Grain-Boundary Wetting-Dewetting in z= 1 SiAlON Ceramic

The grain-boundary structure of a model SiAlON polycrystal with nominal composition Si₅AlON₇ was characterized by transmission electron microscopy (TEM) both in an equilibrium (as-processed) state at room temperature and after quenching from elevated temperature. In addition, low-frequency (1–13 Hz) internal friction data were recorded as a function of temperature, showing a pronounced grain-boundary sliding peak positioned at 1030°C. High-resolution transmission electron microscopy (HRTEM) of the equilibrated low-temperature microstructure revealed residual glass only at multigrain junctions, but no amorphous intergranular films were observed. The detection of clean interfaces in the as-processed sample contradicts the internal friction data, which instead suggests the presence of a low-viscosity grain boundary phase, sliding at elevated temperatures. Therefore, a thin section of the as-sintered material was heated to 1380°C and rapidly quenched. HRTEM analysis of this sample showed, apart from residual glass pockets, wetted grain boundaries, which is in line with the internal friction experiment. This wetting-dewetting phenomenon observed in z = 1 SiAlON is expected to have a strong impact not only on high-temperature engineering ceramics but also on geological, temperature-activated processes such as volcanic eruptions.     

Abnormal Grain Growth of Pb(Mg1/3Nb2/3)O3-35 mol% PbTiO3 Ceramics Induced by the Penetration Twin

Pb(Mg_1/3Nb_2/3)O₃-35 mol% PbTiO₃ (PMN-35PT) specimens with a 5 mol% excess PbO were prepared by excessive heat treatment at 1150°C to induce abnormal grain growth. Through electron backscatter diffraction analysis and the observation of a three-dimensional morphology, the abnormally grown PMN-35PT grains were found to be twinned crystals with penetration characteristics. The morphology of the PMN-35PT twinned crystal was crystallographically analyzed. The abnormal grain growth of PMN-35PT is suggested to be due to preferential growth at the reentrant angles formed by twins.     

Microstructural Analysis of Liquid-Phase-Sintered β-Silicon Carbide

The microstructures of fine-grained β-SiC materials with α-SiC seeds annealed either with or without uniaxial pressure at 1900°C for 4 h in an argon atmosphere were investigated using analytical electron microscopy and high-resolution electron microscopy (HREM). An applied annealing pressure can greatly retard phase transformation and grain growth. The material annealed with pressure consisted of fine grains with β-SiC as a major phase. In contrast, the microstructure in the material annealed without pressure consisted of elongated grains with half α-SiC. Energy-dispersive X-ray analysis showed no differences in the amount of segregation of aluminum and oxygen atoms at grain boundaries, but did show a significant difference in the segregation of yttrium atoms at grain boundaries along SiC grains for the two materials. The increased segregation of yttrium ions at grain boundaries caused by the applied pressure might be the reason for the retarded phase transformation and grain growth. HREM showed a thin secondary phase of 1 nm at the grain boundary interface for both materials. The development of a composite grain consisting of a mixture of β/α polytypes during annealing was a feature common to both materials. The possible mechanisms for grain growth and phase transformation are discussed.     

剪切速率和静置时间对Fe-Al-Mg-MMH/钠质蒙脱土复合触变性体系触变性的影响

研究了测定条件对R=0.051的Fe-Al-Mg型混合金属氢氧化物(简称MMH)/钠质蒙脱土(简称MT)复合触变性悬浮体性质的影响.主要考察了高速剪切分散后,测定粘度(η)随时间(t)变化时采用的剪切速率(DL)和测定η前的静置时间(ts)的影响发现DL和ts的影响很复杂,ts=0,低DL时(10和170s-1)呈现复合触变性的体系,在高DL时(340、511和1022s-1)可呈现正触变性;DL增加,体系η逐渐降低.在所研究的ts范围内(0～2h),随ts的增加,体系分别由低DL时(10和170s-1)的复合触变性和高DL时(340、511和1022s-1)的正触变性皆转变为负触变性.低DL时(10和170s-1),η随ts逐渐降低;高DL时(340、511和1022s-1),η随t逐渐增高.对影响机理进行了初步探讨.     

骨料颗粒与多孔材料显微结构关系的研究

本文阐述了多孔材料的孔隙率与生产工艺的关系 ,结合显微结构分析了骨料粒径及其分布对多孔材料的孔隙率、抗折强度的影响。     

A Systematic Study of Mixed Surfactant Solutions of a Cationic Ester-Bonded Dimeric Surfactant with Cationic, Anionic and Nonionic Monomeric Surfactants in Aqueous Media

A novel cationic biodegradable dimeric (gemini) surfactant, ethane-1,2-diyl bis(N,N-dimethyl-N-hexadecylammoniumacetoxy) dichloride (16-E2-16), containing an ester-linked spacer was synthesized. Its pure and mixed micellization properties with monomeric surfactants cetyl trimethyl ammonium chloride, cetyl pyridinium chloride, sodium dodecyl sulfate, sodium dodecyl benzene sulfonate, cetyl alcohol ethoxylate (20EO) and tert-octylphenol ethoxylate (9.5EO) were investigated by surface tension measurements at 30 °C. The critical micelle concentration (CMC) of 16-E2-16 is well below that of cetyl trimethyl ammonium chloride containing the same number of carbon atoms in the hydrophobic tail per polar head. At different mole fractions of the gemini surfactant, the CMCs of the gemini-conventional binary mixtures were determined and were found to be less than the ideal CMC values in all the cases indicating synergistic interactions. Aggregation number and Stern–Volmer constant, obtained by the fluorescence quenching technique, also support the synergistic behavior of the surfactant systems.     

PMMVA润滑油降凝剂的合成及其降凝效果

用混合高碳醇、十八胺分别与马来酸酐反应得到醇解产物和胺解产物,再以2种产物以及醋酸乙烯酯为单体,三元共聚得到目标产物：马来酸混合醇酯-马来酸十八酰胺-醋酸乙烯酯共聚物（PM—MVA）。正交实验确定了缩合反应中醇解反应的最优工艺条件：n（马来酸酐）：n（混合醇）-1：1、m（催化剂）：m（反应物）-2．0％、m（溶剂）：m（反应物）-40％。胺解反应以反应物n（马来酸酐）：n（十八胺）=1：2进行。正交实验确定最佳的聚合工艺条件：n（缩合产物）：n（醋酸乙烯酯）-1：1．5、m（引发刑）：m（聚合单体）-1．5％、m（溶剂）：m（聚合单体）-30％、聚合温度75℃、聚合时间4h。IR结果表明：所制备产物的官能团结构与设计的目标产物相符。将最佳条件下合成的产物以硼（降凝剂润滑油）-0．85％加入到150SN润滑油基础油中,凝点可降低17℃。     

石灰竖窑结瘤原因分析和预防措施

结合生产实践,对石灰竖窑的结瘤原因进行了分析,介绍了结瘤的防范措施、结瘤的判断方法及处理方法。     

PMI泡沫塑料及其夹层结构的高频介电性能研究

本文研究了密度和厚度对PMI泡沫塑料及其碳纤维、玻璃纤维夹层结构10GHz的高频介电性能的影响。结果表明,PMI泡沫塑料的厚度对其高频介电性能影响不大;随着密度的增加,PMI泡沫塑料的高频介电性能呈近线性规律增大,并与理论计算值基本一致;随着厚度的增加,其碳纤维夹层结构和玻璃纤维夹层结构的高频介电性能均不断降低,并逐渐接近纯PMI泡沫塑料的介电性能,其规律符合串联公式模型;玻璃纤维夹层结构的高频介电性能低于碳纤维夹层结构。     

Aggregation Behavior of Perfluorononanoic Acid/Sodium Dodecyl Sulfate Mixtures

The mixed system of an anionic hydrocarbon surfactant, sodium dodecyl sulfate, and a perfluorinated surfactant, perfluorononanoic acid (PFNA), was investigated by a combination of methods. The critical micellar concentrations (CMC) were determined over a wide range of sample compositions by surface tension, conductivity and UV–visible spectrophotometry using N-(4-nitrophenyl)perfluorononanamide as a molecular probe. The values of CMC obtained by different techniques were in good agreement. In addition, the aggregation numbers were determined in the mixtures with a low content of hydrocarbon surfactant, by measuring the fluorescence quenching of pyrene. The hydrodynamic radii of the aggregates were estimated through the diffusion ordered ¹⁹F- and ¹H-NMR spectroscopy. The values obtained are in agreement with those expected according to the measured aggregation numbers. The analysis of the data with different aggregation models suggests the formation of a non-ideal mixed micelle that is enriched in the perfluorinated surfactant when its mole fraction increases, and that is practically formed by PFNA only at mole fractions higher than 0.8.