Evidence for (E,Z)-8,10-dodecadienyl acetate as the major component of the sex pheromone of the eastern pine seedworm,Cydia toreuta (Lepidoptera: Tortricidae)

The sex pheromone ofCydia toreuta (Grote), the eastern pine seedworm, was investigated using electroantennogram (AG) measurements, gas chromatography (combined GC-FID-EAD) measurements, and field tests. (E,Z)-8,10-dodecadienyl acetate (E,Z8,10-12:Ac) and (E,E)-8,10-dodecadienyl actetate (E,E8,10-12: Ac) produced both the highest EAG and EAD responses. Only a single antennal stimulatory peak was observed when female abdominal tip extracts were analyzed by GC-FID-EAD, which corresponded exactly with that of authenticE,Z8,10-12: Ac. Field tests confirmedE,Z8,10-12: Ac as the major pheromone component. TheE,Z isomer by itself caught equivalent numbers of male moths as did caged females. The addition of theE,E isomer to theE,Z form increased trap catch, although not significantly (P = 0.05). The addition of (Z,Z)-8,10-dodecadienyl acetate to theE,Z isomer significantly (P=0.05) reduced trap catch, while the addition of (Z,E)-8,10-dodecadienyl acetate to theE,Z form also decreased trap catch, but not significantly (P=0.05).     

芯壳乳液胶粘剂的研究

介绍乙酸乙烯酯－丙烯酸丁酯－丙烯酸芯结构乳液的制备方法，并将它们的性能与均匀共聚乳液作了测试与比较。     

Investigation of the Influence of Fillers on the Properties of Poly(vinyl acetate) Adhesives

The properties of poly(vinyl acetate) compositions prepared as potential wood adhesives were investigated. The paper presents the results of the influence of various kinds of inorganic fillers based on calcium carbonate and alumino-silicate and an organic filler, starch, on the adhesive composition properties. The comparison among rheological behavior of the adhesive dispersions concerning the specific role of fillers were made. Mechanical and relaxation properties of the adhesive films could reveal the effect of filler characteristics on the polymer matrix. The significant influences of particle size distribution and specific surface area on the poly(vinyl acetate) adhesive composition were determined, along with other filler characteristics.     

聚醋酸乙烯乳液缩醛化的改性研究

本文介绍了为提高聚醋酸乙烯乳液稳定性、耐水性和防冻性而进行缩醛化改性的原理，并确定了最佳工艺条件即甲醛与聚乙烯醇的配比为０．４５～０．５０。     

微波辐射活性炭固载对甲苯磺酸催化合成乙酸异戊酯

用颗粒状活性炭固载对甲苯磺酸作催化剂，在微波辐射下合成乙酸异戊酯。实验结果显示，当微波功率为150W，催化剂用量为1．4g，n(醇)：n(酸)=1．2：1，反应时间30min，酯化率为98．0％以上。另外通过实验发现，微波辐射下其反应速率明显高于常规加热方式。     

Lewis酸存在下的自由基共聚合——Ⅰ.GeCl_4与BCl_3存在下的乙酸乙烯酯与丙烯酸交替共聚

乙酸乙烯酯(VAc)与丙烯酸(AA)在GeCl_4及BCl_3存在下通过自由基聚合可得到交替共聚物。对GeCl_4体系,聚合反应速率正比于[引发剂]~(0.5)。当VAc/AA=1:1(mol比)时有最大反应速率。CCl_4对本聚合反应无链转移作用。通过紫外光谱分析可证实VAc及AA均与GeC\(?)生成络合物;ESR分析表明,络合AA自由基较未络合AA有较强的阳离子特性,交替共聚的原因可能与络合AA自由基及活化单体络合物二者有关。     

固体超强酸S_2O_8~(2-)/TiO_2-Al_2O_3催化合成乙酸戊酯的动力学研究

研究了以固体超强酸S2O82-/TiO2-A l2O3为催化剂合成乙酸戊酯的反应,在反应温度分别为100,108,116℃下,测出合成乙酸戊酯的动力学方程参数,建立了动力学方程式,并与无催化剂酯化反应的活化能及动力学方程式进行了比较。结果表明,最佳合成条件为:醇酸摩尔比1.3∶1,催化剂用量1 g,带水剂用量10 mL。固体超强酸S2O82-/TiO2-A l2O3使反应活化能明显降低,是合成乙酸戊酯的有效催化剂。     

去甲氨噻肟酸乙酯合成研究

去甲氨噻肟酸乙酯是半合成头孢菌素药物的重要中间体之一.报道了在环合反应中,采用甲醇和水(体积比为1∶1)的混合溶剂代替二氯甲烷,甲醇等单一溶剂,反应温度在25℃左右下进行,收率明显提高,可达56.2%,结果令人满意.产品结构用1HNMR验证.     

HPLC测定复方氯己定甲硝唑栓中醋酸氯己定、甲硝唑的含量

建立复方氯己定甲硝唑栓中主要成分醋酸氯己定、甲硝唑含量的高效液相色谱测定方法。色谱柱为大连依利特公司HypersilC18柱(20cm×4.6mm,10μm);醋酸盐缓冲溶液(取醋酸铵80g、辛烷磺酸钠2g加水800mL溶解后,用冰醋酸调节pH值至4.2,加水至1000mL)—甲醇(40∶60)为流动相;检测波长:甲硝唑315nm,醋酸氯己定260nm。醋酸氯己定、甲硝唑的回收率分别为99.27%、99.40%,RSD分别为0.57%、0.55%(n=9)。该方法简便,结果准确可靠。     

铌酸催化合成乙酸苯乙酯

将铌酸用于催化合成乙酸苯乙酯 ,在醇酸摩尔比 1∶5 ,回流反应 2h ,催化剂用量 (以 1mol醇计 )为 5g的条件下 ,酯收率可达 84 .3%以上。催化剂不经处理 ,可多次循环使用 ,不污染环境 ,相对于一些其他催化剂 ,具有明显的优点。