ATM交换结构综述

本文从国内外ATM交换领域有关最新研究成果出发，全面综述了宽带综合业务数字网中ATM交换结构的实现方法，并对它们的重要特点和性能进行了讨论。提出了ATM交换结构研究中存在的主要问题和今后的发展方向。     

光子交换技术的前景简述

本文首先指出光纤通信向全光网推进的趋向，认真研究光子交换技术的必要性。其后简单说明光子交换有关的波分多路／波分多址系统，空分交换器，交叉连接结点，波长路由器和波长转换器，光电子集成／光子集成技术。最后给出作者个人见解的结论．     

热光双稳态的临界入射功率与临界温升

本文考虑到F—P腔夹层介质和后反射镜均具有一定的吸收时,推导出产生热致色散光学双稳态的临界入射光功率P_c和临界温升△T_c的数学解析表达式。理论计算的 △T_c值与实验值非常符合。为了得到最佳光学双稳态回线和避免腔内的纵向温度梯度,夹层介质和后反射镜应具有一定的匹配吸收。     

Achieving fair service with a hybrid scheduling scheme for CICQ switches

Providing performance guarantees for arriving traffic flows has become an important measure for today’s routing and switching systems. However, none of current scheduling algorithms built on CICQ (combined input and cross-point buffered) switches can provide flow level performance guarantees. Aiming at meeting this requirement, the feasibility of implementing flow level scheduling is discussed thoroughly. Then, based on the discussion, it comes up with a hybrid and stratified fair scheduling (HSFS) scheme, which is hierarchical and hybrid, for CICQ switches. With HSFS, each input port and output port can schedule variable length packets independently with a complexity of O(1). Theoretical analysis show that HSFS can provide delay bound, service rate and fair performance guarantees without speedup. Finally, we implement HSFS in SPES (switch performance evaluation system) to verify the analytical results.     

试论开关电源的电磁干扰

开关电源因体积小、功率因数较大等优点而在通信、控制、计算机等领域广泛应用,但其产生的电磁干扰在一定程度上限制了它的使用。文中简单介绍了开关电源电磁干扰的相关概念,分析了开关电源电磁干扰产生的机理,介绍了实施开关电源电磁兼容的方法,并结合实际实用,介绍了开关电源目前常用的抑制干扰的具体措施。     

基于IPv6组播的M-FHM IPv6切换技术

由于快速分层切换技术FHMIPv6将FMIPv6和HMIPv6切换技术结合起来,因此,在层次移动管理模型中部署快速切换时具有两种技术所具有的优点,可使切换延时进一步减少。文中通过对FHMIPv6的研究发现,其切换过程中DAD重复地址检测过程严重影响了切换性能,因此提出了基于IPv6组播的M-FHMIPv6切换技术。理论分析证明,M-FHMIPv6能有效减少DAD检测过程和各种信息交互的延迟。通过NS2实验仿真进一步说明:改进的M-FHMIPv6方案能减少切换延迟,平滑切换过程。     

高速分组交换网络中调度器的设计

为了满足迅猛发展的网络业务对网络服务质量提出的更高要求,使用高速分组网络交换机中的队列调度器可以有效地提供高质量的网络服务。通过采用分级式队列调度和四种队列调度算法有效地实现了队列调度器的设计。并且深入地比较和分析了队列调度器中多种队列调度算法的优缺点,尤其是对DRR调度算法进行了优化和改进。最后。对所设计的电路进行了仿真验证和电路综合,结果表明该调度器可以满足网络对服务质量的更高要求,并且能够应用到高速分组交换网络的调度器设计中。     

Protection switching schemes and mapping strategies for fail-operational hard real-time NoCs

Communication infrastructures designed for mixed-critical MPSoCs must provide isolation of traffic, hard real-time guarantees, and fault-tolerance. In previous work, we proposed the combination of protection-switching with a hybrid Time-Division-Multiplexed (TDM) and packet-switched Network-on-Chip (NoC) to achieve all three goals. In this paper, we present an FPGA implementation of such a NoC with all its features. We give synthesis results for the hybrid NoC, including the network interface, and show that our router uses over 32% fewer LUTs and registers than a competitive state-of-the-art router for mixed-critical MPSoC. We then explore different channel and task mapping strategies for critical applications which use protection switching and evaluate the effect these mappings have on the best-effort (BE) traffic in the system. Results show, that spreading out the critical traffic rather than naively dividing the system in critical and non-critical application domains is advantageous or even necessary in many cases and can allow for up to 13% more BE traffic. We give a comprehensive trade-off analysis of three protection switching schemes—1:n, 1:1, and 1+1—and show that 1+1 protection has less than half the worst case latency for critical traffic that 1:n and 1:1 protection have. At the same time, 1+1 protection, on average, only causes a 1.18% earlier saturation rate for BE traffic, which we consider to be affordable. We conclude that 1+1 protection is ideally suited for use in mixed-critical systems with high safety requirements.     

基于强跟踪滤波器的开关变换器故障诊断

Buck变换器又称降压变换器、串联开关稳压电源、三端开关型降压稳压器。广泛用于计算机、家用电器、控制系统和通信系统中的电源几乎都是开关电源,具有超快速负载动态响应、高功率变换效率、高功率密度、低电压、大电流的特性.开关变换器作为它的主要电路,故障率较高,对它故障诊断研究是有意义的。基于强跟踪滤波理论,给出了一种开关变换器电路故障实时诊断的一种方法。该方法以建立一种开关变换器电路状态空间模型为基础,利用强跟踪滤波器对电路状态及元件参数进行估计,当元件参数发生软、硬型故障时,根据强跟踪滤波器对元件参数的跟踪结果及修正的Bayes分类算法,可实时诊断开关变换器电路中的元件故障。仿真结果证明了该方法的有效性。     

Contrast‐enhanced wide‐angle high‐speed polarization modulator for active‐retarder 3‐D displays

Abstract— A contrast‐enhanced wide‐angle high‐speed polarization modulator for active‐retarder 3‐D displays is proposed. By using a double liquid‐crystal‐cell structure together with a dedicated driving scheme and an external quarter‐wave retarder, a high‐performance modulator can be realized, resulting in minimized brightness loss and low cross‐talk levels in fast‐refresh time‐multiplexed 3‐D displays.