全文获取类型
收费全文 | 27841篇 |
免费 | 3606篇 |
国内免费 | 1706篇 |
专业分类
电工技术 | 7908篇 |
综合类 | 3239篇 |
化学工业 | 817篇 |
金属工艺 | 622篇 |
机械仪表 | 2147篇 |
建筑科学 | 6105篇 |
矿业工程 | 942篇 |
能源动力 | 1472篇 |
轻工业 | 288篇 |
水利工程 | 1171篇 |
石油天然气 | 603篇 |
武器工业 | 250篇 |
无线电 | 1237篇 |
一般工业技术 | 2197篇 |
冶金工业 | 756篇 |
原子能技术 | 131篇 |
自动化技术 | 3268篇 |
出版年
2024年 | 174篇 |
2023年 | 418篇 |
2022年 | 797篇 |
2021年 | 878篇 |
2020年 | 1000篇 |
2019年 | 806篇 |
2018年 | 809篇 |
2017年 | 1029篇 |
2016年 | 1068篇 |
2015年 | 1220篇 |
2014年 | 1937篇 |
2013年 | 1564篇 |
2012年 | 2150篇 |
2011年 | 2336篇 |
2010年 | 1738篇 |
2009年 | 1809篇 |
2008年 | 1726篇 |
2007年 | 1998篇 |
2006年 | 1776篇 |
2005年 | 1462篇 |
2004年 | 1162篇 |
2003年 | 1016篇 |
2002年 | 801篇 |
2001年 | 685篇 |
2000年 | 552篇 |
1999年 | 492篇 |
1998年 | 288篇 |
1997年 | 289篇 |
1996年 | 259篇 |
1995年 | 196篇 |
1994年 | 171篇 |
1993年 | 103篇 |
1992年 | 73篇 |
1991年 | 57篇 |
1990年 | 66篇 |
1989年 | 61篇 |
1988年 | 64篇 |
1987年 | 28篇 |
1986年 | 16篇 |
1985年 | 14篇 |
1984年 | 14篇 |
1983年 | 13篇 |
1982年 | 14篇 |
1981年 | 6篇 |
1980年 | 6篇 |
1979年 | 4篇 |
1961年 | 1篇 |
1957年 | 1篇 |
1955年 | 1篇 |
1951年 | 1篇 |
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
11.
12.
Yasuhiro Kobayashi Toshiyuki Sawa Toshiyuki Furukawa Shigeru Kawamoto 《Electrical Engineering in Japan》2002,138(2):49-58
This paper describes a load dispatch method which minimizes power cost—[fuel cost]/[electric output]—for a power system with thermal plants and energy storage facilities. The proposed method employs fractional programming to convert a minimization problem with fractional objective function to a series of quadratic minimization problems, and semidefinite programming to solve converted problems. The method provides the optimum time‐dependent power output/input and storage level of energy storage facilities as well as time‐dependent power output of thermal plants. The method has been applied to a power system with five thermal plants, two energy storage facilities of various performances, and five load demands. The optimum load scheme of four time mesh points is obtained for the thermal plants and energy storage facilities. The fractional programming successfully converges the optimal scheme through a few iterations. The semidefinite programming deals with a variable matrix of 164 dimensions, and 185 inequality constraints. © 2001 Scripta Technica, Electr Eng Jpn, 138(2): 49–58, 2002 相似文献
13.
This paper presents observations regarding the cracking behavior of tensile-loaded structural adhesive joints. Experiments showed that fracture occurred by the development and propagation of a damage zone, rather than a single, sharp crack, and that the presence of the adhesive spew fillet did not affect the fracture load of the adhesive joints studied. For joints bonded with the mineral-filled epoxy Cybond 4523GB (American Cyanamid), there was approximately 5 mm of subcritical crack propagation prior to final fracture. Fracture-load predictions based on the initial uncracked geometry made in previous papers were unaffected by this small change in geometry. For joints bonded with the rubber-toughened epoxy Permabond ESP 310, approximately 50 mm of subcritical crack propagation was observed. It was again found that predictions made in previous papers on the basis of the initial geometry gave a good estimate of the final fracture load even though this subcritical crack propagation significantly altered the geometry, and thus the applied energy release rates. The effect of shear deformations of the adherends was also investigated, and it was found that shear deformations could be neglected in engineering calculations for joints subject to remote tensile loading. 相似文献
14.
在分析转向柱管花键部位应力集中情况的基础上,通过对某厂生产的转向柱管扭转破坏的试验研究,得到如下结论:①转向柱管的承载能力与其外花键齿与方向盘中心内花键齿之间的非接触区长度有关,以花键端部过渡圆弧的直径大小为宜;②安装方向盘总成时所施加在安装螺母上的拧紧力矩在70N.m左右时,转向柱管的承载能力最大。 相似文献
15.
16.
17.
对武钢引进的两台3×104m3/h空分设备,为改变其自动变负荷生产调节范围小、时间长的问题,采用了人工手动变负荷的操作方法。实践表明:扩大了增减产范围,缩短了调节时间,有十分明显的综合经济效益,可供大型空分变负荷生产借鉴参考。 相似文献
18.
采用通用蒙特卡罗粒子输运程序MCNP/38计算低环径比Tokamak(紧凑环或球形环)聚变堆第一壁及中心导体上的中子壁负荷分布和核热沉积分布,并与常规Tokamak堆第一壁上中子壁负荷分布和核热沉积分布进行比较、分析。结果表明,在中子壁负荷归一化为1MW/m2时,与常规Tokamak相比,在低环径比Tokamak堆第一壁及中心柱表面上中子壁负荷分布峰值并不比常规Tokamak堆第一壁上的峰值高,而且低于低环径比Tokamak堆整个第一壁上的平均值,而中心柱上的核热沉积峰值稍高于常规Tokamak堆第一壁上的核热沉积峰值,但对较高中子壁负荷情况,中心导体柱上的核热沉积和辐照损伤仍可能是比较严重和值得特别研究的问题。 相似文献
19.
Motonobu Yoshikawa Hiroshi Nakajima Takeshi Inada Yasushi Harada Masahiko Amano Yuji Nakata 《Electrical Engineering in Japan》1995,115(7):29-39
A new practical method is proposed which gives a quasi-optimal solution of the dynamic load-dispatching problem formulated by a multiconstraint multiobjective optimization problem. Here, the multiple constraints are rate reserve constraints and power flow ones, and the multiple objectives are fuel cost and CO2 emission. The proposed method is an integration of the following three techniques: (1) “Group Dispatch Scheme,” which is developed by the authors, is used to satisfy a violated constraint easily. This scheme consists of three steps. The first step is to classify all generators into two groups. One is the group which should be more loaded to satisfy the violated constraint, and the other is the should-be less loaded group. The second step is to add some load to the former group, and to subtract the same load from the latter. The third step is to dispatch each group load to each groups generators, respectively; (2) the dynamic load-dispatching algorithm is used which provides, in practical time, quasi-optimal generation trajectories; (3) the conventional weighting parametric method is used to obtain a Pareto optimal solution of multiobjective problems. The effectiveness of the method is clarified by a computer simulation on the actual power system of Kansai Electric Power Company. 相似文献
20.
太钢3#高炉大修改造是集团公司重点外部工程项目之一,工程量大,工期紧,施工场地狭小,而质量要求较高。如何采取科学、经济的设备吊装方案,对整个项目经济指标的实现,意义重大。文章详细介绍了太钢3#高炉重力除尘器大件整体吊装方案。通过实际采用,取得良好的经济效果。 相似文献