在线multicast数据传输网络中的一个优化问题

首先建立了数据传输网络选择的最小成本模型，给出了有效支撑树代表集的概念，并给出了一个时间复杂性为D(mlogen)的算法产生代表集。然后对静态数据传输问题和在线数据传输问题，分别给出了一个时间复杂性为D(mlogen)和O(m^2 mlogen)的多项式时间的算法。     

DC/DC电源中的电磁干扰及其对策

概述了电磁干扰(EMI)和电磁兼容(EMC)的基本知识，对DC／DC电源中的电磁干扰进行了综合分析，并给出了各自的解决方案。     

The Algorithm and Its Application of a Multi-Channel Adaptive Decision-Feedback Equalizer

1　IntroductionOneofthekeyproblemsinhigh speeddigitalradiocommunicationistheInter Symbol Interfer ence (ISI)causedbythemulti pathbetweenthetransmitterandthereceiver.Becauseoftherelativemovementbetweenthereceiverandthetransmitterandthecontinuouschangeoftransmissionmedia,ISIisusuallytime variant.Inthepasttwotothreedecades,abroadstudyofthetype ,structureandadaptivealgorithmofadaptiveequalizershasbeencarriedouttomitigateISI[1～ 7] .Withtheintroductionofadaptiveantennasanddiversityreceptiontec…     

隔河岩水电站大坝廊道排水系统自动化改造

隔河岩水电站大坝廊道排水控制系统存在设备备品、备件不足,技术落后,系统软件工作不稳定等问题,不能按库坝管理要求对排水量进行监控,严重影响廊道排水系统的可靠性。为此,对该系统进行了综合自动化改造,采用TCP6IP通讯,PLC直接上网,异种CPU热备冗余等技术,提高了整个系统的运行可靠性,满足了“无人值班”的要求。     

串行及并行A/D转换器在高速数据采集中的采样差别性分析

串行和并行接口模式是A/D转换器诸多分类中的一种,但却是应用中器件选择的一个重要指标.在同样的转换分辨率及转换速度的前提下,不同的接口方式不但影响了电路结构,更重要的是将在高速数据采集的过程中对采样周期产生较大影响.本文通过12位串行ADC ADS7822和并行ADC ADS774与AT89C51的接口电路,给出二者采样时间的差异性.     

基于FPGA的ASI信号接收与发送的实现

提出了一种用FPGA芯片代替Cypress公司的CY78933和CY78923芯片来实现ASI信号接收与发送的方案，详细阐述了DVB—ASI接口的硬件组成与FPGA实现，该接口符合DVB—ASI的接口规范，可实现270Mbps的信号传输，已经得到实际运用。     

基于FPGA的CAVLC编解码器设计与实现

H．264标准在基本档次和扩展档次中采用CAVLC熵编码，完成对变换系数残差块的编码。提出一种基于FPGA的H．264标准的CAVLC编解码器，程序代码用verilog硬件描述语言编写，并在QuartusⅡ中进行了仿真验证，可以实现对每个残差块数据的编解码并将其按照宏块光栅扫描的顺序输出到存储器，因此适合于嵌入在最终的码流中。仿真结果表明此CAVLC编解码器达到H．264标准中基本档次和扩展档次level3．0的性能要求。     

1/f noise in large-area Hg<Subscript>1−x</Subscript>Cd<Subscript>x</Subscript>Te photodiodes

The 1/f noise in photovoltaic (PV) molecular-beam epitaxy (MBE)-grown Hg_1−xCd_xTe double-layer planar heterostructure (DLPH) large-area detectors is a critical noise component with the potential to limit sensitivity of the cross-track infrared sounder (CrIS) instrument. Therefore, an understanding of the origins and mechanisms of noise currents in these PV detectors is of great importance. Excess low-frequency noise has been measured on a number of 1000-μm-diameter active-area detectors of varying “quality” (i.e., having a wide range of I-V characteristics at 78 K). The 1/f noise was measured as a function of cut-off wavelength under illuminated conditions. For short-wave infrared (SWIR) detectors at 98 K, minimal 1/f noise was measured when the total current was dominated by diffusion with white noise spectral density in the mid-10⁻¹⁵A/Hz^1/2 range. For SWIR detectors dominated by other than diffusion current, the ratio, α, of the noise current in unit bandwidth i_n(f = 1 Hz, V_d = −60 mV, and Δf = 1 Hz) to dark current I_d(V_d = −60 mV) was α_SW-d = i_n/I_d ∼ 1 × 10⁻³. The SWIR detectors measured at 0 mV under illuminated conditions had median α_SW-P = i_n/I_ph ∼ 7 × 10⁻⁶. For mid-wave infrared (MWIR) detectors, α_MW-d = i_n/I_d ∼ 2 × 10⁻⁴, due to tunneling current contributions to the 1/f noise. Measurements on forty-nine 1000-μm-diameter MWIR detectors under illuminated conditions at 98 K and −60 mV bias resulted in α_MW-P = i_n/I_ph = 4.16 ± 1.69 × 10⁻⁶. A significant point to note is that the photo-induced noise spectra are nearly identical at 0 mV and 100 mV reverse bias, with a noise-current-to-photocurrent ratio, α_MW-P, in the mid 10⁻⁶ range. For long-wave infrared (LWIR) detectors measured at 78 K, the ratio, α_LW-d = i_n/I_d ∼ 6 × 10⁻⁶, for the best performers. The majority of the LWIR detectors exhibited α_LW-d on the order of 2 × 10⁻⁵. The photo-induced 1/f noise had α_LW-P = i_n/I_ph ∼ 5 × 10⁻⁶. The value of the noise-current-to-dark-current ratio, α appears to increase with increasing bandgap. It is not clear if this is due to different current mechanisms impacting 1/f noise performance. Measurements on detectors of different bandgaps are needed at temperatures where diffusion current is the dominant current. Excess low-frequency noise measurements made as a function of detector reverse bias indicate 1/f noise may result primarily from the dominant current mechanism at each particular bias. The 1/f noise was not a direct function of the applied bias.     

一种新型的多功能照相胶片影像质量评价方法

本设计了一种新型的多功能照相胶片感光性能和影像质量评价方法。这种方法的主要特点的快速、方便并有满足 实用要求的精确度。该方法仅使用一个测试标板，就可以很容易地测定出照相胶片的感光性能、分辨率、均方根粒度和密度振幅响应（DAR）值等多种表征影像质量的参数。本简要介绍该方法并给出试验结果及其与传统测试方法的比较和讨论意见。     

一种用于TCP/IP减荷的体系结构

TCP/IP减荷的目的是为了将系统主处理器从用于协议处理的繁重的内核中断服务中解脱出来。笔者从对TCP/IP减荷的需求出发,分析了TCP/IP减荷在设计方面的要求,进而提出了一种用于TCP/IP减荷的体系结构。