生物除铬(VI)效果及机理探讨

以特定污泥挂膜的自制厌氧生物滤床系统具有良好的去铬(VI)能力。恒流泵最佳流量为47mL/min,外加碳源使废水COD约140mg/L,铬(VI)的浓度由60mg/L左右降到0.5mg/L以下(一级排放标准),需要4h,而对照组(未加碳源)需要14h。铬(VI)浓度由64.66mg/L提高到75.53mg/L时,对系统负面影响甚微,提高到95.47mg/L时,系统出水达标所需时间延长到7.5h。添加微量金属离子与未添加微量金属离子的情况相比,处理效率提高21.26%。分析试验表明:铬(VI)的去除途径可能是由生物还原作用将六价铬还原为三价铬,形成氢氧化铬沉积于微生物表面。     

TNT-RDX混合废水处理的实验研究——生物-吸附法

介绍了在２５￣３５℃的温度下，用厌氧－兼氧－水生生物－吸附组合工艺处理ＴＮＴ和ＲＤＸ混合废水的方法，进行了日处理量为６０￣９００Ｌ的实验室放大实验。当ＴＮＴ和ＲＤＸ混合废水总浓度为４￣１２ｍｇ／Ｌ时，经过该工艺处理后可达到国家排放标准。其中厌氧－兼氧能去除废水中８０％以上的ＴＮＴ和ＲＤＸ，水生生物（水葫芦）对ＴＮＴ及ＲＤＸ也有一定的降解效果，最后用活性炭吸附可以实现深度处理。     

Stimulatory effects of tannins and cholic acid on tryptic hydrolysis of proteins: Ecological implications

The biochemical basis for considering tannins as digestion inhibitors has been reexamined. Both stimulatory and inhibitory effects of tannins on tryptic hydrolysis are reported. We show how stimulation may result from tannin-induced structural changes in the substrate protein, effectively denaturing it. The surfactant and bile constituent cholic acid also produced similar stimulatory effects. These results have considerable implications for normal digestive physiology as well as for the impact of tannins on argicultural and natural herbivore populations.     

油田采出水的高温水解-好氧处理工艺研究

根据油田采出水的水质特征，采用厌氧(水解)-好氧(接触氧化)处理工艺。实验表明，虽然油田采出水的BOD5／CODCr，较低，属于难生物降解废水，但是当温度为50～60℃时，选择厌氧停留时间为6h，好氧停留时间为3．5h，气水比为10～20，可使其出水的CODCr稳定在120mg／L左右。如果排除Cl^-产生的影响，CODCr，约为60～70mg／L，达到GB8978-1996一级排放标准。     

Municipal solid waste conversion to energy

In recent years it has been recognised by an increasing number of nations that there is considerable energy potential within MSW. As a result many countries have established R,D& D programmes to examine methods of exploiting this potential. The IEA's MSW Conversion Activity was set up in 1986 to provide an infrastructure for sharing information and co-ordinating work in this area internationally. This Activity was extended in 1989 and currently a total of 9 nations participate in it.

To cope with the wide scope of the area (encompassing both biological and thermal processing of MSW) the Activity was divided into three subgroups or Expert Working Groups (EWGs). Each of these dealt with a distinct area of expertise:

1. •Downstream effects of source separation and screening of MSW

2. •Sampling and analytical protocols

3. •Landfill gas

In addition to these groups a central secretariat based at Harwell (UK) has provided guidance, established and administered databases of contacts and produced a series of national reports.

This paper describes the achievements of the Activity and discusses work proposed for the future.     

Fluorine analysis of nuclear waste glasses

A method for analyzing the fluorine content of glass using a microwave oven to digest the glass is presented. Analysis time and secondary waste generation are reduced using this method, without sacrificing accuracy.     

厌氧胶快速渗补技术在汽车发动机上的应用

将金属铜易与过氧化物发生氧化还原反应生成游离基的原理应用于厌氧胶，开发了针时金属零件表面微孔进行局部渗补的实用技术。在相关技术可靠性和工艺可行性得以论证的前提下。将局部渗补技术成功地应用于渗补发动机泄漏缸盖，减少了废品损失，取得了良好的经济效益。     

酸溶性钛渣酸解工艺研究

针对攀枝花钛铁矿冶炼钛渣的物化性质，对影响钛渣酸解率和钛液指标的各个因素进行了全面系统的实验室研究，并在年产2000t钛白生产线上进行了工业验证和优化试验，酸解率稳定在93％以上，三价钛控制在1－3g/L，钛液浓度较钛矿酸解提高了40－50g/L，其它钛液指标达到了后续水解工艺的要求。     

新型废水厌氧处理工艺——内循环厌氧反应器

介绍内循环(IC)厌氧反应器的发展、基本结构、运行机理。分析该反应器的工艺过程,指出该工艺具有处理效率高、抗冲击能力强等优点。针对IC反应器存在的缺陷,人们对该反应器进行技术改进:通过提高它的内循环的气量进行处理低浓度有机废水;增加外循环装置缩短IC反应器的启动周期。     

气浮池──稳定塘处理造纸废水

叙述了用气浮地→厌氧塘→兼性塘处理造纸废水的试验与设计。经运行后测定，出水达到了天津市水污染物排放标准的要求。气浮池采用３０％的回流比，提高了处理效率，每天可回收纸板原料８．４～１０．８ｔ。