料浆法磷铵工艺的历史和近期技术进展

简单回顾“中和料浆浓缩法磷铵工艺”在我国的发展历史和现状 ,着重介绍该工艺与采用传统“磷酸浓缩工艺”的大型进口磷铵装置实现“联产”,促进、优化后者的生产和经营的科技创意和实践 ,展望该工艺最新技术进展的推广应用前景     

Color and COD retention by nanofiltration membranes

In the present study the application of the nanofiltration process was investigated mainly in the retention ofcolor and chemical oxygen demand (COD) present in textile industry wastewater. Nanofiltration experiments were carried out in a pilot unit, operating in crossflow. Three different types of spiral wound membranes, DK 1073, NF 45 and MPS 31 were used simultaneously in the same unit. The results of the tests showed that for color retention, the values were around 99% for the DK 1073 and NF 45 membranes and the 87% for COD retention for the DK 1073. The permeate flux for the different wastewaters varied from 30.5 to 70 L/h.m². Fouling was observed in all membranes due to the accumulation of molecular species close to the filtering surface. The process was efficient and promising for the reuse of wastewater from this type of industry.     

Different effects of tri(acryloyloxyethyl) phosphate on the thermal degradation of photopolymerized epoxy acrylate and polyurethane acrylate films

Tri(acryloyloxyethyl) phosphate (TAEP) was blended in different ratios with epoxy acrylate EB600 and polyurethane acrylate EB270 to obtain a series of UV curable flame retardant resins. The thermal degradation mechanisms of their cured films in air were studied by thermogravimetric analysis, in situ Fourier‐transform infrared spectroscopy, and direct pyrolysis/mass spectrometry measurements. The results showed that the phosphate group in TAEP first degraded to form poly(phosphoric acid) before the degradation of EB600. Then, the formed poly(phosphoric acid) effectively promoted the conversion of EB600 to form char, which prevented the sample from further burning. However, urethane group in EB270 degraded simultaneously with phosphate group in TAEP, leading to not effectively increase the conversion of EB270 to char during the thermal degradation. It was thus found that the addition of TAEP more effectively improved the thermal stability, flame retardance, and the char yield during combustion of EB600 than those of EB270. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 99: 3130–3137, 2006     

云南省硫酸磷肥工业的发展方向

论述近年来云南省硫酸磷肥工业的发展情况及今后的发展方向.到2010年,云南省硫酸产能应控制在12.5 Mt/a左右,约占全国总量的20%;磷肥产能应控制在4.1 Mt/a左右,约占全国总量的25%,其中高浓度磷复肥约占全国总量的35%以上;磷矿产量应控制在20 Mt/a左右,约占全国总量的30%,其中擦洗与浮选磷矿约占70%.     

硫酸铜灭藻影响因素的试验研究

目的通过对硫酸铜灭藻影响因素的试验研究,确定出硫酸铜灭藻的最佳工况条件.方法以叶绿素a法作为检测方法,通过烧杯试验,确定处理含藻水的最佳硫酸铜投加量、接触反应时间、pH等参数.结果硫酸铜最佳投加量为1.5 mg/L;硫酸铜适宜的接触反应时间为8～12 h;pH值6.6左右时,硫酸铜藻类去除率较高,pH值＞9时,藻类去除率显著降低.结论 pH值对硫酸铜灭藻效果的影响较大;温度对硫酸铜灭藻有一定的影响;水中还原物质浓度对硫酸铜灭藻影响较小;藻类浓度不同对硫酸铜灭藻效果有一定的影响.     

盐水中硫酸根的脱除技术

指出了盐水中硫酸根的危害，介绍了盐水生产中脱除硫酸根的主要技术方法。     

Simulation of Fe-Al compounds developed during single superphosphate manufacture

In order to analyse iron phosphate complexes and gel-like phases encountered in the single superphosphate process, experiments were performed with a free-Al, Fe apatite crystal of Durango from Mexico phosphate rock and sulfuric acid. Reaction products were studied by X-ray diffraction and surface analysis methods namely X-ray photoelectron spectroscopy and scanning electron microscopy. Results show that in a free Al, Fe-system, part of the Ca(H₂PO₄ )₂.H₂O (MCPM) forms before precipitation of any CaSO₄(CS) and gel-like phase such H₂SO₄.yH₃PO₄.xH₂O is formed. When iron is added, the precipitation rate of (CS) and (MCPM) increases and Fe₃(H₃O)H₈(PO₄)₆.6H₂O is formed. When Fe and Al are added, a gel-like phase is quickly formed with a molar ratio that changes with time and develops into crystalline compounds. The composition of this gel may be represented as a mixture of two phases: H₂SO₄.yH₃PO₄.xH₂O and a gel containing Al-Fe-Si.     

炭粒床高效工业除尘装置的设计与开发

The new dust removal technical route using the carbon-granular bed filter,packed of carbon particles with appropriate grade derive from an online-process vibration sieve,to replace the traditional baggy filter had been developed successfully for capturing the micro-carbon dusts produced from pulverization of petroleum coke,and the green close loop of carbon materials is thus completed in the combined pulverizing and classifying system and pulverized carbon dust removal process.The high dust removal efficiency greater than 99%,low outlet dust concentration less than 100 mg.m-3,low pressure drop through dust filtration chamber less than 980 Pa,simple and easy design,and flexible and stable operation were achieved also with the carbon-granular bed filter in both bench and industrial scale operations.     

锌-锰合金镀层磷化工艺研究

为进一步提高Zn-M n合金镀层的抗蚀性,采用锌锰系磷化处理Zn-M n合金镀层,研究表明在相同镀层厚度下,Zn-M n合金镀层抗蚀能力是镀锌层的5倍,经磷化后的Zn-M n合金镀层的抗蚀能力是镀锌层的7~8倍。实验结果表明,Zn-M n合金镀层经锌锰系磷化后抗蚀性明显提高。     

磷复肥喷浆造粒“三内”技术研究与开发(一)

介绍磷复肥喷浆造粒“三内”技术 ,该技术集喷浆造粒、分级、返料、破碎为一体在转筒内完成全过程 ,实现机头喷浆机尾出产品 ,粉体在筒内闭式循环造粒新技术