利用Love波特性计算地基动力响应

本文利用Love波弥散特性在频域上对地基出平面振动及扭振问题进行了研究。在计算区域内结构将采用有限单元划分,而在边界上则根据Love 面波特性使用传递边界有限单元。本文同时讨论了不同模态波对结构动力响应的贡献。本文方法也适合于静力分析。     

等温脉冲自由射流压力场动态特性的实验研究

针对冶金工业过程脉冲燃烧及脉冲流技术所进行研究的基础部分,借助于计算机辅助信号分析手段,运用湍流统计理论,对等温脉冲自由射流压力场动态特性进行了系统的实验研究。实验的Re范围为19486～93936,st范围为0～0.057,所对应的射流脉冲频率为0～25Hz。研究结果表明;脉冲射流极大地提高了射流区压力波动水平,任何受气体的动量、热量和质量传递制约的工业过程均可望通过适当地采用脉冲流技术加以强化.     

Frequency response function of magnetic bearings using high-temperature superconductor

A high-temperature superconductor YBa₂Cu₃O_7-x with strong pinning force has allowed stable magnetic suspension with no control to be developed. Two types of superconducting magnetic bearings (SMB) using YBCO and permanent magnet were assembled. The two types are radial and axial. The dynamic stiffness of each SMB as it was cooled down under a magnetic field by liquid nitrogen was measured both radially and axially. As a result, it was found that the spring constants of these SMBs were almost as large as a practically desirable value; however, their damping coefficients were lower than the practical level. These findings are useful as one of the data bases for development of an optimum SMB design to support the weight of rotors in an axial direction.     

Discrete-time adaptive sliding mode power system stabilizer with only input/output measurements

In this paper a discrete-time adaptive sliding mode control method is newly developed and applied to the power system stabilization problem. A controllable canonical form of state space realization is constructed using the parameters identified by the on-line recursive least squares method and the system state is estimated from the input/output measurements and the simple state transformations. The identified parameters and the estimated state are then used by the discrete-time sliding mode control, which is suitable for the digital equipment. The most important advantage of the proposed power system stabilizer (PSS) is that it is able to maintain its regulating performance with a slower sampling period than that of the conventional sliding mode PSS because it is developed in a pure discrete-time domain. Another advantage of the proposed PSS is that it needs neither a mathematical model of the power system nor the full-state measurements because they are identified through on-line identifications. Several computer simulations for the linear power system are performed to verify the performance of the proposed PSS. In the computer simulations for various circumstances which are probable in a power system are considered, such as transitions of the active and reactive powers, change of parameters of the synchronous machine, line-to-ground faults and measurement noise. As a result, a new power system stabilizer which can operate in a wide range of operating conditions and can overcome various disturbances and measurement noises is proposed.     

无端点检测汉语识别算法的实现及改进——动态时间规整和隐马尔可夫统一模型的应用

语音识别算法中，动态时间规整（ＤＴＷ）和隐马尔可夫模型（ＨＭＭ）是最有效的识别算法，并且两者之间有着本质的联系和内在的统一［１］，据此前期工作中，已经建立了ＤＴＷ和ＨＭＭ的统一模型（ＤＨＵＭ）［２、３］。本文对ＤＨＵＭ进行了改进，在ＤＨＵＭ中引进寂静段自环，并根据汉语语音的特点，提出了一种无端点检测的语音识别算法。在识别过程中，该算法无需确定语音信号起止点位置，而是从寂静段开始，直接按帧提取特征（帧长２０ｍｓ，帧间重叠５０％），特征向量由１５阶倒谱系数和帧平均能量组成。实验中，用ＤＨＵＭ实现了该算法，对９９个相似汉语单字的识别测试结果表明：无端点检测的识别正识率为９４．９５％，正识率下降很少，但不作端点检测却降低了算法的复杂程度。为进一步改善识别性能，特征向量采用一种听觉模型特征，识别器具有更好的鲁棒性，识别率会略有提高。     

重金属污染物动态吸附试验及数学模拟

本文采用泥沙动力学中Ｒｏｕｓｅ等人用来研究泥沙浓度沿垂线分布的装置。对泥沙吸附重金属污染物进行了动态模拟。试验分有底泥和无底泥两种情况。研究中发现在Ｒｏｕｓｅ装置的水力、泥沙条件下泥沙吸附重金属污染物达到平衡状态需要６小时以上，由极坐标下的重金属迁移转化数学模型方程，在本文具体试验条件下进行数值求解，计算结果和试验结果合良好，说明数学模型是正确合理的试验是可靠的。计算时依据室内静态试验结果，对动态     

双机械臂协调：以运动学为基础的模型分析与动态补偿控制方法

本文建立了双机械臂协调系统的主从式控制的非结构模型，并针对两臂具有相同特性和不同特性这两种情形作了稳定性分析，提出特性校正的方法，本文还利用内模原理设计出动态补偿器来克服标定约束的不确定性对系统控制品质的影响，最后给出了实验结果。     

Dynamic elastic-plastic behaviour of whipping pipes: experiments and theoretical model

This paper is concerned with the problem of pipe whip, the dynamic response of a high pressure piping system subjected to an end force as the result of a pipe break which releases a jet of fluid from the broken section. Both experimental and theoretical results are presented concerning the dynamic elastic-plastic behaviour of cantilever pipes subjected to a transverse force pulse at the free end. Comparisons between experimental data and theoretical predictions are made for mild-steel pipes with outer diameter-to-thickness ratios of 19.5, 28 and 32. It is demonstrated that, for these geometries, the whipping pipes display three characteristically different responses, viz. elastic, plastic hardening behaviour for thick pipes, elastic, plastic hardening-softening behaviour for moderately thick pipes and elastic, plastic hardening-softening-collapse behaviour for thinner pipes. The experimental data taken from a series of high-speed films are compared with the predictions of the instantaneous shapes of the whipping pipes derived from both a rigid, perfectly-plastic, large deflection, dynamic beam model and a more comprehensive model which incorporates the effects of elasticity and plastic hardening and softening, the details of which are presented in the paper.     

SFTMP——一个实现软件容错的多处理机系统

多版本软件通过设计相异性实现了软件容错。为了对这种方法进行研究，我们的课题实现了一个三版本软件系统，称之为SFTMP（SoftwareFault－TolerantMultiProcessor）。本文描述了SFTMP的硬件结构和软件执行支持环境，该环境包括同步、表决和监控功能、版本间的通讯及故障的恢复和重构。     

柔性机械手系统的动力学方程

本文应用动力学普遍方程,导出了单链柔性机械手系统的动力学方程;并以递推形式分析该方程的求解过程,递推的每一步只须解低维的方程组,因而便于计算.还讨论了多链柔性树状系统动力学方程的求解方案,它与单链柔性机械手系统具有相似性,便于编制程序.