GSM与WCDMA无线网络规划比较

WCDMA与GSM在空中接口上存在较大差异,WCDMA基于码分多址技术,GSM基于时分多址技术。GSM主要处理语音和低速数据,而WCDMA引入了多种速率的数据业务,根据业务的QoS进行资源控制和分配,因此在无线网络规划方法上,WCDMA与GSM存在较大差异。文章从容量规划、覆盖规划、蜂窝布局、规划流程、网络评估等方面对WCDMA与GSM的无线网络规划进行了比较和分析。     

Development and simulation studies of an unsteady state biofilter model for the treatment of cyclic air emissions of an α‐pinene gas stream

This paper describes the development and simulation of an unsteady state biofilter model used to predict dynamic behaviour of cyclically‐operated biofilters and compares it with experimental results obtained from three, parallel, bench‐scale biofilters treating both periodically fluctuating concentrations and constant concentrations of an α‐pinene‐laden gas stream. The dynamic model, using kinetic parameters estimated from the constant concentration biofilter, was able to predict the performance of cyclic biofilters operating at short cycle periods (ie, in the order of minutes and hours). Steady state kinetic data from a constant concentration biofilter can be used to predict unsteady state biofilter operation. At a 24 h cycle period, the dynamic model compared well with experimental results. For long cycle periods (ie, hours and days), removal efficiency decreased after periods of non‐loading: the longer the period of non‐loading, the poorer the biofilter's performance at the re‐commencement of pollutant loading. At longer time scales the model did not effectively predict transient behaviour, as adsorption and changes in kinetic parameters were not accounted for. Modelling results showed that similar biofiltration performance for the cyclic and constant concentration biofiltration of α‐pinene is expected for biofilters operating solely in the first order kinetics regime. Poorer performance for cyclic biofilters following Monod kinetics spanning the entire kinetics range is expected as the cycle amplitude increases. The most important parameters affecting the performance of a cyclically‐operated biofilter with short cycle periods are: amplitude of cyclic fluctuations, C_{g, max}/C_g, relative value of the half‐saturation constant in the Monod expression, K_s, and effective diffusivity of α‐pinene in the biofilm, D_e. Copyright © 2005 Society of Chemical Industry     

Ultrasound‐activated Knoevenagel condensation of malononitrile with carbonylic compounds catalysed by alkaline‐doped saponites

α,β‐Unsaturated nitriles have been synthesized by Knoevenagel condensation of a carbonylic compound with malononitrile, assisted by sonochemical irradiation. Two alkaline‐promoted clays (Li⁺‐ and Cs⁺‐exchanged saponites) have been employed as catalysts. The influence of the carbonylic compound (benzaldehyde or cyclohexanone) and the use of a solvent on the catalytic activity have been studied. Remarkable increase in the conversion values has been found when the reaction is activated by ultrasound, as compared with the thermal activation. In this green, solvent‐free procedure, α,β‐unsaturated nitriles have been produced in very high yields (97%) when the Cs⁺‐saponite is used as catalyst. Copyright © 2004 Society of Chemical Industry     

三维地震勘探中强声波干扰的压制

在三维地震资料采集中产生的声波为非线性干扰波,能量强,频谱宽,利用常规的分频去噪和线性压噪方法难以将其去除,使后续的资料处理效果受到影响。基于声波具有非常稳定的传播速度这一特点,提出了一种利用非线性变换手段压制强声波干扰的方法。方法原理是,首先对三维地震资料中含声波到达时间的某段记录(时窗)进行转换,将非线性声波时距关系转换为速度趋于无穷、波数趋于零的一组噪声;然后应用f-k滤波对这组噪声进行压制;最后,再通过逆转换得到声波压制后的结果。该方法易于实现,并只对声波到达时间处的小范围数据进行处理,数据量小,计算效率高。对实际三维地震资料的处理结果表明,该方法压制强声波干扰的效果非常明显。     

层状Ti3SiC2陶瓷的组织结构及力学性能

利用热压烧结TiH₂,Si和C粉获得了致密度大于98%的层状Ti₃SiC₂陶瓷。利用压痕法,在不同的载荷下测定了材料的维氏硬度, 发现其硬度值随载荷的增加而降低,在最大载荷30kg时,硬度值为4GPa。压痕对角线没有发现径向裂纹的出现。 这归因于多重能量吸收机制——颗粒的层裂、裂纹的扩展、颗粒的变形等。利用三点弯曲法和单边切口梁法测定了材料的强度和韧性分别为270MPa和6.8MPa·m1/2。Ti₃SiC₂材料的断口表现出明显的层状性质,大颗粒易于发生层裂和穿晶断裂,小颗粒易被拔出。当裂纹沿平行于Ti₃SiC₂基面的方向扩展造成颗粒的层裂,当裂纹沿垂直于基面的方向扩展时,裂纹穿过颗粒的同时,在颗粒内部发生偏转,使裂纹的扩展路径增加。裂纹的扩展路径类似人们根据仿生结构设计的层状复合材料。裂纹在颗粒内的多次偏转、裂纹钉扎以及颗粒的层裂和拔出等是材料韧性提高的主要原因。此外,在室温下得到的荷载-位移曲线,说明Ti₃SiC₂材料不象其它陶瓷材料的脆性断裂,而是具有金属一样的塑性。     

喷射导管技术在深水钻井作业中的应用

深水油气日益成为海洋石油勘探开发的热点，但深水钻井作业面临着许多难题和挑战，喷射导管技术是解决深水浅层钻井难题的技术之一。该技术采用在喷射管柱内下动力钻具的方式，用钻入泥线以下的管串自身重力钻进，喷射到位后利用地层的粘附力和摩擦力稳固住导管，起出送入工具和管内钻具，完成导管的安装。喷射导管技术可避免因水泥浆密度过大而压破地层，也可避免深水由于低温等因素影响固井质量。我国第一口水深超千米的深水井——荔湾3-1-1井利用该技术成功完成了导管的安装，井口装置没有出现井口失稳的问题。随着我国深水勘探步伐的加快，越来越多的深水区块将投入勘探开发，喷射导管技术具有良好的应用前景。     

鞍钢1780mm热轧生产线"三电"工程施工概述

概述了鞍钢1780mm生产线技术改造工程中供电、传动及自动控制系统的构成、安装及调试技术要点,以及技术经济效果评述,可供同类工程施工参考.     

A geometry-based error estimation for cross-ratios

For choosing specific cross-ratios as 2D projective coordinates in various computer vision applications, a reasonable error analysis model is usually required. This investigation adopts the assumption of normal distribution for positioning errors of point features in an image to formulate the error variances of cross-ratios. Based on a geometry-based error analysis, a straightforward way of identifying the cross-ratios with minimum error variances is proposed. Simulation results show that the proposed approach, as well as a further simplified alternative, yield much better estimations of minimum error variances in terms of accuracy, cost, and stability compared with some other methods, e.g., the one based on the rule given by Georis et al. (IEEE Trans. Pattern Anal. Mach. Intell. 20 (4) (1998) 366). Some causes of the performance differences in the estimations are explained using a special configuration of point features.     

乙炔在磁稳定床中的选择性加氢研究

 制备了一种磁性Pd/Al₂O₃催化剂，采用磁稳定床考察了活性组分负载量、反应条件及CO浓度对乙炔加氢反应性能的影响。结果表明，当反应温度80℃、反应压力1.5MPa、空速9000h－1、磁场强度（H）25kA/m时，乙炔转化率为100％，乙烯选择性可达81％，具有优良的乙炔加氢活性和乙烯选择性，优于相同反应条件下的进口催化剂；250h稳定性实验结果表明，磁性Pd/Al2O3催化剂具有良好的初活性和乙烯选择性，催化剂性能稳定。     

负载化非茂单活性中心催化剂乙烯聚合的研究

在硅胶上负载了双(N-环己基-3-叔丁基水杨醛亚胺基)二氯化锆配合物,得到负载化非茂单活性中心催化剂。该催化剂用于乙烯聚合,考察了配合物用量、共聚单体1-己烯用量、聚合温度、聚合压力、聚合时间、三乙基铝用量对乙烯聚合性能的影响及对聚合物的相对分子质量、相对分子质量分布、熔体流动指数和密度的影响。实验结果表明,负载化非茂单活性中心催化剂保持了原均相催化剂的乙烯聚合性能;该催化剂在淤浆聚合工艺中聚合平稳,所得聚合物的颗粒形态良好。