陕北富县探区天然气藏钻井液屏蔽暂堵技术

陕北富县探区上古生界储层属低孔、低渗的致密储层,下古生界主要储集空间为溶蚀孔洞和裂缝,孔洞多为1～3 mm的小孔,裂缝宽度为0.2～7.0 mm,油气主要聚集在裂缝中.优选出了由复合暂堵剂CXD、憎水性屏蔽剂DYC和表面活性剂ABA组成的屏蔽暂堵配方,其中CXD具有架桥作用并对裂缝性储层有独特暂堵效果,DYC有浊点效应、能在井壁上快速形成阻止滤液侵入的油膜,ABA能减少水锁损害.加入暂堵剂后的钻井完井液,抑制性增强,页岩回收率在90%以上;高温高压滤失量降低,滤饼薄而韧、光滑;岩心静态渗透率恢复值大于90%;滤饼摩阻系数降低.富古6井通过使用该完井液,堵塞比和表皮系数都在轻微污染范围内,井径扩大率比其它井有不同程度的降低,表明优选出的屏蔽暂堵钻井完井液,能很好地保护陕北探区天然气藏.     

Thermomechanical fatigue—damage mechanisms and mechanism-based life prediction methods

An existing extensive database on the isothermal and thermomechanical fatigue behaviour of high-temperature titanium alloy EVII 834 and dispersoid-strengthened aluminum alloy X8019 in SiC particle-reinforced as well as unreinv conditions was used to evaluate both the adaptability of fracture mechanics approaches to TMF and the resulting predictive capabilities of determining material life by crack propagation consideration. Selection of the correct microstructural concepts was emphasised and these concepts were, then adjusted by using data from independent experiments in order to avoid any sort of fitting. It is shown that the cyclic /-integral (δJ_eff concept) is suitable to predict the cyclic lifetime for conditions where the total crack propagation rate is approximately identical to pure fatigue crack growth velocity. In the case that crack propagation is strongly affected by creep, the creep-fatigue damage parameter δ_CF introduced by Riedel can be successfully applied. If environmental effects are very pronounced, the accelerating influence of corrosion on fatigue crack propagation can no longer implicitly be taken into account in the fatigue crack growth law. Instead, a linear combination of the crack growth rate contributions from plain fatigue (determined in vacuum) and from environmental attack is assumed and found to yield a satisfactory prediction, if the relevant corrosion process is taken into account.     

原油沥青质沉积引起储集层损害的室内评价

防止沥青质沉积造成的储集层损害是渤海稠油油藏开发生产中遇到的技术难题之一。结合渤海SZ36-1油田实际情况，使用岩心流动实验装置，建立沥青质沉积导致储集层岩心渗透率下降的室内评价方法，并应用SARA法对稠油发生沥青质沉积的可能性进行预测。评价实验结果表明，损害程度与沥青质沉积量和储集层岩心的原始渗透率有关。沉积量越大，原始渗透率越低，则损害越严重。表5参12     

Experience with Siberian Centralized Dispatch Regulation regarding location determination of damages sustained by intersystem high-voltage transmission lines

A set of measures that can be implemented by the Relay-Protection and Automated-Equipment Service for Centralized Dispatch Regulation (CDR) in Siberia to determine the location of damage sustained by inter-system 550-and 220-kV transmission lines maintained by the United Power System (UPS) of Siberia, and the methodology and technology of damage-location determination (DLD) are described. The damage sustained by the 500-kV high-voltage lines (HL), and the accuracy of DLD relative to zero-sequence emergency parameters are analyzed statically. __________ Translated from élektricheskie Stantsii, No. 5, pp. 59–62, May, 2006.     

双头螺栓失效分析

与汽车电机装配在一起的双头螺栓在拧紧后不久便发生断裂。采用扫描电镜、化学分析、金相检验等方法对失效件进行了检测，同时又进行了氢脆试验验证。结果表明，螺栓在进行表面酸洗及电镀时，氢向金属内部扩散和富集，当氢浓度达到一定临界值后，促使氢致裂纹的产生和扩展。在外应力的作用下，即出现氢脆现象导致螺栓断裂。     

用屏蔽暂堵技术封堵水平井裂缝性漏层

克拉玛依油田HW702水平井的大斜度段和水平段,将穿越纵向裂缝发育的二叠系佳木河组储层。为安全钻进和保护油层,用超细碳酸钙和磺化沥青复配后加入复合离子钻井液中成屏蔽暂堵的堵漏钻井液。室内用岩心试验,屏蔽暂堵后渗透率可降为0,暂堵深度小于3cm,可用酸化和射孔解堵。现场使用效果也很好,使HW702水平井顺利完钻,并获得工业油气流。     

Bridge design with reserve and residual reliability constraints

System reliability is evolving as an important design method for selecting components and topology. It should be used to investigate the original intact structure behavior as well as providing sufficient reserve capacity under likely accident and damage scenarios. Highway bridges are an area of special concern since effort to optimize the cost of construction may not provide adequate redundant capacity. The paper describes an example in which a typical girder bridge structure is optimized (both size and girder spacing) to achieve target system performance. System reliability constraints are imposed on the behavior of the intact structure under highway loads. Also, residual system reliability constraints are imposed to control safety under specified accident scenarios corresponding to damage and “lost” members due to corrosion, fatigue, fire or accidental collisions. An optimal design framework for controlling safety under all these life cycle situations is thus provided.     

T-stress in orthotropic functionally graded materials: Lekhnitskii and Stroh formalisms

A new interaction integral formulation is developed for evaluating the elastic T-stress for mixed-mode crack problems with arbitrarily oriented straight or curved cracks in orthotropic nonhomogeneous materials. The development includes both the Lekhnitskii and Stroh formalisms. The former is physical and relatively simple, and the latter is mathematically elegant. The gradation of orthotropic material properties is integrated into the element stiffness matrix using a “generalized isoparametric formulation” and (special) graded elements. The specific types of material gradation considered include exponential and hyperbolic-tangent functions, but micromechanics models can also be considered within the scope of the present formulation. This paper investigates several fracture problems to validate the proposed method and also provides numerical solutions, which can be used as benchmark results (e.g. investigation of fracture specimens). The accuracy of results is verified by comparison with analytical solutions.     

基于改进PSO算法的结构损伤检测

结构的损伤检测常转化为求解约束优化问题,针对粒子群算法容易出现早熟问题,增大算法后期的粒子位置的改变量,从而增加粒子位置的差异,因而能够增强其在求解约束优化问题时抵抗局部极小的能力。两层刚架单损伤和多损伤识别的数值结果和收敛曲线表明了改进后的粒子群算法优于传统的带惯性因子的粒子群算法。三层框架结构的4种损伤工况的试验研究进一步说明了该算法应用于结构损伤检测领域的有效性。     

钢筋混凝土结构正截面强度计算理论的应用

简述了钢筋混凝土正截面强度计算理论的发展历程，介绍了其计算理论的特点及其存在的问题，并对今后需要进一步研究的问题进行了展望，为工程设计提供参考。