液晶微位移传感器

液晶微位移传感器的工作原理是以负介电各向异性的向列相液晶材料的动态散射效应为基础的，文中给出了这种传感器的结构，测量方法、精度、应用范围和实验结果；研究了在阈值电压附近光的吸收和散射，讨论了该传感器的稳定性和遥控方法。     

低温下液体饱和蒸气压的测试

着重介绍了静态法测试低温下（－１００～５０℃）液体饱和蒸气压的原理及方法，给出了低温下液体全氟三乙胺饱和蒸气压的测试结果，并进行了讨论。     

填充HDPE复合材料基体结晶形态的控制因素

本文以HDPE/玻璃微珠和HDPE/CaCO₃体系为研究模型,通过扫描电镜、红外光谱、偏光显微、小角激光散射和材料力学性能实验等方法考察了这两种体系的界面粘结性、填料含量、粒径及试样成型冷却速率等与其材料性能及基体结晶形态变化间的关系。实验结果表明;在复合材料试样成型过程中,因基体树脂冷却收缩而产生的界面应力可干扰基体中球晶的生长环境,应变诱导填料颗粒周围基体树脂的结晶,促使其表面伸展链晶体结构的形成,并由此而明显改变了复合材料的耐热性;复合材料的界面粘结性是产生这种应变诱导作用,并控制异相结晶的关键。     

高强度船板纵裂纹的成因及预防

针对高强度船板纵裂纹轧后退废过高的现状，分析原因并优化冶炼、连铸工艺及操作，有效地降低高强度船板的退废率。     

VHF-PECVD制备微晶硅材料的均匀性及其结构特性的分析

采用VHF-PECVD技术在多功能系统(cluster tool)中制备了系列硅薄膜，研究薄膜的均匀性及电学特性和结构特性。结果表明：气压和功率的合理匹配对薄膜的均匀性有很大的影响；材料的喇曼测试和电学测试结果表明微晶硅薄膜存在着纵向的结构不均匀，在将材料应用于器件上时，必须要考虑优化合适的工艺条件；硅烷浓度大，相应制备薄膜的晶化程度减弱，即薄膜中非晶成分增多。     

Structural and electrical measurements of CdZnSe composite

TheI—Vcharacterization and the electrical resistivity of selenium rich Se₈₅Cd_15-xZn_x (x = 0, 3, 7, 11 and 15) system at room temperature have been studied. Samples were obtained using melt cooling technique. So prepared samples were then characterized in terms of their crystal structure and lattice parameter using X-ray diffraction method. The materials were found to be poly crystalline in nature, having zinc blend structure over the whole range of zinc concentration. The measurements ofI—V bdcharacteristics have been carried out at different temperatures from room to 140°C. The electrical resistivity of the samples with composition at room temperature has been found to vary between maximum 2.7 x 10⁸ Ωm and minimum 7.3 x 10⁵ Ωm and shows a maximum at 3 at. wt.% of Zn. The carrier activation energy of the samples with composition has also been determined and found to vary from 0.026 eV to 0.111 eV.     

InGaAsP／InP PFBH激光器

采用Ｎ－ＩｎＰ衬底研制ＩｎＧａＡｓＰ／ＩｎＰ激光器和ＤＦＢ激光器在国内已报导过多次，本文介绍用Ｐ－ＩｎＰ衬底研制ＩｎＧａＡｓＰ／ＩｎＰ平面埋层异质结构激光器和ＤＦＢ－ＰＦＢＨ激光器，同时利用晶体生长和晶向的依赖关系，改进埋区的结构，使器件最高激射温度大于１００℃。     

α－Al_2O_3衬底上生长的GaN膜的光学性质

采用金属有机化学气相淀积（ＭＯＣＶＤ）方法生长了α－Ａｌ２Ｏ３衬底上外延的高质量的单晶ＧａＮ薄膜。Ｘ射线衍射光谱与喇曼散射光谱表征了ＧａＮ外延薄膜的单晶结构和单晶质量。透射光谱和光调制反射光谱定出了六角单晶ＧａＮ薄膜的直接带隙宽度和光学参数。     

A study of the static and dynamic properties of side-chain liquid crystalline polymers in low molar mass mesogens

The static and dynamic properties of solutions of a side chain polysiloxane liquid crystal polymer have been studied in a cyanobiphenyl nematic host as a function of concentration and temperature. Refractive index measurements were carried out on aligned samples and the data used to determine the macroscopic order parameter, S, using Haller's method. Photon correlation spectroscopy has been used to measure ($\text{k}{}_{22}\text{γ}{}_1$) for the pure nematic solvent and the solutions. From these measurements it appears that the static properties vary slowly and linearly with increasing polymer concentration whilst the dynamic or viscoelastic properties change markedly. This change has been attributed to γ₁, the twist viscosity, and the results have been discussed in terms of the function of the siloxane polymer backbone.     

Long-term stability of an Au/Al2O3 catalyst prepared by incipient wetness in continuous-flow glucose oxidation

A 0.3% Au/Al₂O₃ catalyst prepared by the incipient wetness (IW) method was investigated in the continuous-flow liquid-phase glucose oxidation. Therefore, a continuous stirred tank reactor (CSTR) system equipped with an ultrasonic separator was used. The continuous-flow glucose oxidation was carried out at 40 °C, pH 9 and 1 bar oxygen partial pressure. Residence time and glucose concentration were varied. The IW gold catalyst showed very high activity and selectivity to gluconic acid within its 110 days of operation and, thus, an excellent long-term stability. Even after severe microbial contaminations of the catalyst, its activity could be completely restored by in situ regeneration with 2-propanol.