带网、井下工业以太网3个方面分别进行详细阐述。     

Adaptive fuzzy dynamic surface control for a class of perturbed nonlinear time-varying delay systems with unknown dead-zone

In this paper,adaptive dynamic surface control(DSC) is developed for a class of nonlinear systems with unknown discrete and distributed time-varying delays and unknown dead-zone.Fuzzy logic systems are used to approximate the unknown nonlinear functions.Then,by combining the backstepping technique and the appropriate Lyapunov-Krasovskii functionals with the dynamic surface control approach,the adaptive fuzzy tracking controller is designed.Our development is able to eliminate the problem of "explosion of complexity" inherent in the existing backstepping-based methods.The main advantages of our approach include:1) for the n-th-order nonlinear systems,only one parameter needs to be adjusted online in the controller design procedure,which reduces the computation burden greatly.Moreover,the input of the dead-zone with only one adjusted parameter is much simpler than the ones in the existing results;2) the proposed control scheme does not need to know the time delays and their upper bounds.It is proven that the proposed design method is able to guarantee that all the signals in the closed-loop system are bounded and the tracking error is smaller than a prescribed error bound,Finally,simulation results demonstrate the effectiveness of the proposed approach.     

Finite-size effects in surface tension: Thermodynamics and the Gaussian interface model

It has been suggested by Kayser that finite-size effects associated with capillary waves might play a significant role in some surface tension measurements; for capillary rise between plates a distance D apart, an effect varying as 1/D and apparently observable in measurements, was proposed. In reconsidering this problem, one must analyze the thermodynamics of finite-size corrections to surface tension. In particular, one sees that capillary rise between plates does not measure the interfacial free energy density but, rather, a derivative of the interfacial free energy with respect to a system dimension. The quantity needed to draw definite conclusions, the finite-size residual free energy, can be calculated within the harmonic or Gaussian capillary wave model in d spatial dimensions with the aid of Poisson summation techniques and should yield the correct leading asymptotic behavior. For d=3 and experimentally relevant parameter values, the results are independent of the short-wavelength cutoff needed in the model and can be checked against the theory of conformai covariance at two-dimensional critical points. It is found that the finite-size effects in capillary-rise measurements of surface tension vary as 1/D ² (with a universal coefficient) but are too small to be seen in current experiments.Invited paper presented at the Tenth Symposium on Thermophysical Properties, June 20–23, 1988, Gaithersburg, Maryland, U.S.A.