用分步沉积法去除Nb(OH)5/Ta(OH)5中Ti,Sb等金属杂质的工艺研究

从理论和实践应用方面，研究了在不同活性金属离子存在的条件下控制pH值，应用分步沉积的方法去除Nb(OH)5/Ta(OH)5中某些金属杂质。在一定温度下，可在不影响Nb(OH)5/Ta(OH)5沉积的条件下，达到有效去除Ti，Sb，Sn，Al，Fe等杂质元素的目的。     

MLS结构的电容-电压特性

本文报导在 Si 衬底上拉制聚酰胺 LB 膜的电容-电压特性,结果表明:它具有与其它绝缘膜相似的特性,为聚酰胺 LB 膜应用于场效应器件奠定了基础。     

Au（Ⅲ）—PAR络合吸附波的研究

金与PAR(4-(2-吡啶偶氮)间苯二酚)的络合物在HAc-NaAc底液中于-0.43V处有一灵敏的络合吸附导数波,波高与金浓度在0.1～1.8μg/ml范围内呈线性关系,可用于分析测定。研究了该波的性质及电极过程,测定了该络合物的组成及表观稳定常数。     

高密度聚乙烯6300M和2480的耐环境应力开裂性能研究

研究了成型塑料管材的两种牌号的高密度聚乙烯(HDPE)6300M和2480的耐环境应力开裂(ESCR)性能。研究中采用的测试方法为一般弯曲试片法、在管上取样的弯曲试片法和恒定压应变法-压缩环法。根据两种材料测试结果及与其他牌号HDPE测试数据比较,对他们的ESCR进行评价,并讨论和解释了HDPE结构参数,ESCR与韧性形变和脆性断裂之间的联系。     

X-ray structure analysis and elastic properties of a fabric reinforced carbon/carbon composite

The effect of heat treatment on microstructure of a plain-weave carbon fabric reinforced carbon-carbon composite with phenolformaldehyde-derived carbon matrix was investigated by X-ray diffraction. The diffraction patterns were analysed by the least-square fitting program Carbonxs. After heat treatment from 1000 to 2800 °C the interplanar distance of (002) planes decreased from 3.488 to 3.420 Å and the lattice parameter in basal plane increased from 2.440 to 2.464 Å, respectively. Simultaneously, the coherent block size in the basal plane directions increased from 18 to 54 Å, which was accompanied by an increase of the fraction of organised carbon atoms from 0.50 to 0.85. The 002 diffraction profile of the composite was much narrower than the sum of peaks of the matrix and fabric alone. This can probably be caused by a better crystallographic ordering (or by a partial graphitisation) of the matrix in the composite. On the other hand, the composite Young’s modulus slightly decreased with the treatment temperature increasing from 2200 to 2800 °C in spite of the established strong improvement of fibre crystallinity and, therefore, fibre modulus. The mechanisms diminishing the modulus of composite (e.g. partial matrix graphitisation at the fibre/matrix interface and decreasing fibre/matrix contact area) probably prevailed over the increasing contribution of the fibre modulus.     

北京地区膳食摄入^232Th吸收入体液份额f1值的探讨

从北京地区公众成年人~(232)Th 的膳食日食入量,空气日吸入量,以及骨中~(232)Th 的沉积量出发,利用 ICRP 30号报告中参考人的代谢参数和内照射的库室模型,估算了北京地区公众成年人膳食摄入~(232)Th 后经胃肠道向体液转移份额 f_1值。结果表明,对于公众中成年人0.005是 f_1值的合适代表值,是 ICRP 30号报告推荐值 f_1=0.0002的25倍。虽然 ICRP 推荐值并不用于公众,但可以对群体有所了解;而北京地区从实测数据资料出发导出的 f_1值可能是更适于公众的。     

制氢尾气二氧化碳回收装置设计

对制氢尾气二氧化碳的回收装置进行了简捷设计，流程分析，并对换热装置的换热量和传热面积给出了算法和有关数据。     

The initial behaviour of freshly etched copper in moderately acid, aerated chloride solutions

When freshly etched samples of various types of copper were exposed in moderately acid, aerated chloride solutions, two phenomena were observed. First the corrosion potential and the pH of the solution decreased over a shorter time, then the potential increased over a long period (600-1500 min), following an s-shaped pattern. Increase in pH during the second stage was avoided using a pH-stat. The corrosion rate increased little or not at all over the entire period. A tentative interpretation of the short-term behaviour is presented with some reservation. The long-term development of the potential suggests phase formation or transformation following the Avrami pattern. By suitable derivations it was possible to fit the development of potentials to the Avrami equation. Subsequent examinations by Auger spectroscopy proved the presence of thin layers of Cu₂O on the copper surfaces, increasing in thickness with exposure time. The dissolution kinetics can be described in terms of two parallel electrochemical reactions and a simultaneous non-electrochemical dissolution reaction.     

熔融 NaCl-(Na,K)_2SO_4引起的 Fe-Cr 合金的热腐蚀

本文采用电化学方法研究了 Fe-Cr 合金在800℃、熔融 NaCl-(Na,K)_2SO_4中的腐蚀行为,并对腐蚀产物进行了观察和分析。结果表明,提高合金 Cr 含量可以改善合金耐蚀性能。氧化-硫化是Fe5Cr、Fe10Cr 合金腐蚀破坏的主要方式;氧化膜的熔融反应是 Fe20Cr、Fe25Cr 合金加速腐蚀的主要原因。同时,氧化膜的机械破裂也加速了合金的腐蚀。