异癸醛气相加氢制异癸醇催化剂的研究

研究了一种铜锌系异癸醛气相加氢制异癸醇催化剂的制备方法,考察了影响催化剂性能的几种因素,总结出较为合理和有效的制备工艺。     

苯和二异丙苯烷基转移化反应的研究

研究了二异丙苯转移烷基化反应中，催化剂配制条件等因素对反应的影响，对均相条件下的二异丙苯转移烷基化反应动力学进行了研究，得到了反应动力学方程。     

Guerbet十四醇的合成与表征

以正庚醇为原料 ,通过Guerbet反应合成Guerbet十四醇 (2 戊基壬醇 ,C14 GA)。用IR、NMR和元素分析测定了C14 GA的结构 ,并研究了反应温度和用料比对其产率的影响。实验结果如下 :(1)在较优化的反应条件下 (正庚醇的总加入量为 1mol,在实验过程中 ,先加入 1/ 3mol庚醇和 1/ 4mol的KOH ,在 16 0℃下反应 2h ,然后再加入剩下的 2 / 3mol庚醇和 4g 5 %Pd -C催化剂 ,在 15 5℃下反应 6h)合成产物 ,其产率可达到 5 4 2 0 % ;(2 )所合成的产物与试图要得到的Guerbet十四醇 (2 戊基壬醇 ,C14 GA)含有相同的基团 (2×—CH3、10×—CH2 —、1×CH、1×—CH2 —O—和 1×—OH) ,而且 ,所合成的产物中 ,w (C) =79 0 6 % ,w (H ) =13 6 2 % ,与从Guerbet十四醇分子式计算的理论值w(C) =78 5 0 % ,w (H) =14 0 1%基本一致。可见所合成的产物正是Guerbet十四醇 (C14 GA)     

香料丁酸糠醇酯的合成与表征

由丁酰氯和糠醇反应,以廉价的氧化钙和碳酸钠为复合束酸剂,合成了香料丁酸糠醇酯,并用IR、GC等进行了表征。优化条件为:n(丁酰氯)/n(糠醇)=1 2;0 1mol糠醇溶剂用量为60mL、束酸剂用量为18g,回流时间为4h。丁酸糠醇酯的收率为87 2%,产品质量分数为99 9%。     

Alkylation of Benzene with Isopropyl Alcohol over SAPO-5 Catalyst in an Integral Pressure Reactor

The alkylation of benzene with isopropyl alcohol was studied in an integral pressure reactor over silicon substituted aluminophosphate molecular sieves, SAPO-5. The influence of various process parameters such as temperature, pressure, time on stream, weight hourly space velocity, and mole ratio of reactants on cumene yield and selectivity were investigated. The activity of SAPO-5 was compared with that of Hbeta for this reaction under similar conditions and in the same reactor. At pressures higher than atmospheric, almost the theoretical maximum yields of cumene were achieved on this SAPO-5. Among the diisopropyl benzenes formed by the alkylation of cumene, the meta-isomer was found to form in a significant amount followed by the para-isomer. The ortho-isomer with relatively high strain energy of 4.26 kcal/mol was almost negligible. The cumene yield goes through a maximum in the temperature range 498-543 K studied. Cumene selectivity was found to decrease at higher temperatures, higher pressures and lower benzene to isopropanol mole ratios.     

醇溶剂中TS-1催化丙烯环氧化的本征动力学与反应机理研究

研究了在三种不同醇溶剂(甲醇、异丙醇和仲丁醇)水溶液中TS—l催化丙烯过氧化氢环氧化反应的本征动力学，反应条件为温度30～60℃，丙烯压力0．4-0．6MPa。根据实验现象和各组分在TS-1上的吸附特点建立了该反应的Eley-Rideal机理模型，环氧化反应在吸附态的H2O2分子与游离态的丙烯分子之间进行，表面反应为速度控制步骤。通过实验数据对机理模型进行了参数估值，检验结果表明拟合效果较好，平均偏差在10％以内。最后对过程进行了进一步讨论，为该过程的工业化提供了依据。     

Separation of kinetics and mass-transfer in a batch alkoxylation reaction

The quantitative aspects of the role of interfacial mass-transfer and reaction kinetics in ethoxylation of lauryl alcohol were examined in a batch recirculation reactor. The liquid droplets falling through a gas column were obtained by utilizing a recirculation loop and a set of spray nozzles. The CO₂/NaOH reaction was employed to characterize the interfacial area. The alkoxylation reaction was studied at temperatures between 124°C and 171°C, at catalyst levels between 0.09 and 0.50 weight percent and at ethylene oxide partial pressures between 68 kPa and 204 kPa. A model was developed which permits the prediction of reactor performance at various operating conditions. The mass-transfer during free fall dominates the interfacial mass-transfer and the contributions during the drop formation and coalescence stages are small. The rate of ethylene oxide (EO) addition to lauryl alcohol was constant during the batch run, indicating similar activity for the unreacted lauryl alcohol and the lauryl alcohol ethoxylated to varying extents. The rate of ethoxylation is first-order in both catalyst and ethylene oxide concentrations. The liquid-phase reaction kinetics and interfacial mass-transfer occur in series, with kinetics dominating the overall ethoxylation rate. As expected, an increasing role of mass transfer is observed at higher temperatures, and/or higher catalyst concentrations where the kinetic rate becomes significantly high. The intrinsic activation energy for the ethoxylation of lauryl alcohol is 55.2 kJ/mole.     

脂肪醇聚氧乙烯醚的厌氧与好氧生物降解性

以脂肪醇聚氧乙烯醚(AEO)为目标污染物，在等同条件下做厌氧消化污泥和好氧活性污泥对其生物降解性能的对比实验，得出了同一系列AEO分子中聚氧乙烯基与整个分子的降解难易程度的关系。表明：①污泥会对AEO分子产生吸附一脱附作用而出现假降解率，克服假降解率的干扰是准确测定AEO生物降解性的关键因素；②厌氧和好氧条件下，AEO均可降解，但厌氧降解要稍优于好氧降解；③AEO中聚氧乙烯基的单元数(n)是影响其生物降解的重要因素，相同碳链的直链烷基，生物降解率随n的增加而明显降低。     

Sintering of Ceria-Doped Tetragonal Zirconia Crystallized in Organic Solvents, Water, and Air

Amorphous CeO₂–ZrO₂ gels were prepared by coprecipitation in ammonia solutions. The onset of crystallization of the gels, from calcining in air, was 420°C, while 200° to 250°C in the presence of water and organic solvents such as methanol and ethanol. The sintering behaviors of CeO₂–ZrO₂ powders were sensitive to the crystallizing conditions, since hard agglomerates formed when the precipitated gels were crystallized by normal calcination in air, whereas soft agglomerates formed when they were crystallized in water or organic solvents. CeO₂–ZrO₂ powders crystallized in methanol and water at 250°C were sintered to full theoretical density at 1150° and 1400°C, respectively, whereas that crystallized by calcination in air at 450°C was sintered to only 95.2% of theoretical density, even at 1500°C.     

Aerobic selective oxidation of (hetero)aromatic primary alcohols to aldehydes or carboxylic acids over carbon supported platinum

The synthesis of substituted benzaldehydes, benzoic acids, heterocyclic aromatic aldehydes and acids has been studied via the oxidation of the aromatic alcohols with air under mild pressure (<20 bar) at 100 °C, in the presence of a 1.95 wt.% Pt/C catalyst. The solvent was found to play the most important role in determining the selectivity of the oxidation products. Changing the solvent enabled tuning the reaction either to the aldehyde (pure dioxane), or the carboxylic acid (dioxane/aqueous solution without or with addition of sodium hydroxide). This oxidation method allowed to effectively oxidize many substituted benzylalcohols with various electron-releasing or -attracting groups (NO₂, Me, OMe, Cl, Br, OH, phenyl, …) and heterocyclic alcohols including nitrogen and sulphur atoms (2-thiophenemethanol, 2- and 4-pyridine methanol compounds).