岔河集油田开发调整的主要做法与成效

岔河集油田有多个受构造、岩性双重因素控制的中低渗透复杂断块油藏,其主要储集层为河流相沉积。油田20余年的开发历程是典型的滚动勘探开发过程。通过精细科学的地质研究,不断的实践和认识,制定出与其油田地质特点相适应的开发方针,完善了井网部署与加密、产吸剖面调整、油水井配套综合治理等一系列开发对策,并取得了比较好的开发效果。岔河集油田的开发实践对于类似油田开发不乏成功的经验。     

热镀锌工艺对Ti-IF钢光整热镀锌板组织和性能的影响

在连续热镀锌线上研究了RTH带钢温度和光整延伸率对Ti—IF钢光整热镀锌板组织和性能的影响。试验表明，当RTH带钢温度在830℃以下时，成品铁素体晶粒度为10．0级，织构类型以{332}、{114}为主，随着带钢温度的进一步提高，热镀锌板的晶粒逐渐粗化，织构成为典型的{111}织构，且取向密度增加，r值随之提高，但当带钢温度在900℃以上时，织构又趋于无规则分布，r值显著降低；光整延伸率对Ti—IF钢光整热镀锌板力学性能的影响很大，随着光整延伸率的提高，屈服强度明显提高，n值明显降低，延伸率降低，抗拉强度变化较小，且光整延伸率对性能的影响与成品铁素体晶粒尺寸有关，成品晶粒越粗，光整延伸率的影响越大。因此对于Ti—IF钢光整热镀锌板而言，n、r值是一对矛盾体，在制订热镀锌工艺时，需根据使用条件的不同，对其n、r值进行综合考虑。     

250W带功率因数校正整流电源模块的研制

功率因数校正技术越来越成为电源行业研究的热点。文中介绍了适用于雷达等设备的250W带功率因数校正整流电源模块的设计，分析了其中升压电感器设计、主开关管保护、控制电路消振、散热设计和表面贴装等关键技术，完成了实验研究，获得了满意的试验结果。     

Ability of a contactless inductive device for the characterization of the critical current versus temperature in superconducting rings at temperatures close to TC

Critical current measurements for three polycrystalline rings of YBCO, three Bi-2223, and one YBCO + Ag were developed from a temperature close to 80 K to the critical temperature using a previously reported contactless inductive device based on the transformer method. These data were used to analyze the ability of this device to characterize, in superconducting rings, the Ginzburg-Landau, Ambegaokar-Baratoff, and De Gennes regimes as well as the crossover temperature between them.     

Investigation on vapor-cooled current leads operating in a pulse mode

This paper describes transient numerical modeling for thermal characteristic of vapor-cooled current leads under pulse operation. The transient thermal analysis considers the temperature difference between a helium gas flow and a copper lead with temperature dependent properties of helium gas, copper and stainless steel. The numerical analysis was validated by an experiment with commercially available 100 A vapor-cooled current leads. A proper overloading factor calculation and the effect of intermediate cooling are presented for the current leads under pulse operation, which can significantly reduce heat input to a cryostat.     

An Experimental Investigation of the Coagulation of Aerosol in a Tube in the Vicinity of Subharmonic Resonance

Nonlinear oscillation of aerosol in the vicinity of a resonance frequency that is twice lower than the first eigenfrequency (subharmonic resonance) is experimentally investigated in tubes with different conditions at the ends. The time dependence of the number density of aerosol droplets is determined, and the effect of the frequency and intensity of oscillation on the process of coagulation of droplets is studied. The nonmonotonic pattern of the dependence of the time of coagulation of aerosol droplets on the frequency of excitation with a minimal value at resonance is found. Ordered space-time structures (alternation of denser and looser regions of aerosol) are revealed in the visible region in the vicinity of the middle of a closed tube.     

The Region 1 & 3 Broadcasting‐Satellite Service Plan after WRC‐03

The 1977 Broadcasting‐Satellite Service (BSS) Plan for Region 1 & 3 had been widely acknowledged to be out‐of‐date by the late 1980s. Development of digital modulation in the early 1990s provided an opportunity to update the technical provisions of the Plan to make it more economically viable. After a decade of work and three World Radiocommunication Conferences (WRCs), the revision of Region 1 & 3 BSS Plan was finally completed in 2003. The new Plan increased channel assignments from 5 to 10 analog‐equivalent channels for each country in Region 1, and from 4 to 12 channels for each country in Region 3. Yet, despite the increase in capacity, the new Plan is surprisingly similar to the original one in terms of the technical parameters. It is still based on national coverage, and the channel plan, orbital location, orbital spacing, and polarization are also the same. As a result, the new Plan is no more economically viable to implement than the old. To create economically viable BSS systems would most likely require modifications to the assignment in the Plan. Yet, modification procedures were made more difficult to apply after replanning. Less future implementation of BSS networks than would otherwise have occurred can be expected, and an inefficient usage of these frequency bands will likely result. On the other hand, less implemented systems will mean more capacity set aside for future use. This is important for countries that currently do not have satellite operations. In the end, BSS replanning reflects the eternal conflict between efficient usage and guaranteed future access. Copyright © 2005 John Wiley & Sons, Ltd.     

印品质量控制中的密度测量与色度测量

在印刷品质量控制中为了得到更多的可靠数值,越来越多地选择用仪器测量法来代替主观评价法.这就是密度测量法和色度测量法.     

热压/热变形Nd2Fe14B/α-Fe纳米双相永磁体的研究

为了制备各向异性块状Nd2Fe14B／α—Fe纳米双相永磁体，研究了热压／热变形工艺参数与样品微观组织结构、磁性能之间的关系。结果表明，饱和磁化强度Js随模压温度的升高而提高；而剩磁Jr、内禀矫顽力Hcj和最大磁能积(BH)max开始都随模压温度的升高而上升，但超过一定温度后反而降低；同时提高热压压力会使磁性能增加，而热变形温度对磁性能影响很小。热变形后样品垂直于压力方向的磁性能略高于平行于压力方向，呈现出轻微的各向异性。Nd2Fe14B／α—Fe纳米双相永磁材料在热压／热变形后没有产生晶粒的择优长大，在晶体学上仍然是各向同性的。     

Density Measurement of Liquid Ni-Ta Alloys by a Modified Sessile Drop Method

The density of liquid Ni- Ta alloys was measured by using a modified sessile drop method. It is found that the density of the liquid Ni- Ta alloys decreases with the increasing temperature, but increases with the increase of tantalum concentration in the alloys. The molar volume of liquid Ni- Ta binary alloys increases with the increase of temperature ancl tantalum concentration.