Effect of Pressure Gradient on Heat Transfer of Impinging Submerged Circular Jets

An experimental and numerical study have been carried out to investigate the distribution of radial local heat transfer coefficients of impinging submerged circular jets. Good agreement is achieved between the experimental results and the predicted value. Results show that the outer peak usually occurs at the radial location of r/d= 1.8~2.0, in which transition from laminar to turbulence happens resulting from disappeared pressure gradient abruptly, and that the inner peak appears rigidly at r/d=0.5, where the boundary layer has a minimum thickness because of elevating pressure gradient.     

纵横波测井资料在储层评价中的应用

将弹性波基础理论，Gasman理论，Biot理论和实验研究结果相结合，探讨了沉积岩地层中速度和弹性模量，弹性模量和孔隙度，剪切模量和孔隙度，速度和孔隙度，孔隙度和Biot系数之间的关系，利用从各种声学测井资料中提取出的P波和S波时差（或速度）定量评价地层孔隙度和骨架物质，辅以泥质指示测井曲线，可以计算地层孔隙度，饱和度，岩性等参数，在M，Krief方法的基础上，采用优化算法寻求适合于任何岩性地层的孔隙度与Biot系数之间的关系式，提高了Biot系数的计算精度，该评价方法有坚实的实验基础和理论基础，评价结果与实验室岩心分析数据吻合。     

Yield Stress and Microstructure of Set Yogurt Made from High Hydrostatic Pressure-Treated Full Fat Milk

ABSTRACT: Set yogurts were prepared from fortified milk subjected to the following processes: (a) Thermal process (85C,°C,35 min), (b) High hydrostatic pressure process (193 or 676 MPa for 5 or 30 min), and (c) Nonprocessed milk (control). Yogurts from milk treated with 676 MPa for 30 min exhibited similar yield stress and water-holding capacity (WHC) to yogurts from heated milk. Transmission Electron Microscopy (TEM) micrographs exhibited small round casein micelle aggregates without appendages in yogurts from heated milk. Yogurts from milk treated with 193 MPa and untreated milk exhibited low yield stress, low WHC, and large clusters of coalesced micelles. Mechanisms for gel formation are discussed.     

Measurement of Gibbs energies of formation of CoF2 and MnF2 using a new composite dispersed solid electrolyte

Gibbs energies of formation of CoF₂ and MnF₂ have been measured in the temperature range from 700 to 1100 K using Al₂O₃-dispersed CaF₂ solid electrolyte and Ni+NiF₂ as the reference electrode. The dispersed solid electrolyte has higher conductivity than pure CaF₂ thus permitting accurate measurements at lower temperatures. However, to prevent reaction between Al₂O₃ in the solid electrolyte and NiF₂ (or CoF₂) at the electrode, the dispersed solid electrolyte was coated with pure CaF₂, thus creating a composite structure. The free energies of formation of CoF₂ and MnF₂ are (± 1700) J mol⁻¹; {fx37-1} The third law analysis gives the enthalpy of formation of solid CoF₂ as ΔH° (298·15 K) = −672·69 (± 0·1) kJ mol⁻¹, which compares with a value of −671·5 (± 4) kJ mol⁻¹ given in Janaf tables. For solid MnF₂, ΔH°(298·15 K) = − 854·97 (± 0·13) kJ mol⁻¹, which is significantly different from a value of −803·3 kJ mol⁻¹ given in the compilation by Barinet al.     

三峡地下电站变顶高尾水洞水动力特性

在国内首次应用模型水轮发电机组对三峡地下电站变顶高尾水洞方案进行水力过渡过程试验研究。对水轮机导叶实行分段关闭 ,并求出了二段关闭的最佳拐点 ,试验证实了二段关闭对减小尾水管进口的负压和机组转速上升有明显的作用。通过有关水力参数的测试 ,认为变顶高尾水洞可以满足各项技术要求 ,是一个减少山体开挖、节省投资的新型设计方案。在地下电站中具有广泛的应用前景     

淤泥质土状亚粘土的一些特征

珠江三角洲软土地区存在一种灰色亚粘土，其工程性能与淤泥、淤泥质土相似，但两者的物理力学性质却有明显的不同，这是一种在规范土名定义上处于过渡或边缘状态的粘性土，不是严格定义上的淤泥质土，也不是正常沉积的一般粘性土，土的强度和工程性质与淤泥质土类似，应该近沿海地区淤泥和淤泥质土对待，不应看成一般粘性土。     

高压玻璃钢管道的研制及在油田中的应用

本文介绍了高压玻璃钢管道的特性及在我国油田的应用情况。     

气液固三相相平衡热力学模型与计算方法

原油中含有大量的高分子有机固相物质，因此，要准确地描述油气体系相平衡，必须对气液固三相相平衡进行研究，在对高分子有机烃类沥青沉降机理有了一定的认识的基础上，提出了大的交互作用系数，可以描述沥青与原油中轻质不相容性的程度。根据对油气烃类混合物体系的一般性认识与提出的沥青组分特征化方法，导出了与之相应的有其自身特殊性的气液沥青三相相平衡物料平衡方程组，用考虑沥青沉降三相闪蒸数值算法，对沥青沉降进行有效的理化模拟计算，此外，结合实例分析，给出了沥青质参考逸度的计算，饱和压力和沉降量的拟合方法。     

EVOLUTIONARY ALGORITHMS WITH PREFERENCE FOR MANUFACTURING CELLS FORMATION

Due to the combinatorial nature of cell formation problem and the characteristics of multi-objective and multi-constrain, a novel method of evolutionary algorithm with preference is proposed. The analytic hierarchy process （AHP） is adopted to determine scientifically the weights of the sub-objective functions. The satisfaction of constraints is considered as a new objective, the ratio of the population which doesn＇t satisfy all constraints is assigned as the weight of new objective. In addition, the self-adaptation of weights is applied in order to converge more easily towards the feasible domain. Therefore, both features multi-criteria and constrains are dealt with simultaneously. Finally, an example is selected from the literature to evaluate the performance of the proposed approach. The results validate the effectiveness of the proposed method in designing the manufacturing cells.     

Study of impurity induced modifications in amorphous N-type (GeSe3·5)100−x Bi x using high pressure technique

The technique of high pressure is utilized to study the carrier transport behaviour in doped and undoped bulk amorphous (GeSe_3·5)_100−x Bi _x (x=0, 2, 4, 10) down to liquid nitrogen temperature to observe impurity induced modifications in amorphous semiconductors. It is observed that pressure induced effects in lightly doped (2 at % Bi) and heavily doped (x=4, 10) semiconductors are markedly different. Results are discussed in view of the incorporation behaviour of the bismuth impurity.