离子静电水处理技术在循环冷却水中的应用

简要介绍了离子静电水处理技术杀菌、灭藻、防垢阻垢的机理，及在循环冷却水系统中的应用情况。     

用于重离子核反应实验测量的纵向电场气体电离室

本文报道了一种新型的大动态范围，多叠层探测器系统组件之一的纵向电场气体电离室的构造，性能和在中能得离子核反应实验中的应用。     

微波电子回旋共振等离子体技术及其应用

微波电子回旋共振等离子体是淀积薄膜、微细加工和材料表面改性的一种重要手段。由于这种等离子体电离水平高,化学活性好,可以用来实现基片上薄膜的室温化学气相淀积和反应离子刻蚀,因此对于微电子学、光电子学和薄膜传感器件的发展,这种等离子体会具有重要的意义。此外,采用微波电子回旋共振等离子体原理,没有灯丝的离子源可以提高离子源的使用寿命,可以增加离子束的束流密度。可以确信,微波电子回旋共振等离子体的发展,将把离子源技术提高到一个新的水平。显然,这必将对材料表面改性工艺,包括离子注入掺杂等工艺的发展发挥作用。自从1985年以来,为了得到大容积等离子体而发展了微波电子回旋共振多磁极等离子体,这些技术在薄膜技术、微细加工以及材料表面改性中的应用前景是乐观的。我们将在本文中,介绍微波电子回旋共振等离子体的原理及其应用。     

Damage and strain in pseudomorphic vs relaxed GexSi1−x layers on Si(100) generated by Si ion irradiation

We compare both the strain and damage that 100 keV Si irradiation at room temperature introduces in pseudomorphic and relaxed Ge_xSi_1−x films grown on Si(100) substrates. The ion range is such that the Si/Ge_xSi_1−x interface is not significantly damaged. The amount of damage produced in pseudomorphic and relaxed Ge_xSi_1−x layers of similar x for irradiation doses up to 2.5 × 10¹⁴ Si/cm² is the same, which proves that a pre-existing uniform strain does not noticeably affect the irradiation-induced damage. However, the irradiation-induced strain does depend on the pre-existing strain of the samples. Possible interpretations are discussed. On leave from Inst. voor Kern en Stralingsfysika, Catholic University of Leuven, Belgium.     

硼酸使掺铁铝酸锂发光增强的现象

在硼酸存在下合成了掺铁铝酸锂荧光体,研究了在不同温度下硼酸加入量对荧光体发光强度的影响,并通过X射线粉末衍射和粒度分析,初步探讨了发光增加的原因。     

Co^3＋—modified Surface of LiMn2O4 Spinel for its Improvementof Electrochemical Properties

Cobalt was used to modify the surface of spinel LiMn2O4 by a solution technique to produce Co^3 -modified surface material (COMSM). Cobalt was only doped into the surface of LiMn2O4 spinel. XPS(X-ray photoelectron spectroscopy) analysis confirms the valence state of Co^3 . COMSM has stable spinel structure and can prevent active materials from the corrosion of electrolyte. The ICP(inductively coupled plasma) determination of the spinel dissolution in electrolyte showed the content of Mn dissolved from COMSM was smaller than that from the pure spinel. AC impedance patterns show that the charge-transfer resistance (Rct) for COMSM is smaller than that for pure spinel. The particles of COMSM are bigger in size than those of pure spinel according to the micrographs of SEM(scanning electron microscopy). The determinations of the electrochemical characterization show that COMSM has both good cycling performance and high initial capacity of 124.1 mA/h at an average capacity loss of 0.19 mAh/g per cycle.     

Optical data storage by novel photoelectrochromic polymer

A novel elastic polymer containing 4,4′-bipyridinium salts with tetrakis[3,5-bis(trifluoromethyl)phenyl]borate as part of the main chain was synthesized. The cast film showed persistent and reversible colour changes due to photoinduced electron transfer upon excitation of an ion-pair charge-transfer band (_ex >365 nm) in vacuo. The lifetime of the coloured state markedly depended on temperature. The optically written data were stored without decay below 0°C and were erased thermally at elevated temperatures. The colour changes were reversibly repeatable for many times.     

精对苯二甲酸反应器桨叶断裂分析与修复

为了保证进口精对苯二甲酸装置氧化反应器中钛制搅拌器的正常工作，对钛制搅拌器桨叶在运行中断裂脱落的原因进行了分析，并叙述了桨叶修理的方法和要求。经修理后的桨叶投入生产使用，达到了预期的目标。     

Kinetics study of Ti[O(CH2)4OCHCH2]4 initiated ring‐opening polymerization of ε‐caprolactone by differential scanning calorimetry

Chemical shrinkage was used for the in situ measurement of the progressing chemical stabilization reactions and the influence of ozone during the stabilization of polyacrylonitrile. A method for evaluating the activation energy through the sensitivity temperature is presented. The calculated results show that the activation energies were 161.57 kJ/mol in air and 181.23 kJ/mol in ozone-enriched air. Therefore, the chemical reactions were postponed during stabilization in ozone-enriched air. Ozone seemed to act in three ways: first, ozone promoted the formation of the serious skin–core structure. Second, ozone accelerated the chemical reactions and shortened the stabilization time at lower heating rates. Third, ozone postponed the chemical reactions. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

Preparation and adsorption behavior of a cellulose‐based,mixed‐mode adsorbent with a benzylamine ligand for expanded bed applications

A novel mixed‐mode expanded bed adsorbent with anion‐exchange properties was explored with benzylamine as the functional ligand. The cellulose composite matrix, densified with stainless steel powder, was prepared with the method of water‐in‐oil suspension thermal regeneration. High activation levels of the cellulose matrix were obtained with allyl bromide because of the relative inertness of the allyl group under the conditions of the activation reaction. After the formation of the bromohydrin with N‐bromosuccinimide and coupling with benzylamine, the activated matrix was derived to function as a mixed‐mode adsorbent containing both hydrophobic and ionic groups. The protein adsorption capacity was investigated with bovine serum albumin as a model protein. The results indicated that the prepared adsorbent could bind bovine serum albumin with a high adsorption capacity, and it showed salt tolerance. Effective desorption was achieved by a pH adjustment across the isoelectric point of the protein. The interactions between the cell and adsorbent were studied, and the bioadhesion was shielded by the adjustment of the salt concentration above 0.1M. Stable fluidization in the expanded bed was obtained even in a 2% (dry weight) yeast suspension. The direct capture of target proteins from a biomass‐containing feedstock without extra dilution steps could be expected with the mixed‐mode adsorbent prepared in this work, and this would be especially appropriate for expanded bed adsorption applications. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008