Analysis of thermodynamics and kinetics of titanium between top slag and liquid steel

Titanium is an impurity element in some special steel grades.The existence of titanium decreases the grain size and lowers the yield strength,resulting in low quality of these steels with regard to various properties.Thus,the titanium content should be reduced to the minimum.Based on the industrial production of ultra-low carbon Al-Si killed steel,this paper investigated the physical-chemical behaviors of titanium with and without desulfurization during RH refining.The influences of Ti content in hot metal,ladle slag composition,and ladle slag quantity,etc.,on the Ti content in refined liquid steel were discussed.The results show that the partition ratio of titanium between ladle slag and liquid steel is inversely proportional to the Al content to the power of 4/3,and the empirical formula regressed from practical experience can be expressed as w(TiO2)/w[Ti]=48/w[Al]4/3.Maximum partition ratio of titanium between top slag and liquid steel can be ensured by an optimum slag composition including components of FeOx and Al2O3 and an appropriate slag basicity.The contents of FetO and Al2O3 should be controlled above 6% and below 20% respectively and the slag basicity should be kept within 1.5 to 3.0.Moreover,desulfurization refining in the RH vacuum will decrease the partition ratio of titanium between ladle slag and liquid steel significantly.To keep the Ti content stably below 15×10-4% in a 300 ton ladle,the Ti content in hot metal must be lower than 500×10-4% and the thickness of ladle slag carried over from BOF slag must be less than 50 mm.     

高压溶出稀释槽乏气利用的改进措施

本通过对高压溶出稀释槽产生乏汽的原因进行分析，同时也对目前乏汽利用中存在的不足提出了改进措施，通过改进可以节约大量的蒸汽，降低消耗费用，改善现场操作环境，对进一步提产降耗和改善环境状况都会起到积极的作用。     

梅山高炉瓦斯泥综合利用的研究

分析研究国内外高炉粉尘使用情况，结合梅山高炉瓦斯泥的性质、特征和现状，提出用弱磁-强磁选的选矿方法，从梅山高炉瓦斯泥中回收铁精矿的设想。通过试验室试验，取得了较好的技术经济指标，达到了预期效果，并可降低锌含量。     

倾斜管中气－液两相流摩擦压降的研究

本文对倾斜管中气一液两相流摩擦压降进行了试验研究。试验参数为：系统压力０～０．６ＭＰａ，水流量０～４ｍ３／ｈ，空气流量０～４０ｍ３／ｈ。得到了计算倾斜管摩擦阻力的计算公式，所得计算结果与试验结果符合良好。     

Experimental study on mercury content in flue gas of coal-fired units based on laser-induced breakdown spectroscopy

Accurate measurement of trace heavy metal mercury(Hg) in flue gas of coal-fired units is great significance for ecological and environmental protection.Mixed gas was used to simulate the actual flue gas of a power plant in this study.A laser-induced breakdown spectroscopy(LIBS)system for Hg measurement in mixed gas was built to study the effect of mixed gas pressure,Hg concentration in mixed gas and delay time on Hg measurement.The experimental results show that the appropriate low mixed gas pressure can obtain high Hg signal intensity and signal to noise ratio.The Hg signal intensity and signal to noise ratio increased with the increase of Hg concentration in mixed gas.The Hg signal intensity and signal to noise ratio decreased with the increase in delay time.According to the above results,the optimized measurement conditions can be determined.Different Hg concentrations in mixed gas were quantitatively analyzed by the internal standard method and traditional calibration method respectively.The relative error of prediction of the test sample obtained by the internal standard method was within 11.11%.The relative error of prediction of the traditional calibration method was less than 14.54%.This proved that the internal standard method can improve the accuracy of quantitative analysis of Hg concentration in flue gas using LIBS.     

Two-Parameter Thermal Lattice BGK Model with a Controllable Prandtl Number

In this paper, two time relaxation parameters are introduce to a thermal lattice BGK, model to make its Prandtl number controllable. The dependency of the Prandtl number on the two parameters is derived. Numerical measurement of the transport coefficients is used to demonstrate the validity of the method. Furthermore, two examples of convective heat transfer are calculated, with one to show the effectiveness, and the other to show the breakdown of the two-parameter formulation under different conditions.     

Pt掺杂SnO2花状纳米结构的合成及其气敏性能的研究

用原位掺杂法制备了Pt/SnO2花状纳米结构.通过控制反应源物中n(Pt4+)/n(Sn4+)比率,可以获得不同Pt掺杂量的复合纳米结构.采用SEM、XRD、TEM和Raman光谱对样品的形貌、结构等进行了分析,并测试了材料的NH3气体敏感性能.结果表明,Pt掺杂的SnO2纳米花大小约为2μm,由平均直径为180nm,...     

有机硅膜分离润滑油中脱蜡溶剂的机理研究

利用气相色谱法,在348．15～368．15K温度,测定了正己烷、正庚烷、正癸烷、甲苯和丁酮溶剂在有机硅膜中的无限稀释扩散系数,结合Vrentas-Duda自由体积模型计算得到溶剂／有机硅膜体系溶剂有限浓度扩散系数,在理论上预测了不同溶剂在有机硅膜中扩散特性对膜分离性能的影响,在实验和理论两个方面,为进一步研究有机硅膜分离机理打下了基础．     

工业炸药有毒气体含量测定的影响因素

文章探讨了工业炸药爆炸后有毒气体测定过程中多种因素对测定结果的影响。试验表明,钢炮扩孔对有毒气体测定结果影响明显,随钢炮扩孔增大,有毒气体含量显著增大。当扩孔率为37%和95%时,有毒气体总量比新钢炮分别增大了24.5%和29.2%。起爆用雷管对低感度炸药有毒气体测定结果影响较显著,而对高感度炸药影响较小;用军用雷管起爆产生的有毒气体最少,而用煤矿许用瞬发电雷管起爆产生的有毒气体最多,并且膨化硝铵炸药有毒气体的增加(23.0%)大于粉状乳化炸药(10.8%)。石英砂用量对有毒气体测定结果也有明显影响。当石英砂完全覆盖药卷时,在一定范围内,增加石英砂用量导致有毒气体含量增大;当钢炮扩孔相当大时,增大石英砂用量使钢炮口全部覆盖严实,有毒气体含量减少。     

液化天然气装置的类型与液化工艺

论述了液化天然气装置的类型,分析了天然气液化工艺的特点,展望了液化天然气在我国的应用。