Nanocrystalline CeO2 in SBA-15: Performance of Pt/CeO2/SBA-15 Catalyst for Water-gas-shift Reaction

CeO₂ particles confined within the pores of an SBA-15 mesoporous silica host were prepared by incipient wetness impregnation (IMP) and deposition precipitation (DP) methods. The materials were characterized by XRD, N₂-adsorption and temperature programmed reduction (TPR) to evaluate the structure, texture, and redox properties. The preparation procedure had significant impact on the assembling mode of CeO₂ inside the SBA-15 mesopores. A high dispersion of CeO₂ particles was achieved via DP, whereas the dispersion of CeO₂ prepared by IMP was found to be inhomogeneous and CeO₂ partially blocked the pores. The CO conversion in the water-gas-shift reaction was enhanced over 1 wt% Pt supported on CeO₂-modified SBA-15 obtained by DP.     

A voltammetric study concerning the structural stability of Li-overstoichiometric Mg-doped LiCoO2 powders

The effect of Mg-doping and Li overstoichiometry on the structural stability of LiCoO₂ powders has been investigated with emphasis to voltammetric properties. Microparticle cyclic voltammetry (CV) conducted in caustic NaOH to best simulate a non-aqueous electrolyte shows a marked improvement of the structure stability of doped LiCoO₂. In contrast to the unsubstituted LiCoO₂ sample which shows voltammetric peaks associated to the well-known two-phase domain and monoclinic distortion reactions, in Li_1.08Mg_0.06CoO₂, LiMg_0.06CoO₂ and Li_1.08CoO₂ samples these peaks are strongly suppressed providing direct evidence for the existence of a stable solid solution with negligible phase transitions in the reversible intercalation region (3.8-4.2 V vs. Li) as well as in the overcharged region. The effect is higher with Mg-doping, irrespective of the Li overstoichiometry. However, the concomitant presence of Mg and Li excess in the structure is important for obtaining small particle sizes. Since Mg-doping induces a quasi metallic behavior in the samples, whereas the Li excess may provide an higher initial capacity, it is suggested that the Li_1.08Mg_0.06CoO₂ composition may be of interest as positive cathode for advanced Li-ion batteries.     

乙烯二聚制高纯丁烯－1技术经济评价

本文对生产高纯度丁烯－１的Ａｌｐｈａｂｎｔｏｌ工艺进行了技术经济评价，认为该工艺条件简单、反应条件温和，而且投资少，所以很适合事在发展中国家应用。     

Crystallization and phase transformation kinetics of poly(1-butene)/MWCNT nanocomposites

Poly(1-butene)/MWCNT nanocomposites were prepared by simple melt processing technique. Crystallization, crystal-to-crystal phase transformation and spherulitic morphology were studied using differential scanning calorimetry (DSC), wide angle X-ray diffraction (WAXD) and optical microscopy (OM). The non-isothermal crystallization exhibited higher values of Z_t derived from Avrami theory and lower values of F(T) obtained from Avrami-Ozawa analysis, while the isothermal crystallization revealed a significant increase in crystallization temperatures and lower crystallization half times compared to pristine PB. The observed changes in the crystallization kinetics were ascribed to the enhanced nucleation of PB in the presence of MWCNT. The nucleating activity calculated from the non-isothermal crystallization data revealed that the MWCNTs provide an active surface for the nucleation of PB. The optical micrographs exhibited significantly smaller crystallites with disordered morphology for the nanocomposites compared to the well defined spherulitic morphology for pristine PB. The rate of phase transformation from kinetically favored tetragonal to thermodynamically stable hexagonal form was noticeably enhanced as evidenced by the reduction in the half time for phase transformation from 58 h to 25 h for PB reinforced with 7% MWCNT.     

Possible Energy Network with polygeneration system and CCS for China

On basis of adopting polygeneration systems for power and alternative fuels,capturing CO2 with near zero energy penalties,and storing CO2 on sites,a new kind of Energy Network can integrate energy utilization,CO2 capture,transportation and storage synthetically.Techno-economic analysis of this solution focusing on Inner Mongolia and the Yangtze River Delta districts had been carried with comparison to the chain method for energy utilization and CO2 sequestration.This solution can save 21.5% of energy,and re...     

CuO-NiO/Al_20_2催化剂上N-甲基哌嗪合成研究

以共沉淀法制备铜、铝系复合氧化物作为催化剂,二乙醇胺和甲胺为原料,合成了N-甲基哌嗪.利用高压反应釜对其进行活性评价,发现CuO-NiO/Al2O3活性最高.并对铜、铝、镍摩尔比、沉淀剂种类、沉淀方式,焙烧温度等条件进行了优化.结果表明:催化剂中理想的Cu、Al、Ni摩尔比为1:1:3.2,沉淀剂为氢氧化钠,沉淀方式为并流,焙烧温度为500℃.该条件下N-甲基哌嗪的选择性为27.7%,二乙醇胺的转化率达89.8%.另外通过对使用前后催化剂进行表征分析发现催化剂失活原因为表面高聚物的附着和对孔道的堵塞.     

Study of the physico–chemical characteristics and rheological behaviour of boehmite dispersions for dip-coating applications

Dispersions of a totally dispersible AlOOH powder have been studied. The effect of the initial composition has been studied to outline the reactions that determine the final rheological behaviour of the dispersions. The final viscosity and viscoelastic properties of the dispersions are determined by the sol–gel phenomena occurring during the ageing treatment. Gel formation is favoured by low water and high acid contents, while it is disfavoured by prolonged stirring. Gelling time from 48 h to 4 months has been observed depending on the initial composition.     

Intergranular oxidation of silicon in 20Cr-25Ni niobium-stabilized stainless steel at 1140–1230 K

The kinetics of intergranular oxidation of silicon in a 20Cr-25Ni Nb-stabilized stainless steel are reported, at temperatures in the range 1140–1230 K, in CO₂ at 40 bar pressure. The depth of attack increased parabolically with respect to time, with an activation energy of 335±30 kJ/mol. The mechanism of growth is discussed in terms of classical internal-oxidation theories, and an alternative explanation based on an available-space theory is developed. The internal oxidation rates in a number of different alloys are compared with diffusivities of metals in the base alloy. It is proposed that intergranular oxidation in the 20–25 Nb steel is controlled by the rate of outward diffusion of iron or chromium in the alloy.     

基于FPGA的TDM over IP的设计

设计一种TDM over IP的技术系统。该系统用FPGA将E1数据包通过串并转换到千兆以太网数据包,经IP网传输到终端设备,再通过并串转换将以太网数据包转换成E1数据包完成传输。经过软件和硬件测试验证了此系统在千兆以太网上传输的可行性,系统没有出现误码,固有输出抖动是0.55UI,最大峰值抖动指标均满足ITU-G.823标准要求。