基于压水试验数据的渗透系数应力敏感性研究

岩体渗透率与应力关系是进行岩体渗流应力耦合分析的基础。基于龙滩水电站边坡岩体渗流压水试验结果和边坡岩体岩性及物理力学性质，对岩体渗透系数和地应力进行了分析计算，给出了边坡岩体渗透率随应力变化的关系式，为进行边坡岩体渗流一应力耦合分析提供了可靠数据。     

台缙高速公路苍岭隧道水文地质勘察与涌水量预测

以台缙高速公路苍岭隧道为例，通过水文地质综合勘探方法，查明隧道不同裂隙发育程度岩体的渗透系数K值。然后利用地下水动力学法、地下水径流模数法对隧道开挖涌水量进行了预测。通过施工检验发现，涌水段位置和涌水量总体较接近，说明预测工作对隧道的施工开挖和排水设计具有指导意义。     

新型保温材料—炭化稻壳在连铸生产中的应用效果

对新型保温材料──炭化稻壳的理化指标及其保温性能进行了阐述。在连铸生产中采用炭化稻壳做保温剂可取得显著的经济效益，是理想的保温材料。     

二阶非线性微分方程的一个振动准则

本文给出了二阶非线性微分方程的一个新的振动准则。所得结果改进了若干熟知的振动准则。     

CFRP强度复合Weibull分布的物理特征分析

本文对ＣＦＲＰ材料疲劳后剩余强度的复合Ｗｅｉｂｕｌｌ分布的物理特征进行了初步分析。指出树脂基复合材料失效（破坏）机理的双重性（基体和纤维失效模型）决定了剩余强度（累积损伤程度）测试结果的分布特征。复合Ｗｅｉｂｕｌｌ分布曲线的特征与分析结果对设计、使用及材料研究都有重要参考意义。     

掺气减蚀设施水力计算的改进

结合小湾工程泄洪洞模型试验进行了11种挑跌坎型和6级流量的试验观测，据此提出了特别适用于大单流量条件的射流出射角修正式，提出了射流近底流速的选取原则.与实验资料对比证明本文计算方法有足够精度。     

Corrosion fatigue short crack growth behaviour in a high strength steel

The influence of an aggressive environment (0.6 M, aerated NaCl solution) on short fatigue crack initiation and growth behaviour has been studied. The study involved three major test series, namely: air fatigue, corrosion fatigue, and intermittent air fatigue/corrosion fatigue. The above tests carried out under fully reversed torsional loading conditions at a frequency of 5 Hz, showed that it was the non-metallic inclusions which took part in crack initiation resulting from debonding at metal matrix/inclusion interface and pitting of inclusions in both air and corrosove environments, respectively. Short fatigue crack growth results in these two environments obtained by using plastic replication technique, indicated a large effect of microstructure i.e. prior austenite grain boundaries. The stage/stages at which the environmental contribution was dominant has been discussed by considering the results achieved from intermittent tests. However, the mechanisms involved in corrosion fatigue short crack growth have also been described in the light of results obtained from futher investigations carried out by conducting corrosion fatigue tests under applied cathodic potential conditions and tests on hydrogen pre-charged specimens under air fatigue and uniaxial tension conditions.     

低合金高强度钢的微观组织和疲劳裂纹扩展行为

用透射电镜观察了３０ＣｒＭｎＳｉＮｉ２Ａ钢等温的微观组织，疲劳裂纹扩展行为、裂纹尖端塑性区和位错结构，结果表明，等温状态组织由马氏体和贝氏体组成。在一个奥氏体晶粒内一般存在四个板条领域、裂纹尖端的塑性区内存在主位错带，疲劳断裂的基本组织单元为板条晶或板条束。裂纹遇到板条束界时方向发生较大偏斜。     

直流电动机参数测定

根据直流电机的可逆原理并利用常规的实验仪表，可以简便、准确地测出直流电动机的主要参数－电磁转矩、输出转矩和效率．     

Failure analysis of a wire rope

Wire ropes, pulleys, counterweights, and connecting systems are used for auto tensioning of contact wires of electric railways. A wire rope in one such auto tensioning system suffered premature failure. Failure investigation revealed fatigue cracks initiating at nonmetallic inclusions near the surface of individual wire strands in the rope. The inclusions were identified as Al-Ca-Ti silicates in a large number of stringers, and some oxide and nitride inclusions were also found. The wire used in the rope did not conform to the composition specified for AISI 316 grade steel, nor did it satisfy the minimum tensile strength requirements. Failure of the wire rope was found to be due to fatigue; however, the ultimate fracture of the rope was the result of overload that occurred after fatigue failure had reduced the number of wire strands supporting the load.