土壤源热泵取热的实验研究

通过广泛分析国内外对土壤源热泵实验研究的现状,建立了可以模拟多个地区、多种运行工况的土壤源热泵沙箱实验台,并进行了绝热边界工况短期内取热的实验研究。     

Extending boosting for large scale spoken language understanding

We propose three methods for extending the Boosting family of classifiers motivated by the real-life problems we have encountered. First, we propose a semisupervised learning method for exploiting the unlabeled data in Boosting. We then present a novel classification model adaptation method. The goal of adaptation is optimizing an existing model for a new target application, which is similar to the previous one but may have different classes or class distributions. Finally, we present an efficient and effective cost-sensitive classification method that extends Boosting to allow for weighted classes. We evaluated these methods for call classification in the AT&;T VoiceTone^® spoken language understanding system. Our results indicate that it is possible to obtain the same classification performance by using 30% less labeled data when the unlabeled data is utilized through semisupervised learning. Using model adaptation we can achieve the same classification accuracy using less than half of the labeled data from the new application. Finally, we present significant improvements in the “important” (i.e., higher weighted) classes without a significant loss in overall performance using the proposed cost-sensitive classification method.     

Finite sample properties of estimators of spatial autoregressive models with autoregressive disturbances

The article investigates the finite sample properties of estimators for spatial autoregressive models where the disturbance terms may follow a spatial autoregressive process. In particular we investigate the finite sample behavior of the feasible generalized spatial two-stage least squares (FGS2SLS) estimator introduced by Kelejian and Prucha (1998), the maximum likelihood (ML) estimator, as well as that of several other estimators. We find that the FGS2SLS estimator is virtually as efficient as the ML estimator. This is important because the ML estimator is computationally burdensome, and may even be forbidding in large samples, while the FGS2SLS estimator remains computationally feasible in large samples. Received: 20 January 2001 / Accepted: 31 August 2001     

Characteristics of origin-destination pair traffic in Funet

In this paper we analyze measurements gathered from a 2.5~Gbps link in the Finnish university network (Funet) in 2004. The traffic is broken down into origin-destination (OD) pair components based on source and destination IP address. We study the traffic characteristics of these components, and identify four typical representative OD pairs. For these pairs we investigate the validity of a moving IID Gaussian model. We find that the statistical properties of these OD pairs differ significantly from each other, with only some of them close to Gaussian. The OD pairs are also found to have some cross-correlation between each other, contradicting an often made assumption about OD pair independence. Furthermore, the existence of a mean-variance relation between the OD pairs is studied. We find that there is a relation between mean and variance, but for some periods of time it is rather weak.     

SOC设计中的浮动压焊块电源/地线网络设计和优化

随着VLSI工艺技术的发展和芯片规模的不断增加，尤其是在SOC设计中，原有的那种供电压焊块只能位于芯片边缘的确定益的模式已经不能够满足整个电路性能的需要。在很多情况下，依靠在电源线的拓扑结构确定后的线宽优化，还是无法保证在有限的布线资源下为电路提供可靠的高性能的供电需求。由此，出现了在芯片边缘上浮动放置压焊块及在芯片的顶部放置供电压焊块阵列的方法。文中提出了一种用于SOC设计中新的基于树型结构的浮动压焊块的电源／地线网络优化算法，经过MCNC电路实例测试后得到明显的优化结果。     

基于聚类算法实现信号盲分类

本文解决了信号处理、工业控制等领域存在的非平稳信号盲分类问题。在聚类中广泛应用的K-Means算法及其它基于中心的聚类算法有两个共同的缺陷-需要预先确定类数目且随机初始化中心引起性能不稳定。本文提出的算法较好地解决了这两个问题，提高了算法稳定性，实现了非平稳信号盲分类。提取非平稳信号的小波系数作为聚类的样本空间，分析聚类结果的统计偏差以估计类的数目，采用调和均值准则进行分类。最后给出的仿真结果表明本文提出的方法较传统的K-Means算法明显降低分类错误率。     

裂缝性油气藏采收率：100个裂缝性油气田实例的经验总结

通过对世界上100个裂缝性油气藏的综合评价，研究储集层及流体本身的性质(包括孔隙度、渗透率、黏度、可动油比例、含水饱和度、润湿性及裂缝分布特征等)和驱动机制及油藏管理战略(优化日产量和采用不同类型的提高采收率技术)对其最终采收率的影响。将裂缝性油气藏分为4类：I类的基质几乎没有孔隙度和渗透率，裂缝是储存空间和流体流动的通道；Ⅱ类的基质有较低的孔隙度和渗透率，基质提供储存空间，裂缝提供流动通道；Ⅲ类(微孔隙)的基质具有高孔隙度和低渗透率，基质提供储存空间，裂缝提供流动通道；Ⅳ类(大孔隙)的基质具有高的孔隙度和渗透率，基质提供储存空间和流动通道，裂缝仅增加渗透率。对26个Ⅱ类油气藏和20个Ⅲ类油气藏的开采历史的研究表明：Ⅱ类油气藏的采收率受水驱强度和最优日产量控制，日产量过高会很容易破坏Ⅱ类油气藏，一些Ⅱ类油气藏如果管理得当，采收率可以很高，不需要二次或三次采油；Ⅲ类油气藏的采收率主要受岩石和流体本身性质的影响，特别是基质渗透率、流体重度、润湿性以及裂缝强度等，不进行二次或三次采油不可能完全开采，往往需要采用一些提高采收率的专门技术。以往将Ⅱ类和Ⅲ类裂缝性油气藏归为一类，认识它们的区别将有助于选择更好的开发策略。     

Using classification techniques for informal requirements in the requirements analysis-supporting system

In order to efficiently develop large-scale and complicated software, it is important for system engineers to correctly understand users’ requirements. Most requirements in large-scale projects are collected from various stakeholders located in various regions, and they are generally written in natural language. Therefore, the initial collected requirements must be classified into various topics prior to analysis phases in order to be usable as input in several requirements analysis methods. If this classification process is manually done by analysts, it becomes a time-consuming task. To solve this problem, we propose a new bootstrapping method which can automatically classify requirements sentences into each topic category using only topic words as the representative of the analysts’ views. The proposed method is verified through experiments using two requirements data sets: one written in English and the other in Korean. The significant performances were achieved in the experiments: the 84.28 and 87.91 F1 scores for the English and Korean data sets, respectively. As a result, the proposed method can provide an effective function for an Internet-based requirements analysis-supporting system so as to efficiently gather and analyze requirements from various and distributed stakeholders by using the Internet.     

CPM自滤波非稳腔YAG激光器研究

把由非谐振环和凸面全反射镜构成的自滤波非稳腔应用于撞脉冲锁模Ｎｄ：ＹＡＧ激光器，改善了光束的空间质量和输出稳定性，获得发散角为２倍衍射极限，能量５０ｍＪ，脉宽１０ｐｓ的锁模脉冲，并与未加滤波小孔的ＣＰＭ非稳腔的输出性能进行实验比较。，     

Measurement of specimen charging in scanning electron microscopy with a kelvin probe

A vibrating Kelvin probe in form of a platinum wire loop is used to measure the surface potential U_s on electron-irradiated free-floating metal and insulator specimens as a function of electron energy E. This allows an accurate measurement of the critical electron energy E₂ for no charging. At energies below E₂, the positive charging increases with decreasing energy to U_s=2–5 eV at E=0.5 keV and switching off the collector bias of the Everhart-Thornley detector. A two-to threefold increase of U_s is observed when the bias is switched on. For E > E₂, the strong increase of a negative surface potential can be measured. Insulating films free-supported on a conductive substrate show a steep decrease to small positive and negative U_s when the film thickness becomes lower than the electron range at a critical energy E₃ > E₂. At insulating specimen the temporal decrease of charging can be measured when the electron beam is switched off.