郑411块超稠油试油试采工艺技术应用

郑411块沙三段地层疏松出砂、原油粘度高，属中深层超稠油，常规试油试采方法难以突破出油关，采用APR全通径氮气垫测试、地层与井筒复合防砂、水平井配合直井蒸汽吞吐、氮气泡沫封堵调剖和井筒加热举升稠油等配套工艺技术，取得了较好的效果，为中深层超稠油油藏的开发提供了技术思路。     

非无线电设备的无线电波辐射

介绍了电磁辐射的分类和非无线电辐射造成的各种危害，指出了可能产生电磁辐射的设备，给出了几种特殊情况的辐射值，并结合国际标准和国家标准，分析了电磁干扰的管理现状，最后提出了减少非无线电设备电磁辐的几种方法。     

日本关西宽带实验网印象

本文根据实地考察内容，结合宽带网络技术和业务重点及实施策略，全面介绍了日本关西宽带实验网发展背景，通信与广播电视综合应用实验和Ｂ－ＩＳＤＮ实用化实验的进展以及ＮＴＴ所起作用。文章最后就关西宽带实验网的借鉴意义提出了几方面意见。     

Design and Characterization of the CLIMPAQ,Chamber for Laboratory Investigations of Materials,Pollution and Air Quality*

A test chamber has been developed in order to provide a small and simple emission testing facility capable of testing construction products in a climate where the important climatic parameters such as temperature, ventilation rate and air velocity can be varied independently around typical indoor values. The test chamber CLIMPAQ is made of panes of window glass. Other main surface materials are stainless steel and eloxated aluminium. The chamber has a volume of 50.9 litres and is designed to meet the requirements for quantifying air pollution. In this investigation human subjects acted as air pollution judges, and chemical characterization of the air pollution was carried out. Carpet, linoleum, wall paint and seal- ant were tested simultaneously in the CLIMPAQ and in four other chambers ranging from a full-scale chamber of 28 m³ to a field and laboratory emission cell of 3.5· 10^?5m³. Product ranking is the same in all chambers for the sensory measurements. Emission rates based on sensory measurements differ for all products less than 100 % except for tests in a 3-litre chamber where emission rates were higher. Chemical measurements differ up to approximately 10 times for the same product in different chambers. Deviations appear to be the result of different environmental parameters in the various chambers. Low air concentrations or high specific ventilation rates seem to increase emissions, while differences in air velocities and sink properties may also be the cause of differences in emission rates.     

二流量试井工艺及资料解释分析方法

描述了二流量试井工艺的实现，从常规分析和双对数曲线拟合两上方面，给出了二流量试井的资料解释分析方法，分析认为二流量试井同样可以计算出正常关井测压力恢复（或压力降落）资料所解释的油藏及流体参数。这种试井方法不但可以减少因正常关井测压对产油量和注水量的影响，而且可以减缓因突然关、开井造成的套管变形或损坏。实践证明，该试井技术方法具有较好的经济效益和应用前景。     

Thermal Monitoring of Self-Checking Systems

With the increasing power density in integrated systems resulting from scaling down, the occurrence of field failures due to overheating has considerably increased. Faulty operation can be prevented by on-line temperature monitoring. This paper deals with questions of on-line temperature monitoring in safety-critical systems. First the possible temperature sensors are reviewed and basic principles of self-checking systems including such sensors are detailed, then a new temperature sensor cell with extremely good parameters designed especially for DfTT applications is presented. The basic questions of integrating thermal sensors into self-checking systems are also discussed.     

用于疏通油水井的脉冲放电技术

评价了各种不同的解堵技术，指出冲击波解堵是一种很有发展前途的技术。介绍了液中脉冲放电产生冲击波的基本原理，并由此研制出了一套井下脉冲放电油水井处理设备样机。通过现场试验，表明用冲击波疏通油井能较好地解除油井污染，提高采收率。     

浅谈试验室对混凝土拌合站的质量管理

从水泥、粗细集料、水、外加剂等方面阐述了试验室对拌合站所用原材料的质量控制，论述了试验室对拌合站计量设备的质量管理，并对拌合站混凝土的质量控制、混凝土试件制作等方面进行了介绍，以真正的管理好混凝土拌合站。     

可燃气体检测报警系统的分析和检修

分析可燃气体检测报警系统的组成和检修方法，并列举了根据故障现象进行分析和检修的实例。     

Nondestructive evaluation of pavements using spectral analysis of surface waves in the frequency wave-number domain

The potential of using Spectral analysis of surface waves (SASW) for nondestructive testing of pavement and soil sites has been demonstrated in several publications. The usual SASW field testing and data analysis procedures and the assumption of a single propagation mode yield accurate results when there are no sharp changes in the stiffness of the site with depth. When this is not the case, however, difficulties arise in the interpretation of experimental data due to the participation of more than one mode in the wave field. In an earlier study, the multiple filter/crosscorrelation technique was suggested for analyzing multi-mode SASW signals. This technique, however, may not yield accurate results when propagation modes are closely spaced. A more general method using spectral analysis in the frequency wave-number domain is presented in this paper. Formulas are presented for determining a reasonably small number of surface measurements, and the accuracy of this method in resolving experimental dispersion curves is demonstrated for a pavement site.