Base Pressure Measurements under a Scale Model Stockpile

The ability of a granular bulk material to transmit internal shear stress is a fundamental property that is often overlooked or underestimated, yet it is this ability that allows many observed physical phenomena to occur. One such area that continues to be a focus for numerical, theoreticals and experimental researchers is the pressure that a stockpile of granular material places on the supporting surface. While appearing to be a simple problem, the ability of granular materials to transmit shear stress makes this an extremely complex problem. This article presents high-quality data collected under a 2 m high stockpile and full details of the experimental facilities used in the collection of the data.

The work presented is of significant value, having a much greater scale than previous studies (Jotaki & Moriyama, 1979; Lee & Herington, 1971; Smid & Novosad, 1981), and the deliberate inclusion of a central reclaim channel offers insight into stress changes during gravity reclaim and refilling. The results of this work have shown that the so-called 'M' pressure does exist under larger stockpiles both with and without reclaim hoppers; of more significance is the reemergence of the M pressure upon refilling of an emptied stockpile. This clearly illustrates that the M pressure is a robust and natural pressure distribution for a conical stockpile.     

石墨炉原子吸收测定化探样品中痕量金的研究

采用以王水分解样品,泡沫塑料富集,硫脲解脱,石墨炉原子吸收分光光度计测定微量金。研究了测定时干燥温度和时间的选择,原子化温度和时间的选择,灰化温度和时间的选择,以及王水体积分数对吸附效果等条件对测定结果的影响。该方法检出限为0.2×10-9,经国家一级分析标准样品验证,结果与标准值相符。     

Growth and optical properties of Er,Yb:YAl3(BO3)4 crystal

Single crystal of erbium, ytterbium-codoped yttrium aluminum tetraborate Er,Yb:YAl₃(BO₃)₄(Er,Yb:YAB) has been grown by the flux method. The absorption spectrum in the visible and NIR regions of Er,Yb:YAl₃(BO₃)₄ crystal are measured at room temperature and fluorescence spectrum of Er,Yb:YAl₃(BO₃)₄ crystal are also measured at room temperature, excited by 976 nm laser. Not only the strong NIR emission peaks located at 1548 nm was observed, but also the visible up-conversion luminescence has been found. The specific heat of the Er/Yb:YAB crystal at room temperature is 0.81 J/g °C.     

Development of Measurement Facilities for Analyzing Petroleum Products

The question of developing measurement provisions for the parameters of petroleum products is considered. The main technical features of a KLAN-1 mobile laboratory unit for analyzing petroleum products intended for rapid analysis of fuel and lubricating materials in storage and on sale are provided.     

Molecular dynamics studies of atomic-scale tribological characteristics for different sliding systems

A slider-slab sliding model for hard-to-soft and soft-to-soft sliding systems with abrasive and non-abrasive wear conditions is used to investigate atomic-scale friction. The molecular dynamics simulation uses the Morse potential to calculate interatomic forces between atoms. Separation distance between the slider and the slab is changed to simulate repulsive and attractive interactive force fields exerted on interface between two sliding components. Effects of the interaction potential parameters on the sliding friction are investigated. The relationship of frictional force, normal force and temperature rise of the slider and the slab during sliding are established. Comparison of the hard-to-soft and the soft-to-soft sliding system are carried out and shows different tribological phenomena.     

Atmospheric effects of friction,friction noise and wear with silicon and diamond. Part II. SEM tribometry of silicon in vacuum and hydrogen

Scanning electron microscope (SEM) tribometric data on polycrystalline silicon (poly-Si) vs. poly-Si, Si(100) vs. Si(100) and Si(111) vs. Si(111) interfaces, obtained in Torr and in 0.2 Torr partial pressure of hydrogen gas ( ) from room temperature to 850^°C, were performed under standard and much slower thermal ramping rates. The friction data were analyzed per the methodology described in part I of this paper series. The results indicate a highly beneficial friction- and wear-reducing regime within a relatively narrow thermal region. This desirable region coincides with some chemisorption of excited species of molecular hydrogen just before the mass thermal desorption of surface hydrides. These data represent the tribochemical equivalent of a method routinely used in electronics, whereby deep electron traps (dangling Si bonds) are passivated by baking in molecular hydrogen. The also exerts a moderating influence on the size of the friction noise at all test temperatures. However, the general level of friction beyond the beneficial thermal region is high. In parallel, the general wear rate of Si representative of the entire range of standard thermal ramping in both atmospheric environments is in the extremely high 10^-12m³/(N m) range. Operating strictly in the beneficial, low-friction thermal regime resulted in a several orders-of-magnitude reduction in the wear rate over those measured under standard thermal ramping conditions. Although the results confirm previous findings that Si is not a good material of construction for miniaturized moving mechanical assemblies (e.g., microbearings and gears), there seems to be some limited possibility of gas-phase lubrication of Si micromechanisms with rarefied hydrogen at surface temperatures between 100 and 300^°C. This revised version was published online in July 2006 with corrections to the Cover Date.     

梯度功能材料热弹性应力的分析方法

本文介绍了近年来国外有关梯度功能材料热弹性应力问题的最新研究方法，并对其方法特点进行了评述．     

稀土材料新进展

叙述了稀土材料的新种类以及应用前景，并对国内稀土工业的现状及其存在的问题、国外稀土市场概况进行了综述，同时，展望了我国稀土材料的发展方向。     

Critical State of Granular Materials Based on the Sliding-Rolling Theory

By representing the assembly by a simplified column model, a constitutive theory was recently developed for a two-dimensional assembly of rods. This theory, referred to as the sliding-rolling theory, is extended in this paper to represent the triaxial stress-strain behavior of granular materials. The sliding-rolling theory provides a dilatancy rule and an expression for the slope of the line of zero dilatancy in the stress space. These rules are then combined with triaxial observations to provide a microstructural interpretation of the critical state of granular materials. According to the theory, the slope of the critical state line in the stress space depends on the interparticle friction angle and the degree of contact normal anisotropy. To verify the basic ideas of the sliding-rolling theory, numerical experiments are conducted using the discrete-element method on three-dimensional assemblies of spheres.