Voltage reference architectures for low-supply-voltage low-power applications

This paper presents a voltage reference generator architecture and two different realizations of it that have been fabricated within a standard 0.18 μm CMOS technology. The architecture takes the advantage of utilizing a sampled-data amplifier (SDA) to optimize the power consumption. The circuits achieve output voltages on the order of 190 mV with temperature coefficients of 43 ppm/°C and 52.5 ppm/°C over the temperature range of 0 to 120°C without any trimming with a 0.8 V single supply. The power consumptions of the circuits are less then 500 nW while occupying an area of 0.2 mm² and 0.08 mm², respectively.     

An enhanced anti-disturbance attitude control law for flexible spacecrafts subject to multiple disturbances

As well-known disturbance rejection methods, active disturbance rejection control and disturbance observer-based control can effectively improve the control performances of complex systems in the presence of disturbances. However, the accurate rejection of multiple disturbances for control systems of practical engineering, for example, the attitude control system of flexible spacecraft, is still a bottleneck problem. In order to further improve the anti-disturbance capability and reduce the conservativeness, this paper proposes a novel enhanced anti-disturbance control law for the attitude control system of flexible spacecraft by combining active disturbance rejection control and disturbance observer-based control in a unified framework. More specifically, the disturbance from flexible vibration is described by an uncertain exogenous system based on the partially known information including elastic damping ratios and modal frequencies. The disturbance observer-based control is utilized to estimate and thereby reject this disturbance. On the other hand, the other disturbances such as external environmental disturbance and complex model nonlinearity are merged into a equivalent disturbance with bounded derivative, which is compensated by using the active disturbance rejection control law. Stability and robustness analysis are carried out for the disturbance observer and extended state observer. Finally, simulation results of low-earth-orbit flexible satellite are presented to verify the effectiveness of proposed methods.     

Low concentration short time ozonation of rapeseed seeds reduces the stability of the oil and content of some antioxidant components

Ozonation is an innovative way to preserve high quality of seed during storage and it is an alternative to harmful organophosphorus agents. Disclosure of changes in the rapeseed oil under the influence of oxidative action of ozone on the seeds was the aim of the work and is presented for the first time. Two ozone concentrations and different length of ozonation were applied. The changes in tocopherols, phenolics, flavonoids contents, antiradical activity and oxidative stability were examined. The average vitamin E concentration was 33 mg per 100 g of oil before and 31.7 after ozonation of seeds. The average content of phenolic compounds was 14.3 mg of sinapic acid g⁻¹ and 16.9 after the ozone treatment. Changes in the flavonoids content and antioxidant activity were observed too. Ozonation caused a decrease in the vitamin E concentration which resulted also in reducing the quenching of free radicals and reduction of oil induction time.     

A first-principles investigation on mechanical and metallic properties of titanium carbides under pressure

The titanium carbides are potential candidates to achieve both high hardness and refractory property. We carried out a structural search for titanium carbides at three pressures of 0 GPa, 30 GPa and 50 GPa. A phase diagram of the Ti-C system at 0 K was obtained by elucidating formation enthalpies as a function of compositions, and their mechanical and metallic properties of titanium carbides were investigated systematically. We also discussed the relation of titanium concentration to the both mechanical and metallic properties of titanium carbides. It has been found that the average valence electron density and tractility improved at higher concentrations of titanium, while the degree of covalent bonding directionality decreased. To this effect, the hardness of titanium carbide decreases as the content of titanium increases. Our results indicated that the titanium content significantly affected the metallic properties of the Ti-C system.     

智能化中高压变频器实载试验平台的实现

中、高压变频器产量越来越多，但试验手段大多比较落后，一般采用带电机空转的方法。本文介绍了一个高压变频器试验平台，通过该平台可以对电压等级在3kV～10kV、功率在5000kW以下的变频器进行实载试验。     

超高压大容量铝电解电容器的研制

分析了大功率设备用超高压大容量铝电解电容器的特点,通过研制工作电解液、制订制作工艺及零部件设计方案,研制出的超高压大容量铝电解电容器具有损耗角正切小(tgδ为0.25)、承受纹波电流能力强(100 Hz,2.12～27.8 A)及寿命长的特点,耐久性达到85℃,5 000 h。     

低密度微泡沫压井液的研究与应用

吐哈油田部分区块地层压力系数小于0.9,常规水基压井液对储层伤害大,若使用油基压井液成本高,环境污染严重。通过实验优选出了一种低密度水基微泡沫压井液。该压井液具有密度低、泡沫强度高、稳定性好、携砂能力强等优点。现场应用表明,低密度微泡沫压井液稳定时间大于48 h,密度在0.70~0.99 g/cm3之间可调,抗油污染能力强,抗油大于8%,抗温在100℃以上,岩心污染后渗透率恢复值大于80%;并且施工方便,成本低,具有储层保护能力,使用微泡沫压井液的井表皮系数在0.20~2.34之间。     

Chemische Zusammensetzung und Mikrostruktur polymerabgeleiteter Gläser und Keramiken im System Si–C–O. Teil 2: Charakterisierung der Gefügeausbildung mittels hochauflösender Durchstrahlungselektronenmikroskopie und Feinbereichsbeugung

Chemical Composition and Microstructure of Polymer‐Derived Glasses and Ceramics in the Si–C–O System. Part 2: Characterization of microstructure formation by means of high‐resolution transmission electron microscopy and selected area diffraction Liquid or solid silicone resins represent the economically most interesting class of organic precursors for the pyrolytic production of glass and ceramics materials on silicon basis. As dense, dimensionally stable components can be cost‐effectively achieved by admixing reactive filler powders, chemical composition and microstructure development of the polymer‐derived residues must be exactly known during thermal decomposition. Thus, in the present work, glasses and ceramics produced by pyrolysis of the model precursor polymethylsiloxane at temperatures from 525 to 1550 °C are investigated. In part 1, by means of analytical electron microscopy, the bonding state of silicon was determined on a nanometre scale and the phase separation of the metastable Si–C–O matrix into SiO₂, C and SiC was proved. The in‐situ crystallization could be considerably accelerated by adding fine‐grained powder of inert fillers, such as Al₂O₃ or SiC, which permits effective process control. In part 2, the microstructure is characterized by high‐resolution transmission electron microscopy and selected area diffraction. Turbostratic carbon and cubic β‐SiC precipitate as crystallization products. Theses phases are embedded in an amorphous matrix. Inert fillers reduce the crystallization temperature by several hundred °C. In this case, the polymer‐derived Si–C–O material acts as a binding agent between the powder particles. Reaction layer formation does not occur. On the investigated pyrolysis conditions, no crystallization of SiO₂ was observed.     

NSA-500-1型氩弧焊机VD9不同接法对引弧和稳弧的影响

从一起NSA－500－1型氩弧焊机故障，分析其高压脉冲旁路二极管VD9不同接法对引弧、稳弧及设备安全的影响。     

NMOS器件两次沟道注入杂质分布和阈电压计算

分别考虑了深浅两次沟道区注入杂质在氧化扩散过程中对表面浓度的贡献。对两次注入杂质的扩散分别提取了扩散系数的氧化增强系数、氧化衰减系数和有效杂地系数，给出了表面浓度与工艺参数之间的模拟关系式，以峰值浓度为强反型条件计算了开启电压，文章还给出了开启电压、氧化条件、不同注入组合之间的关系式。