Evaporation and Evolution of Suspended Solution Droplets at Atmospheric and Reduced Pressures

Thermal history and solute precipitation behavior of suspended solution droplets of sodium chloride (NaCl), magnesium sulphate (MgSO₄), and zirconium hydroxychloride (ZrO(OH)Cl) evaporating at atmospheric and reduced pressures are studied. Experimental measurements on the variation of droplet diameter, solution concentration, and temperature during the evaporation period are presented and discussed. The results of solute precipitation behavior in solution droplets observed under an optical microscope are displayed and discussed. Results indicate that reducing the pressure (∼ 33 kPa) results in a change in the solution droplet evaporation rate, but the thermal histories of a particular solution droplet are similar at the atmospheric and reduced pressures. At atmospheric and reduced pressures used in this study, the d² law for solution droplets is valid at early stages of the evaporation and before the solute precipitation initiates. Drying of MgSO₄ and ZrO(OH)Cl solution droplets results in the formation of spherical particles, whereas drying of spherical NaCl solution droplets results in the formation of cubic particles.     

变压器和电抗器声级测量方法的对比分析

介绍了变压器、电抗器声级测量方法－－声压法和声强法，并对影响测量结果的各种因素进行了对比分析。     

p,V, T and derived thermodynamic data for toluene,trichloromethane, dichloromethane,acetonitrile, aniline,and n-dodecane

Experimentally determined p,V,T data are reported for toluene, trichloromethane, dichloromethane, acetonitrile, aniline, and n-dodecane at 278, 288, 298, 313, and 323 K, except for dichloromethane, for which the highest temperature was 298 K. At each temperature, measurements were done at pressures up to about 280 MPa or (for aniline and n-dodecane) at a lower pressure slightly below the freezing pressure at the temperature of measurement. Values of the isobaric expansivity isothermal compressibility and (for toluene, trichloromethane, dichloromethane, and acetonitrile) internal pressure, derived from the p,V,T data, are presented.     

进口VPSA制氧装置的流程特点及配置

详细介绍了进口的VPSA制氧装置的流程特点、工艺参数及主要设备的配置。实际运转证明 ,该制氧装置具有运行可靠、启动时间短、部分负荷性能优越、负荷转换速度快等优点 ,能满足金隆铜业有限公司的实际生产要求。     

上海市用电负荷管理系统主站异地冗灾备份方案研究

对上海市用电负荷管理系统主站灾备系统的建设进行可行性研究,根据系统现有结构,结合主流技术提出建议性的方案.重点对各种设备技术进行分析,包括涉及计算机、网络、软件等各方面的设备技术,提出建设原则及实施建议.     

雅克拉凝析气田高压脱水工艺的成功应用

雅克拉凝析气田位于新疆阿克苏境内，2005年11月29日建成投运的260×10⁴m³/d雅克拉集气处理站是目前中石化最大的高压凝析气处理装置。该站的高压分子筛脱水工艺为两塔流程，采用差压再生（吸附压力5.9 MPa、再生压力2.8 MPa）、再生气自动回收工艺技术，并采用时序控制程序自动切换，具有工艺简单可靠、自动化程度高、热能利用率高、脱水露点深度高、操作维护简单、投资较少、运行成本低等优点，自建成投产以来运行稳定，效果十分显著。该工艺装置的成功应用，对类似脱水装置设计、操作具有一定参考价值。     

变压吸附制氧设备真空风机入口压力低分析和处理

介绍了邯钢动力厂真空变压吸附制氧设备的工艺流程,从切换阀本体、电磁阀及仪表气源等方面分析和总结了真空风机入口压力低引起系统联锁停车故障原因,并介绍了相应的处理措施。     

高压低温先导式安全阀的设计

介绍了一种某试验系统用高压低温先导式安全阀,主要从工作原理、结构特点、材料的选用、结构特点、试验等方面进行阐述。     

55t/h锅炉技术改造成功经验

介绍了35t／h锅炉扩容改造为55t／h非标锅炉的技术成功经验。从增加锅炉的容积、受热面面积、燃烧器喷嘴改造三个方面介绍了对锅炉本体的改造，改造后实现了锅炉的水位、汽温及燃烧自动调节，提高了锅炉的热效率为以后的锅炉扩容改造提供了实践经验。     

利用测井资料预测塔河油田地层破裂压力

针对塔河油田奥陶系碳酸盐岩油藏 ,介绍了地层破裂压力预测和地层裂缝高度预测的基本原理 ,选择了塔河油田 4口井的资料进行了破裂压力和裂缝高度预测的成果处理。为塔河油田奥陶系碳酸盐岩储层改造提供了较为可靠的施工参数