各向加权异性有限元法在不可压粘性流动计算中的应用

本文利用各向异性张力有限单元，考虑到其独特的性质，提出了一种各向加权异性的算法，即在不同方向采用不同连续性的插值函数，然后再在原连续性较弱的方向以连续性较强的插值函数计算，最后把两次计算的结果加权处理。这种方法可以适应两个方向连续性要求不同或相同的各种情况，即克服了一般各向异性张力有限单元的局限性，又大大减少了存贮量和计算量。     

短模型上的明渠非恒定流试验

水工整体模型试验中,明渠非恒定流至今大多被简化为恒定流,而效果有时并不理想。本文指出,只要设置固定式曲线尾门,并有必要的动态量测设备,便可模拟原型非恒定流;即使模型偏短,也能得出比恒定流试验更接近原型的成果。在同一模型上,既做恒定流试验,又进行必要的非恒定流试验,二者相辅相成,必将有助于试验水平的提高。作为例证,本文介绍了泄洪调度导致航道水面波动的一项试验成果,并以岩基冲刷、通航水流条件、围堰过水、河床冲淤等研究课题为例,讨论了采用“短模型非恒定流试验方式”的必要性与可行性。     

油气两相压降数值试井模型及其典型曲线的规律

提出油气两相流动压降试井数字模型的数值解法，用此解法对均质油藏中油气两相流动试井的规律进行了研究，根据实例计算结果，分析油气两相流下典型压降试井曲线的特征，以及油、气的初始饱和度分布，两相黏度比，饱和度梯度、相对渗透率关系对试井曲线的影响和相应的作用机理，首次发现气体的存在会使油气两相试井的压力导数曲线表现出类似于单相流双重介质试井的压力导数曲线的“下凹”特征。     

连铸铝镇静钢的钢水准备

在连铸生产铝镇静钢时,水口絮流一直是困扰工程技术人员的一个难题.从絮流的原因入手,分析了Al2O3生成的控制.并介绍了几种钢水钙化的方法,从中比较出用复合造渣材料来解决浇铸铝镇静钢的优点.     

Measurement and prediction of pressure drop in two-phase flow

Experimental data for air–water two-phase co-current flow in two different pipe diameters were used to test the prediction of pressure drop by a number of existing theories and correlations. Several models are shown to be useful for prediction, particularly with the stratified regimes which have proved difficult to handle in the past. The model suggested by Olujic proved to be of particular value.     

AN EXPERIMENTAL AND NUMERICAL INVESTIGATION OF THE STARTING FLOW OF A UNIFORMLY ACCELERATING CIRCULAR CYLIINDER

The starting flow around a uniformly accelerated circular cylinder is investigatedby flow visualization techncque and solving N-S equations numerically in detail.The results ofthe starting flow are similar with those of the impulsively started one.At lower Re_α,numbers the“phenomenon a”is revealed;the“phenomenon β”appears at higher Re_α numbers,but withonly one secondary vortex.At the early stage of the starting vortex formation,the flow islaminar;at the later stage,the flow transforms into turbulent flow.The velocity distribution inthe flow field is measured with the multiwires installment.The calculational results are comparedwith the results of experiment,and both are in agreement with each other.     

用试井方法确定注水后地层渗透率的变化

大港油田已进入开发中后期，高含水油田占73％，开发初期的一些参数已不适合现在开发的需要。研究出一套用试井方法确定注水以后地层渗透率变化的方法，对大港油田的增储上产具有重要意义。     

Prediction of liquid–liquid phase diagrams of aqueous salt+PEG systems using a thermodynamic model

In this study a thermodynamic model for the phase behavior of aqueous salt+polymer solutions is developed. The model is based on the solution theory of Hill, which included scaling laws for the polymer molecular mass dependence and Pitzer–Debye–Hückel theory. This model was tested for systems composed of two different molecular mass of polyethylene glycols (PEG) and five different inorganic salts. All the model parameters were determined from independent measurements. The agreement between the experimental and predicted phase diagrams by this model is good.     

Structure and dynamics of dipolar fluids under strong shear

Molecular dynamical simulation has been carried out to investigate the structure and dynamics of a dipolar fluid under strong shear. Dipolar fluid consists of polarizable particles, which have an induced dipole moment in the applied field direction. Shear stress is perpendicular to the field direction. When shear stress is small, the flow has a flowing-chain structure. If shear stress increases to pass a critical value, flowing-chain structure changes to flowing layer structure. Each layer is parallel to the flow direction and shear direction. Within one layer, particles form strings in the flow direction.