降低电解生产槽立柱与水平母线间压接压降方法探讨

通过对电解生产槽立柱与水平母线间压接压降的论述和分析试验，寻求一种降低该压接压降的方法，以达到降低电耗，降低成本，提高电解生产经济效益的目的。     

A new voltage control equipment using fuzzy inference

Power system control equipment needs higher sensitivity and operational reliability. Advanced voltage control equipment is needed for reducing the frequency of tap changes and improving the characteristics (the relationship between the actual voltage and reference voltage) of the voltage to meet today's power system requirements. However, these objectives are in a trade-off relationship. Studies of voltage control derived from a knowledge base suitable for electric power systems can satisfy these objectives using fuzzy inference. Compared with corresponding conventional equipment, the new equipment improved the deviation of 30 min average voltage of 30 percent. This paper describes the design concept of new voltage control equipment using fuzzy inference. In addition, field test results are described along with rules of fuzzy inference, membership functions, and the deviation of 30 min average voltage through detailed simulation.     

高电容比射频/微波MEMS膜开关的理论分析和数值模拟

建立了一个MEMS膜开关电容比理论模型，由于这个模型比较全面地考虑了开关阈值电压、维持电压、偏置电压和介质膜内的电场强度等因素对电容比的影响，因而能较为正确地反映开关的电容特性。用数值方法计算了影响开关电容比的因素，并对计算结果进行了分析和讨论。提出了使用脉冲电压作为偏置电压可以使介质膜gj的厚度减少到50nm，从而使开关的电容比增加到3800。最后，讨论了实现高电容比MEMS膜开关的可行性。     

Insulating safety analysis of the hot-line sweeping robot

This paper presents a method of calculating the insulating safety distances for hot-line working robots at high voltage when dielectric is adulterated with conducts. Also, finite element method is adopted to calculate the electric field strength to find whether it is beyond the critical. The above methods have been applied to analyze the insulating safety of the robot for hot-line sweeping post insulators in a 220 KV substation. They have also been testified by experimentations.     

高压电动机定子线圈匝间绝缘问题的探讨

在实践经验的基础上，分析了我国匝间绝缘短路的主要原因，提出在匝间绝缘的设计，制造工艺及耐压试验等工序采取合理措施，以提高匝间绝缘的可靠性。     

An investigation of induced voltages to an underground gas pipeline from an overhead transmission line

This paper investigates induced voltage characteristics from an overhead transmission line by applying a method of modeling of induced voltages proposed by the authors. EMTP simulation results obtained by the modeling method agree with analytical results obtained from a well‐known formula. The induced voltages are significantly dependent on the configuration of the overhead line. A horizontal line induces the largest voltage in a gas pipeline, and the voltage induced by a vertical twin‐circuit line is about 20% smaller than that induced by a vertical single‐circuit line. The method is applied to a real pipeline system and the simulation results show reasonable agreement with field test results. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(1): 43–51, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20465     

高压大容量变频技术现状及交——交SDM级联技术简介

本文通过对目前广泛使用的三电平及多电平级联高压变频控制方案技术特点的对比论述，介绍了一种新型高压大容量变频器控制方案，并对该方案的优越性作了介绍。     

变频调速器在桥式抓斗吊车中的应用

论文主要介绍了电机的调速方法、变频器的工作原理以及日本FRNIC500G7型变频器在桥式抓斗吊车上的应用，并分析了使用绕线式电机调速与鼠笼式电机变频调速之间的优缺点。     

感应电机压频比调节的模糊节能控制

根据三相感应电机的等效电路，推导出电机的损耗和输出功率与压频比之间的关系，提出了压频比调节的节能控制方法。考虑电机不同负载时损耗曲线的变化持点，引入基于电机转速和输入功率的比例算子，对电机输入功率的变化进行量化；电机稳态运行时进行模糊自寻优控制，动态调速时进行较高的恒压频比控制，提高了电机的效率并保持了一定的动态响应特性。仿真结果验证了运行控制方案的可行性和有效性。     

PFC控制技术的一种改进方案

文章首先指出了目前ＰＦＣ所用控制技术的缺陷，然后提出了一各改进方案，并从理论分析和仿真验证的角度证明了改进方案的可行性和先进性。