Heat Transfer Analysis for Gas-to-Liquids Transportation Through Trans Alaska Pipeline

Gas-to-liquids (GTL) technology involves the conversion of natural gas to liquid hydrocarbons. In this article, theoretical studies have been presented to determine the feasibility of transporting GTL products through the Trans-Alaska Pipeline System (TAPS). To successfully transport GTL through TAPS, heat loss along the route must be carefully determined. This study presents heat transfer and fluid dynamic calculations to evaluate this feasibility. Because of heat loss, the fluid temperature decreases in the direction of flow and this affects the fluid properties, which in turn influence convection coefficient and pumping power requirements. The temperature and heat loss distribution along the pipeline at different locations have been calculated. Fairly good agreement with measured oil temperatures is observed. The powers required to pump crude oil and GTL individually, against various losses have been calculated. Two GTL transportation modes have been considered; one as a pure stream of GTL and the second as a commingled mixture with crude oil. These results show that the pumping power and heat loss for GTL are less than that of the crude oil for the same volumetric flow rate. Therefore, GTL can be transported through TAPS using existing equipment at pump stations.     

32位MIPS微处理器中乘法器的设计和实现

在Booth算法的基础上,结合MIPS 4KC微处理器中的流水线结构和乘法器的工作过程,提出了一种改进的Booth乘法器的设计方法,并采用全制定方法实现,用这种方法实现的乘法器单元具有面积小、单元电路可重复性好、版图设计工作量小、功耗低等特点.     

Connecting the second exhaust-heat boiler to the operating first one under the conditions of flow circuits of combined-cycle plants with two gas-turbine units and one steam turbine

Problems arising with connecting the second exhaust-heat boiler to the first exhaust-heat boiler under load in the case of flow circuits of combined-cycle plants of type PGU-450 are considered. Similar problems exist for two-boiler single-turbine units of type PGU-325 and for two-boiler single-turbine units of traditional steampower plants with an output of 200–300 MW upon connection of the second furnace of a two-furnace boiler to the operating first furnace. Analysis of the temperature-induced stressed state and of the cyclic strength of thick-walled elements of the steam-water conduit of PGU-450 and of two-furnace boilers of two-boiler single-turbine units with an output of 200–300 MW (the check valve, the inlet header of the water economizer) is used for determining the steam temperature differences in the high-pressure conduits to the steam turbine and the order of connection of the second exhaust-heat boiler to the operating fist one. Modes of enabling a two-boiler single-turbine unit of a combined-cycle plant, which are most “rigid” from the standpoint of thermal strength, are determined. __________ Translated from élektricheskie Stantsii, No. 2, February 2006, pp. 11–17.     

影响铁精矿K2O、Na2O、SiO2含量的因素分析

用统计分析方法 ,分析了影响精矿K2 O、Na2 O、SiO2 含量的因素 ,并根据分析结论提出了对生产工艺进行定向控制的条件     

美国钢铁企业的并购浪潮及特点分析

介绍了最近美国大型钢铁企业发生的主要并购活动。并对这些并购活动的特点进行了分析。     

Model of Primary Austenite Dendrite Structure in Hypoeutectic Cast Iron

Ｉｔｗａｓｒｅｐｏｒｔｅｄ[1] ｔｈａｔｔｈｅｍｉｃｒｏ ｓｔｅｒｅｏｓｔｒｕｃｔｕｒｅｏｆｐｒｉｍａｒｙａｕｓｔｅｎｉｔｅｉｎｃａｓｔｉｒｏｎｃｏｎｓｉｓｔｓｏｆｐｒｉｍａｒｙｓｔｅｍｓａｎｄｓｅｃｏｎｄａｒｙａｒｍｓｔｈａｔ ｇｒｏｗａｃｃｏｒｄｉｎｇｔｏｄｅｎｄｒｉｔｅｃｒｙｓｔａｌｓｂｒａｎｃｈｒｕｌｅ ,ａｎｄｓｏｍｅｏｆｐｒｉｍａｒｙａｕｓｔｅｎｉｔｅｅｖｅｎｈａｖｅｔｈｉｒｄａｒｍｓ .ＭｉｙａｋｅＨｅｔａｌ[2 ]ｐｒｏｐｏｓｅｄａｃｏｎｃｅｐｔｏｆｒｅｇｉｏｎｍｏｄｅｌｂｙｓｔｕｄｙｉｎｇ…     

输气管道天然气连续取样器的研制及应用

文章针对国内管输天然气气质分析工作中取样环节所存在的问题，结合国外技术发展趋势，全面地介绍了输气管道天然气连续取样器的研制过程。实践证明，该装置较好地解决了天然气密度值偏差问题，满足管输天然气全分析的要求，同时，该装置的推广应用将会提高天然气的计量准确度。     

厚断面球铁的声速

论述了影响厚断面球铁声速和声波衰减的各种因素。指出，必须在应力状态下同时考核声速和声波衰减，以作为判别厚断面球铁材质的一种手段。     

油气集输管道最佳敷设方式的分析

根据大庆油田油气集输工艺设计的实践，分析了几种实用的油气集输管道敷设方式的优缺点。在对不同敷设方式的管道热耗做了较详细计算的基础上，进行了比较，提出了确定油气集输管道的最佳敷设方式：站外管道基本上采用埋地敷设；站内管道则应依据站址处的常年最高地下水位资料来确定，即在保证管道不长期受地下水浸泡的前提下，站内室外管道以埋地敷设为主，室内管道以架空与理地同时敷设为最佳；地下水位高的站内，以架空敷设最佳。     

灰铸铁石墨形态的研究

文本研究了化学成份与冷却速度及孕育处理对灰铸铁石、墨形态的影响．并对形成的地B、C、D、E、F等六种衣铸铁石墨形态的形成条件作了讨论．