机械合金化Zr-Al-Ni-Cu-Ag非晶合金的晶化行为

研究了机械合金化非晶态Zr65Al7.5Ni10Cu7.5Ag10合金的晶化过程，由于存在扩散不均匀区，机械合金化非晶合金在深过冷液相区的退火组织不同于快淬合金，在深过冷液相区退火，析出二十面体准晶相及一些知相：在靠近第一个放热峰的温度退火，近出Zr2Cu相：第二个放热峰对应残余非晶相及准晶相向Zr2Ni,Zr2-Al3的转变。     

非晶Sm5Fe74.3Nb1.5Si11.7B4.5C2.5Cu0.5合金经预退火后的晶化动力学的DTA研究

研究了非晶Sm5Fe74.3Nb1.5Si11.7B4.5C2.5Cu0.5合金经400℃，保温10min预退火后的晶化动力学。结果表明；该合金的晶化相为α-Fe固溶体和Sm2Fe17Cx金属间化合物，两相的晶化表观激活能分别为557KJ/mol和514KJ/mol，当晶化体积分数为60%时，α-Fe相的晶化激活能达极大值；Sm2Fe17Cx相晶化激活能则随其晶化体积分数的增加而逐渐减小。     

Homogeneous Plastic Flow of Fully Amorphous and Partially Crystallized Zr_(41.2)Ti_(13.8)Cu_(12.5)Ni_(10)Be_(22.5) Bulk Metallic Glass

The homogeneous plastic flow of fully amorphous and partially crystallized Zr(41.2)Ti(13.8)Cu(12.5)Ni(10)Be(22.5) bulk metallic glass (Vitl) has been investigated by compression tests at high temperatures in supercooled liquid region. Experimental results show that at sufficiently low strain rates, the supercooled liquid of the fully amorphous alloy reveals Newtonian flow with a linear relationship between the flow stress and strain rate. As the strain rate is increased, a transition from linear Newtonian to nonlinear flow is detected, which can be explained by the transition state theory. Over the entire strain rate interval investigated, however, only nonlinear flow is present in the partially crystallized alloy, and the flow stress for each strain rate is much higher. It is found that the strain rate-stress relationship for the partially crystaltized alloy at the given temperature of 646 K also obeys the sinh law derived from the transition state theory, similar to that of the initial homogeneous amo     

低k氟化非晶碳层间介质对芯片性能的影响

讨论了通过合理设计的工艺流程将低k氟化非晶碳材料应用到制造工艺中作为互连介质对集成电路性能的影响。基于一个互连结构简化模型计算出采用低k氟化非晶碳材料作为互连介质后RC延迟、功率耗散和线间串扰的变化情况。采用低k氟化非晶碳介质后,RC延迟和功率耗散随着互连长度的增大而减小,线间串扰也得到显著抑制。     

Changes in the thermomechanical behavior of epoxy glasses under the state of strain aging

Changes in thermomechanical behavior with structural relaxation taking place in epoxy glasses were studied. Differential scanning calorimetry measurements and thermostimulated strain recovery tests were performed for specimens deformed and then aged under fixed strain. In the course of heating, the specimens started to absorb thermal energy, whereas plastic strain was still stable. At higher temperatures, plastic strain started recovery, which was accompanied by exothermic behavior of the specimen. With an increase in the aging duration, the endothermic peak signified and moved to a higher temperature. These results indicated that the longer the aging duration was, the harder the plastic strain and strain energy were frozen in the glassy structure. This freeze‐strain phenomenon was observed for crosslinked epoxy glass, as well as polymeric glasses with linear molecular structures, aged under strain. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Steady-state and transient photoconductivity in hydrogenated amorphous silicon nitride films

Amorphous SiN_x:H films were prepared by the rf glow-discharge decomposition of ammonia/silane gas mixture with varying nitrogen content. The steady-state photoconductivity and its dependence on light intensity have been investigated in a-SiN_x:H as a function of temperature between 100 and 420 K. The electron drift mobility of a set of SiN_x:H samples has been determined from their steady-state photoconductivity and response time measurements. The results suggest that electron drift mobility of the samples was nearly unchanged for a low nitrogen content. Two samples containing lowest nitrogen showed higher photoconductivity than that of unalloyed sample within a temperature range including the room temperature.     

Estimating thermal stress in BIPV modules

The thermal stress on building‐integrated photovoltaic modules (BIPV) in Espoo, Finland, was studied with field‐testing of amorphous silicon modules. Based on these results, the thermal stress at two other European locations (Paris and Lisbon) was estimated. The estimation procedure entailed thermal modelling of heat transfer in the façade with meteorological data as input. The results indicate that the thermal stress on BIPV modules in Lisbon is, in this case, approximately 50% higher that in Espoo and between 80 and 200% higher than in Paris, depending on the activation energy of the degradation process. The difference in stress between a BIPV module and a free‐standing module in Espoo was 50–200%. Copyright © 2006 John Wiley & Sons, Ltd.     

Influence of zero-loss filtering on electron optical phase contrast

Complex scattering amplitudes are used to calculate the phase contrast of colloidal gold particles. Comparison of measurements of the phase contrast intensity at the centre of the gold particle as a function of defocus for unfiltered and zero-loss filtered images demonstrates the increase in phase contrast achieved by zero-loss filtering even for a thick carbon substrate film. The granulation of amorphous germanium films is measured by the spatial rms (root mean square) values of image intensity in a defocus series.     

Cast bulk ZrTiAlCuNi amorphous alloys

Cylindrical bulk amorphous samples with diameters up to 10 mm have been prepared by casting ZrTiAlCuNi alloys in a copper mould. In order to rank glass-forming ability as a function of alloy composition, alloys were also cast into wedge-shaped moulds; to a first approximation, the thickness of the amorphous region obtained can be taken as an indication of glass-forming ability. The compositions which lead to the production of bulk glasses all have reduced glass transition temperatures in excess of 0.65 and the extremely high glass-forming ability of these compositions is discussed. We suggest that both the Al and Ti contents are determining factors for the production of bulk amorphous samples and these are believed to reduce the driving force for, and hence the rate of, crystallisation. These amorphous alloys have been found to display high thermal stability and can be annealed for several minutes in the supercooled liquid region. They are ductile at room temperature and have a high value of yield stress.     

中高频小功率电子元器件用非晶材料的开发与应用

随着电力和电子技术的飞速发展，相应的元器件向高频化，小型化，高效率和节能的方向发展，从而对元器件用材料也提出了更高要求。为此，本文概述了冶金部钢铁研究总院近年来所研究的用于开关电源，脉冲变压器，传感器，电流互感器和电感器等方面的非晶软磁合金的性能及其应用概况。