An investigation of the relation between the temperature dependences of the initial unbalance and the output signal of resistance strain sensor bridge circuits

The relation between the initial unbalance and the output signal of bridge circuits when acted upon simultaneously by the physical factor being measured and the temperature of the surroundings when the bridge is supplied from a voltage or current source is investigated. Analytic relations are obtained which explain the temperature dependence of the useful output voltage under external physical action. __________ Translated from Izmeritel’naya Tekhnika, No. 1, pp. 48–49, 2007.     

曼型气柜支柱的安装方法

通过对曼型气柜关键部位之一的基柱的安装和找正过程的分析，表明基柱安装前对基础进行预处理、安装时测量跟踪找正、安装后定位加固，是保证基柱安装精度的三个重要步骤。     

光通信用垂直腔面发射激光器的进展

垂直腔面发射激光器(VCSEL)以其优异的性能有望成为信息时代的新光源.文章介绍了用于光通信的VCSEL的开发现状.     

近10年中国润滑脂产量与品种构成的发展

基于对中国27个润滑脂生产厂的调查统计结果，综述了1992～2001年10年间中国润滑脂产量、生产规模、品种结构及包装形式的发展变化情况，展望了今后的发展趋势。     

Analysis of exclusively kinetic two-link underactuated mechanical systems

Analysis of exclusively kinetic two-link underactuated mechanical systems is undertaken in this paper. It is first shown that such systems are not full-state feedback linearizable around any equilibrium point. Also, the equilibrium points for which the system is small-time locally controllable (STLC) is at most a one-dimensional submanifold. A concept less restrictive than STLC, termed the small-time local output controllability (STLOC) is introduced, the satisfaction of which guarantees that a chosen configuration output can be controlled at its desired value. It is shown that the class of systems considered is STLOC, if the inertial coupling between the input and output is nonzero. Also, in such a case, the system is nonminimum phase. An example section illustrates all the results presented.     

RLL码的计算机辅助设计

本文着重讨论计算机辅助设计RLL码的具体实现问题.该过程首先根据RLL码两个参数d,k确定一个编码率p/q,然后构造出RLL码的高阶状态转换-输出符号矩阵并求相应的近似特征向量.最后通过状态分裂和状态归并过程,即可得到一个满足d,k约束的编码输出表.其中状态转换-输出符号矩阵为实现计算机辅助设计RLL码提供了有效的数据结构,而且要优化RLL码编码器,就必须有选择地进行状态分裂.     

Parallel feedforward class-AB control circuits for low-voltage bipolar rail-to-rail output stages of operational amplifiers

A new family of class-AB control circuits for bipolar rail-to-rail output stages of operational amplifiers is presented. Step by step, we report the development of five simple class-AB control circuits showing the advantages of using parallel feedforward. The circuits have been designed in such a way that temperature, supply voltage and process parameters have little influence. To test the output stages, one of them has been implemented in a very simple two-stage operational amplifier on a semi-custom chip. Measurements show a bandwidth of 2.5 MHz, a gain of 40 dB, a quiescent current of 23µA and a maximum output current of 250µA. Simulation results of three other simple operational amplifiers with the new class-AB control circuits are shown, which have a higher gain and maximum output current.     

我国力车胎行业现状与展望

介绍了2002年我国力车胎的行业现状。近年的发展及展望。并着重描述了力车胎专用设备的新发展。     

定电流对LED的重要性

高功率超高亮度LED已经开始大量应用.要实际体现LED(尤其是高功率超高亮度LED)的优点,采用定电流驱动方式必要条件之一.     

垂直腔激光器中弛豫振荡频率的优化控制

从垂直腔面发射的半导体激光器（VCSELs）的结构出发，利用增益与载流子密度的广义对数关系，借助小信号分析法，推出了直接调制情形下驰豫振荡频率的严格解析关系。分析指出，量子阱器件的光子寿命并非越短越好，欲提高VCSELs的驰豫振荡频率，除了增加注入电流，提高微分增益等基本途径外，控制器件的结构参数可使驰豫振荡频率达到极大值。同时，自发辐射因子的可控性，以及降低稳态载流子密度，也都是提高VCSELs驰豫振荡频率和拓宽调制带宽的有效措施。