硫酸盐浆厂污水处理工程及单元技术特点

本文简略介绍云南某硫酸盐浆厂污水处理工程采用的国内不多见的污水单元技术，并对其先进性和实用性效果进行评价和探讨。     

Acidogenic fermentation of blended food‐waste in combination with primary sludge for the production of volatile fatty acids

The performance of a laboratory‐scale anaerobic acidogenic fermenter fed with a mixture of blended kitchen food‐waste and primary sludge from a sewage treatment plant was investigated for the production of volatile fatty acids (VFA). The operating variables for acidogenic fermentation were kitchen food‐waste content (10 and 25 wt %), hydraulic retention time (HRT: 1, 3 and 5 days), temperature (ambient: 18 ± 2 °C, and mesophilic: 35 ± 2 °C) and pH (varied from 5.2 to 6.7). The experimental results indicated that effluent VFA concentrations and VFA production rates were higher at ambient temperature than at mesophilic conditions. The net amount of VFA with 10 wt % food‐waste increased up to 920 mg dm^?3 with an increase of HRT, but contrasting results (a decrease of 2610 mg dm^?3) were found due to the conversion of VFA into biogas in the case of 25 wt % food‐waste, which increased significantly at HRT of 3–5 days. In terms of biogas composition (CO₂ and CH₄), the organic matter was converted into CO₂ through the oxidative pathway by facultative species at low temperature while mesophilic temperature and optimum pH (6.3–7.8) played a pivotal role in increasing rate of conversion of VFA into biogas by methanogenesis. Rates of VFA production and their conversion are dependent on the food‐waste content in the mixture. Yet, the higher concentration of food‐waste (25% compared with 10%) did not produce VFA proportionally due to the increased rate of conversion of VFA into gaseous products. The maximum VFA production rate (0.318 g VFA_produced g^?1 VS_fed day^?1) was achieved in the 10 wt % food‐waste at ambient temperature and at a 5‐day HRT. Copyright © 2005 Society of Chemical Industry     

储罐负压排泥技术

油田每年都有大量的储罐需要进行清罐排泥作业,通过对几种常用排泥方法的比较,认为负压排泥装置具有安装简单,操作方便,排泥效率高,排泥费用低等特点,文章详细介绍了储罐负压排泥装置的结构、原理以及安装与操作方法,并提出负压排泥装置使用的注意事项。     

Physicochemical characteristics and leachability of scale and sludge from Bulalo geothermal system, Philippines

Scale and sludge from Bulalo geothermal field, Philippines, have been characterized by whole rock analysis, radioactivity counting, size analysis, light microscopy, scanning electron microscopy, and X-ray diffraction. Their leachability was assessed by regulatory leaching procedures and by sequential extraction. Both scale and sludge consisted mostly of oxides of Si, Al, and Fe with no radionuclides detected. The scale had 10% S content. Sulfides and silicates were important phases in both samples having size ranges from submicron to 2 mm. Geothermal soils at Bulalo have higher than normal soil levels of As, S, Cu, Cr, Zn, and Pb but regulatory leaching tests indicated that these elements are not released. However, the sequential extraction showed that As, Cu, and Zn were leachable under extreme conditions.     

SBR工艺污泥膨胀的纠正方法

在对国内外有关资料的研究基础上，介绍了几种应对SBR反应池内污泥膨胀的措施。着重叙述了氯化法和无机合成絮凝剂法的应用注意点及如何定量运用这两种方法，同时给出了相应的工程实例。     

二氧化氯处理油田回注水工艺

针对中原油田回注水中细菌易产生抗药性,难以控制的问题,提出了应用二氧化氯处理油田回注水工艺。经室内评价及现场试验,二氧化氯可杀死回注水中的细菌,控制微生物生长,同时该工艺可降低现有回注水污泥残渣产出量的50%,减少污泥对环境的污染,提高注水水质。     

含油污泥焦化处理实验研究

采用焦化方法对含油污泥进行处理。经过筛选选取活性白土作为焦化处理催化剂,分别研究了反应时间、反应温度、氮气吹扫量、加热速率等因素对处理效果的影响。4个影响因素对液相油品收率的影响顺序为:氮气吹扫量>反应温度>反应时间>加热速率;对反应转化率的影响顺序为:反应温度>反应时间>氮气吹扫量>加热速率。较为理想的反应参数:反应温度490℃;反应时间60min;氮气吹扫量90mL.min-1;加热速率4℃.min-1。在此反应条件下,含油污泥液相油品收率>80%,反应转化率>99.9%,经焦化处理后的废渣含油率<3‰,达到农用污泥排放标准,实现了达标排放和回收资源的目的。     

活性污泥生物相对污水处理运行的指导作用

污水处理系统处理效果的好坏都与污水处理系统中组成活性污泥的微生物种类、数量及其代谢活力有关,本文从活性污泥结构、微生物种类、数量及活性等方面分析了污泥生物相与运行状态的相互关系.说明了可通过对污水处理系统的生物相观察了解处理效果及运行状况,也可通过对污泥生物相观察发现处理系统环境的变化,及时调整运行环境,预防污水处理系统的运行中的异常情况发生.     

Zeolite synthesis from paper sludge ash with addition of diatomite

BACKGROUND: This study aimed to investigate the synthesis of zeolites from paper sludge ash (PSA) with added diatomite to remove both NH₄⁺ and PO₄^3? for water purification. The PSA had low Si and significant Ca contents. Four types of diatomite: white (T‐W) and brown (T‐B) from deposits of marine origin in Takanosu, and white (S‐W) and gray (S‐G) from lacustrine deposits in Shonai, were added to NaOH solution to increase the Si content and thereby synthesize zeolites with high cation exchange capacity (CEC). RESULTS: The order of the amounts of Si extracted from the diatomite to the alkali solution was S‐W > T‐W = T‐B > S‐G, which correlates with the amorphous SiO₂ content of diatomite. The original ash without addition of diatomite yielded hydroxysodalite with CEC of about 1.0 mmol g^?1. For all samples, the addition of diatomite to the solution yielded zeolite‐P with a higher CEC, but the addition of excess Si inhibited the synthesis of zeolite‐P, and the CEC of the product was low. A product with high CEC including zeolite‐P was obtained in a solution with around 500 mmol L^?1 of Si concentration, and had the ability to remove both NH₄⁺ and PO₄^3?. CONCLUSION: Diatomite has the potential for used as an additive for the synthesis of high CEC zeolite from PSA. The product with zeolite‐P exhibited relatively high CEC, capacity for NH₄⁺ uptake, and the ability to remove PO₄^3? by precipitation, which is preferable for water purification applications. Copyright © 2008 Society of Chemical Industry