Effects of hot-carrier stress on high performance polycrystalline silicon thin film transistor with a single perpendicular grain boundary

This paper is a report on the effect of a single perpendicular grain boundary on the hot-carrier and high current stability in high performance polycrystalline silicon (poly-Si) thin film transistors (TFTs). Under a hot carrier stress condition (Vg = Vth + 1 V, Vd = 12 V), the poly-Si TFT with a single grain boundary is superior to the poly-Si without any grain boundary because of the smaller free carriers available for electric conduction. The shift of transconductance in poly-Si TFT with a single grain boundary is less than 5% after hot carrier stress during a period of 1000 s. The shift of transconductance is about 25% in the case of the poly-Si TFTs without a grain boundary in the channel. On high current stress, the poly-Si TFT without the grain boundary is less degraded than the poly-Si TFT with the grain boundary because the concentrated electric field near the drain junction is lower.     

Feasibility study of absolute activity measurement with metallic magnetic microcalorimeters

We report on a feasibility study on precise determination of mass-specific activity of low-energy emitting radioisotopes. Conventional methods of activity measurement suffer from source self-absorption and a strong decrease in detection efficiency for low-energy electrons and photons. We propose a new method based on metallic magnetic microcalorimeters with the source embedded in the detector target in a 4π geometry. First results with a ⁵⁵Fe source show that electrons and photons are detected with a detection efficiency close to unity and with little loss of energy for electrons. The aim of this study is to provide standards of activity with very low uncertainties in the framework of radiation metrology.     

Modelling of Diffuse Interfaces with Temperature Gradients

The work is devoted to capillary phenomena in miscible liquids under the assumption that they have a constant and the same density. The model consists of the heat equation, diffusion equation, and the Navier-Stokes equations with the Korteweg stress. We study several configurations corresponding to the microgravity experiments planned for the International Space Station. The basic conclusion of the numerical simulations is that transient capillary phenomena in miscible liquids exist and can produce convective flows sufficiently strong to be observed experimentally. In particular, there exists a miscible analogue to the Marangoni convection where the temperature gradient is applied along the transition zone between two fluids. Convection also appears if, instead of the temperature gradient, the case where the width of the transition zone varies in space is considered. Finally, similar to the immiscible case, miscible drops move in a temperature gradient.     

纳米颗粒的测量与表征

介绍了用于纳米颗粒测量的电镜观察法、X射线衍射线宽法、激光粒度分析法、比表面积法、颗粒沉降法、扫描探针显微术以及小角X射线散射等,并对其测量原理、测量过程、适用范围及测量方法的优缺点进行了讨论。     

Perceived stress management skill mediates the relationship between optimism and positive mood following radical prostatectomy.

This study evaluated relations among optimism, perceived stress management skills (PSMS), and positive mood in 46 men who had surgical treatment for localized prostate cancer. The authors found that optimism, PSMS, and positive mood scores were positively correlated. Positive mood was unrelated to demographic and disease-related control variables. In a hierarchical regression model controlling for PSMS, the relationship between optimism and positive mood became nonsignificant, whereas PSMS remained a correlate of positive mood. Results suggest that the relationship between optimism and positive mood may be mediated by belief in being able to use stress management techniques effectively. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

天津独流减河工程监控系统现地通信单元设计

提出一种配电网电容电流测量的新方法，在零序电压互感器的开口三角侧串联一个可调电感，通过注入一个变频恒流信号寻找配电网的谐振频率，改变可调电感的数值后寻找另一谐振频率，联立2个谐振方程求解电容电流，该方法消除了电压互感器漏抗对测量的影响。开发了配电网电容电流测量仪，经模拟试验和现场测试表明，该方法具有安全、快捷、准确等特点，适用于中性点不接地或经随调式消弧线圈接地配电网。     

Eigenspannungen als Messgröße zur Qualitätssicherung

Residual stress as measured quantity in quality assurance The x‐ray method is used in the Volkswagen Automotive Group at different world‐wide locations as a standard procedure to determine residual stress. As an important measured quantity in the quality assurance residual stresses are specified in drawings of different components (e.g. gears, coil springs). Measurements are carried out during quality assurance, production, damage analyse, technical development department and design control of components from suppliers. An optimum efficiency can be achieved, if it exists a unique correlation between residual stress values and loading capacity of components, and if the processes to introduce residual stress can be optimized using residual stress measurements during the production.     

Method to Characterize the Air Flow and Water Removal Characteristics During Vacuum Dewatering. Part II—Analysis and Characterization

This is part II of a study reported earlier on a method to characterize the air flow and water removal characteristics during vacuum dewatering. This article presents experimental data and analysis of results from the use of a cyclically actuated vacuum dewatering device for removing moisture from wetted porous materials such as paper with the intermittent application of vacuum and accompanying air flow though the material. Results presented include sheet moisture content as a function of residence time and hence water removal rate under a variety of process conditions. Also, experimental results on air flow through the wet porous structure and hence the role and importance of air flow during vacuum dewatering are presented. Vacuum dewatering process conditions include exit solids content between 11 and 20% solid under applied vacuum conditions of 13.5 to 67.7 kPa (4 to 20 in. Hg). Regression analysis indicated that the exit sheet moisture content exhibited a nonlinear relationship with residence time with exit solids reaching a plateau after a certain residence time. Final moisture content correlated linearly with the average overall flow rate of air through the paper sample and the basis weight of the material.     

Preparation and Compressive Stress Effect of Polymer Matrix RE-Fe Giant Magnetostrictive Composite

Polymer matrix RE-Fe giant magnetostrictire composite （GMPC） was prepared using bonding and magnetic field forming technique, and magnetostriction of samples was measured for different compressive stress. The experimental results show thai there is certain compressive effect in GMPC. And the influence of compressive stress on magnetostriction of sample was investigated. It offers essential reference for application and device design of GMPC.     

The five elements and chinese-american mortality.

D. P. Phillips, T. E. Ruth, and L. M. Wagner (1993) reported that 1969-1990 California mortality data show that Chinese Americans are particularly vulnerable to diseases that Chinese astrology and traditional Chinese medicine associate with their birth years. For example, because fire is associated with the heart, a Chinese person born in a fire year (such as 1937) is more likely to die of heart disease than is a Chinese person born in a nonfire year. However, many diseases were excluded from this study, some diseases that were included have ambiguous links to birth years, and the statistical tests were indirect. A more complete statistical analysis and independent California mortality data for the years 1960-1968 and 1991-2002 did not replicate the original results. (PsycINFO Database Record (c) 2010 APA, all rights reserved)