有互感和电源的电容耦合电路的量子涨落

通过正则变换和幺正变换的方法研究了有互感和电源存在的情况下的介观电容耦合电路的量子涨落。结果表明电荷和电流的量子涨落与电源无关。当电路元件确定时，如果L1／L2的值很大或很小，耦合对涨落的影响很大。互感从有到无的过程中，回路1中电流的涨落和回路中2中电荷的涨落有明显的变化。换句话说，互感的有无对涨落的大小起着举足轻重的作用。     

火炮身管内表面激光硬化处理的实验研究

提高身管寿命是火炮行业亟待解决的关键技术问题，激光表面改性技术是解决这一问题的有效方法之一。本文在分析激光表面相变硬化性能的基础上，对身管内表面进行了激光硬化处理实验研究，检测了其内表面阳线和阴线的硬化层硬度和深度，对比分析了离焦量和焦深对其内表面硬化层硬度的影响，并对激光相变硬化层金相组织进行了分析。经激光硬化处理后，身管的内表面硬度有明显提高，硬化层较深，且为很细的条状马氏体组织。     

机械力化学作用对低介硅灰石瓷料的相变和相组成的影响

采用X射线衍射仪(XRD)、差热分析(DTA)手段详细研究了由氧化物粉末制备硅灰石陶瓷时,机械力化学作用及后续热处理对硅灰石陶瓷相组成和相变过程的影响,分析了机械力化学在球磨过程中的作用机理主要是细化晶粒、使晶格畸变、晶格缺陷增多、非晶化和诱导低温化学反应。结果表明:高能球磨中的机械力化学作用能够有效地降低硅灰石陶瓷的烧成温度(11160~11220℃)。探明了经高能球磨的样品在烧成过程中的晶相转变规律。瓷料最终的晶相为单一的-硅灰石(高温变体)。     

Analysis of spontaneous electrochemical oscillations by energy distribution technique

Analysis of non-stationary electrochemical oscillations emerges utilization of the techniques allowing an observation of time evolution of their parameters such as instantaneous frequency, amplitude or frequency band. An algorithm of extraction of these parameters can be based on one of linear or quadratic time-frequency representations of oscillations record. In this paper, the authors present representatives of such transformations (Choi-Williams and Cone-shaped) originating from one of the most popular joint time-frequency energy distribution—Wigner-Ville distribution. Short introduction to the mathematics of the topic discussed is provided, then the authors present an example of application in the analysis of current oscillations of copper dissolution process.     

基于子波变换的涡街流量传感器信号分析

长期以来 ,如何提取潜在噪声下的涡街流量信号一直是个问题。流体流速脉动 ,局部阻力 ,随机振动———所有这些因素都给解决这一问题带来难度。文章应用子波变换消噪理论 ,从软件滤波的角度分析了强噪声干扰下的涡街流量信号 ,并提出了单支重构计数方法。分析结果表明 ,这种方法对低流速流量计量效果很好 ,能够有效地扩展量程下限     

射频板条CO_2激光器并联谐振技术的研究

本文利用周期性网络模型计算了射频板条CO2激光器电极的纵向电压分布．探讨了并联谐振技术在板条器件中获得成功运用的原因．提出了利用并联谐振技术进一步提高电压分布均匀性的两个途径．     

改进尿素包装工艺 不断提高产品质量

通过对尿素包装工艺的不断改进，提高了尿素粒度、减少粉尘含量，效果明显。     

发根农杆菌R1000对野葛的遗传转化及其影响因素

初步研究了发根农杆菌R10 0 0对野葛 (Puerarialobata)的遗传转化及其影响因素。结果表明 :经发根农杆菌R10 0 0感染 13d左右可获得毛状根 ,毛状根诱导率及诱导密度分别为 17 9%和 3 9;降低YEB活化液的 pH值 ,或以肌醇 (10 g/L)代替酵母提取成分 ,可明显提高该菌种的致根性 ;叶片预培养 2～ 3d可提前 4d出根     

低品位硼矿的富集加工技术

报道了青海大柴旦地区低品位硼矿富集加工的新工艺，该工艺使硼矿品位30％－35％，B2O3收率大于80％，该工艺路线已工业化。     

Nucleation Mechanism for Bainite

Based on the experimental results that solute-depleted zone was observed in Cu-28Zn-4AI (mass fraction) at 523 K, AG is calculated as a positive according to the thermodynamic criteria for the spinodal decomposition of a ternary systems. So, the solute-depleted zone cannot be formed by spinodal decomposition. Dislocation density required by the formation of solute-depleted zone is estimated greater than 7.89×109 cm-2, according to the segregation of solute atoms around dislocations, which is not consistent with the practical situation for the alloy at 523 K. Associated with the internal friction experimental fact that internal friction peaks appear within the incubation for bainitic transformation in Cu-Zn-AI alloy, the equilibrium temperature, TO, is evaluated as 433 K for solute-depleted Cu-25Zn-3.4AI, which is lower than the experimental temperature 523 K. Thus, nucleation by shear mechanism is impossible in this circumstance. Therefore, it is concluded that, like bainite in steels and Ag-Cd, bainite in