酯化反应偶联渗透汽化膜过程模型(Ⅰ)催化剂的影响

1 INTRODUCTION In former report, the kinetic model for anesterification process coupled by pervaporation wasestablished and the modeling result agreed well withthe experimental result[1].     

板式升膜蒸发器在离子膜烧碱中的应用

介绍了升膜蒸发的原理及影响传热量的因素。重点介绍了板式升膜蒸发器在离子膜烧碱蒸发系统中的应用情况及蒸发装置的特点。     

甲苯稀释对AlCl3-EMIC型离子液体电镀铝工艺氢脆性的影响

采用甲苯作为AlCl3-EMIC(1-乙基-3-甲基咪唑)型离子液体的稀释剂,其中纯态离子液体由物质的量比为2∶1的无水AlCl3和EMIC组成。对比了纯态和按稀释剂与离子液体体积比为1∶1稀释后电镀铝的外观、微观形貌和氢脆性。结果表明,采用甲苯稀释离子液体虽然可以降低镀液的黏度,改善镀层外观和微观形貌,但对离子液体电镀铝工艺的氢脆性有负面影响。     

Forced convection in cross flow of power law fluids over a tube bank

The forced convective heat transfer characteristics for incompressible power-law fluids past a bundle of circular cylinders have been investigated numerically. The cylinder-to-cylinder hydrodynamic interactions have been approximated via a simple cell model. The momentum and energy equations have been solved using a finite difference based numerical method for a range of physical and kinematic conditions. The role of the two commonly used thermal boundary conditions, namely, constant temperature or constant heat flux, on heat transfer characteristics has also been studied. Extensive numerical results elucidating the effect of shear-thinning viscosity on the values of Nusselt number have been obtained for Peclet numbers ranging from 1 to 5000, Reynolds number in the range 1-500, flow behaviour index 1?n?0.5 and three values of voidages, namely, 0.4, 0.5 and 0.6, typical of tubular heat exchangers and tube banks. Under all conditions, varying levels of enhancement in Nusselt number are observed due to shear-thinning behaviour. The surface averaged Nusselt number shows strong dependence on the values of voidage, power-law index, Reynolds and Peclet numbers. The paper is concluded by presenting comparisons with the scant experimental results available in the literature.     

酸性离子液体和Na2WO4·2H2O催化

以酸性离子液体和Na₂WO₄·2H₂O组成的体系为催化剂，过氧化氢为氧化剂，将催化柴油中的噻吩硫氧化为砜类物质，并通过NMP将其萃取出来，同时考察了反应温度、反应时间和催化剂用量等因素对氧化脱硫反应的影响，得出最佳反应条件为：3 mL油样（含硫200 μg·g^_-1），1 g离子液体，0.021 g 钨酸钠（Na₂WO₄·2H₂O）， 0.7 mL过氧化氢，反应温度323 K，反应时间3 h，萃取剂与柴油体积比为1∶1，此时样品中的硫可降低到23 μg·g^-1。反应结束后，可以通过简单的倾倒将油样和催化剂分离，催化剂重复使用5次，催化活性基本不变。     

Antimony Solubility and Speciation in Aqueous Sulphuric Acid Solutions at 298 K

This work is an experimental and theoretical study of antimony speciation and the solubility of Sb₂O₅, Sb₂O₃ and Sb₂(SO₄)₃ at 298 K in aqueous sulphuric acid solutions (0 to 6 kmol/m³). A thermodynamic model was developed to quantify the solubility products and aqueous metal speciation. Main dissolved species were H₃SbO_3(aq) and H₃SbO_4(aq). The solubility of antimony increases with increasing solution acidity and with the presence of hydrogen peroxide in the solution. The following standard equilibrium constants at 298 K were obtained: Log K⁰_(Sb2O5) = 11.7±0.5, Log K⁰_(Sb2O3) = 32±1, and Log K⁰_(Sb2(SO4)3) = 55±2.     

离子水--21世纪的保健品

离子水是一种新型的保健饮用水.本文主要对饮用水、离子水的功能和作用进行了概述,阐述了离子水对人类生活和健康的影响,且指出了离子水具有良好的发展、开发和推广的前景.     

［Bmim］BF4-H2O-Na2CO3离子液体双水相体系液液相平衡数据的测定与关联

用浊点法测定了四氟硼酸1-丁基-3-甲基咪唑—水—碳酸钠体系在常压30℃下的溶解度曲线及密度曲线，并用经验方程进行了关联。用浊点—密度法测定了该体系的液液相平衡数据，绘制了相应的相图。结果表明：双水相体系一相以离子液体和水为主，碳酸钠的含量很少，另一相以碳酸钠和水为主，离子液体的含量很少。该体系既可作为萃取分离体系，也可作为从水溶液中分离回收离子液体的初步体系。用Othmer-Tobias+Bancroft经验方程对相平衡数据进行关联，最大相对误差为94.99%， 最大平均相对误差为15.69%，关联结果不理想。提出用Othmer-Tobias经验方程+溶解度方程对其进行关联，最大相对误差为4.52%，最大平均相对误差为2.77%，关联精度较高，该方法可适用于有一组分含量较低的体系的液液相平衡的关联计算。     

转化乳剂的离子电导和光电导研究

本文研究了ＡｇＢｒＣｌ转化乳剂的离子电导和光电导。随着乳剂中溴含量的增高，其离子电导也随之升高，而光电子寿命则降低。ＡｇＢｒＣｌ乳剂的离子电导主要取决于其组成；ＡｇＢｒＣｌ转化乳剂的光电子寿命主要受隙间银子浓度的影响，隙间银离子浓度越大，光电子寿命越短。     

新型离子液体气相色谱固定相研究

合成了一种用作新型气相色谱固定相的室温离子液体[C7H17NO] [(CF3SO2)2N]-,并考察其色谱性能。该固定相具有较好的成膜性、较高的柱效、较强的极性,对正构烷烃、芳香族化合物以及一些位置异构体具有良好的分离效果。