VCM生产过程中汞污染的防治

介绍了引进VCM生产技术中，有关含汞污水的处理方法及在生产工艺上所采取的减少汞污染的措施，解决了催化剂的汞污染问题。     

Properties of latex blends and its modified cement mortars

In this paper, the mechanical properties of three latex blends and the mechanical properties and chloride diffusivity of the latex-modified mortars are studied. The relationships between the properties of polymer films formed from latex blends and the properties of the latex blend-modified mortars are illustrated. The test results showed that the modified mortar with the blend of styrene-acrylic ester (SAE) and styrene-butadiene rubber (SBR) showed synergistic effect; especially the flexural strength of the SAE/SBR blend-modified mortars was about 20-40% higher than that of monolatex-modified mortars. However, the vinyl chloride-vinylidene chloride copolymer (PVDC)/SBR and PVDC/SAE blends-modified mortars showed antisynergistic effect. The compressive strength of the modified mortars increased with the increasing of the tensile strength of the latex films, while the flexural strength of the modified mortars did not depend on the tensile strength of the latex films. When PVDC with the mass fraction of 0.2 or SAE copolymer emulsion with mass fraction of 0.4 was blended into SBR latex, the latex blend-modified mortars showed lower chloride diffusivity. The chloride diffusivity of the modified mortars increased approximately linear with the tensile strength of the latex blend films, and decreased with increase of the elongation at rupture of the latex blend films. When the elongation at rupture of the latex blend films increased from 200-300% to more than 800%, the chloride diffusivity of the modified mortars decreased from 10-15×10⁻¹² to 3-4×10⁻¹² m²/s.     

Impact of specification changes on chloride-induced corrosion service life of bridge decks

A model was developed to determine the time to first repair and to subsequently rehabilitate concrete bridge decks exposed to chloride deicer salts. Said model incorporates the statistical nature of factors affecting the corrosion process. The time to first repair and rehabilitate was predicted for 10 bridge decks built in Virginia between 1981 and 1994.The model was validated using historical service life data for 129 bridge decks built in Virginia between 1968 and 1972. The time for rehabilitation predicted for the newer set of bridge decks was approximately 13 years longer than the normalized time for rehabilitation projected for the older bridge decks. The increase in time for rehabilitation for the newer set of bridge decks was attributed to a reduction in the specified maximum water/cement ratio and increase in clear cover depth. The probabilistic model is shown to be an advancement over the deterministic model currently in use.     

The effect of Cu-rich sub-layer on the increased corrosion resistance of Cu-xZn alloys in chloride containing borate buffer

The electrochemical behaviour of Cu-xZn alloys, as well as their constituent metals, in a borate buffer containing chloride ions in the molar range from 0.01 to 1 M are studied. Characteristics of these materials under anodic polarization are compared and the composition and morphology of the corrosion products formed in the course of polarization experiment are analysed by SEM and EDS. X-ray photoelectron spectroscopy and electrochemical impedance measurements are used for characterization of the surface layers formed on Cu, Zn and Cu-40Zn alloy during 2-h immersion at E_oc in a borate buffer containing two different concentrations of chloride ions. New aspects of the behaviour of brass under E_oc condition are revealed. The improved corrosion resistance of brass in chloride media, if compared to zinc metal, is attributed to a Cu-rich layer formed by the selective dissolution of zinc. Based on the results, a structural model describing the improved corrosion resistance of Cu-40Zn alloy with respect to Zn metal is proposed.     

铵离子交换处理负硬水供锅炉应用技术

本文论述了负硬水只用氯化铵再生时离子交换器的运行过程及离子交换软化除碱的方法,并阐述了控制出水中残留碱的简便方法。经研究证明,此方法可达到除碱度、除硬度、除盐、延长锅炉使用寿命、减少腐蚀、减少排污量、节约燃煤等效果。经济效益十分显著。     

水解母液生产葡萄糖酸钙新工艺

葡萄糖酸钙的生产一般是以淀粉为原料经液化、糖化、发酵、中和、精制、结晶、干燥制得的。而以母液为原料，其原料成本低，工艺流程短，减少了营养元素的添加，大幅度地降低了生产成本，值得推广。     

对我厂防治加热管内碳酸钙垢的思索

分析了我厂两碱法原卤净化后,加热管内壁结碳酸钙垢的原因,探讨了我厂采取加盐酸、加阻垢剂、用超声波阻垢器的方法,以及对加热管内碳酸钙垢防治的情况和存在的问题.     

Cathodic processes in the leaching and electrochemistry of covellite in mixed sulfate–chloride media

The cathodic processes that occur on a covellite (CuS) surface in mixed sulfate–chloride solutions in the absence and presence of copper(II) ions have been studied using potentiostatic transients and cyclic voltammetry at rotating disk electrodes in the potential range 0.3–0.7 V (versus SHE). This range is relevant to the oxidative leaching of this copper mineral in sulfate and chloride lixiviants. Variations in the concentrations of sulfate and chloride ions had a small effect on the cathodic reduction of covellite in the potential range of 0.5–0.3 V, although the presence of chloride ion resulted in a significant increase in the anodic current on the reverse sweep. On the other hand, addition of copper(II) ions resulted in enhanced cathodic currents and subsequent anodic currents in both sulfate and chloride solutions due to reduction of covellite to an undefined reduced copper sulfide species. Reduction of copper(II) to copper(I) ions becomes the preferred cathodic reaction as the concentration of chloride ions increases, becoming mass transport controlled at a rotating disc electrode at potentials below about 0.4 V. Potentiostatic measurements at potentials negative to the mixed potential in acidic chloride solutions have shown that reduction of copper(II) ions is reversible and have been used to estimate the rate of oxidative dissolution of the mineral which value agrees reasonably well with previously reported leaching rates under similar conditions. Reduction of dissolved oxygen has been found to be very much slower that that of copper(II) ions under ambient conditions.     

饲料级磷酸氢钙中氟的几种分析方法比较

本文采用茜素络合酮比色法和氟离子选择电极法对饲料磷酸氢钙进行氟的测定实验对比,得出常用的氟离子选择电极法完全可以代替经典的蒸馏比色法的结论。     

Stability of protective oxide films in waste incineration environment—solubility measurement of oxides in molten chlorides

Solubility measurements of several oxides in molten NaCl-KCl and NaCl-KCl-Na₂SO₄-K₂SO₄ were conducted in three different levels of basicity. The dissolution behavior of the oxides showed almost the same tendency as that shown by the dissolution behavior of the oxides in molten Na₂SO₄ in literature. In a waste incineration environment, a protective Cr₂O₃ film easily dissolves in molten chlorides as CrO₄²⁻ because pO²⁻ of the molten chlorides tends to have a small value due to the effect of water vapor contained in the combustion gas. From the result of the solubility measurement, the addition of molybdenum and/or silicon was expected to improve the corrosion resistance of alloys. Laboratory corrosion tests confirmed this expectation. However, the scale analysis suggested that the effect of molybdenum could not be explained completely by only the mechanism derived from the result of the solubility measurement.