挠性抗回旋PDC钻头的有限元分析

回旋是导致PDC钻头早期失效的主要原因，介绍了一种基于挠性钻头的构想设计的抗回旋PDC钻头，阐述了其结构和抗回旋原理。对挠性钻头的公、母接头进行了有限元应力分析，说明了模型建立、网格划分以及约束和载荷施加过程中所采用的方法和关键技术。有限元分析结果表明挠性钻头的强度满足要求。     

用改进的逐次逼近解法计算二维井间电磁场

提出了一种计算积分方程的新方法——改进的逐次逼近解法 (MSAM) ,并用该方法计算了轴对称二维井间电磁场。与传统的逐次逼近解法 (SAM)相比 ,该方法收敛性强 ,应用范围广 ,可适用于高电导率对比地层。由于不必进行直接的大型矩阵求逆运算 ,因此与积分方程的直接解法 (IE)相比 ,该方法计算速度更快 ,所需内存更少。采用矩阵求逆方法计算了成层介质中的二维 Green函数 ,并对含 Green函数的积分进行了简化 ,从而加快了计算速度。数值计算结果显示 ,在地层电导率对比度达到 2个数量级时 MSAM仍收敛 ,且计算结果与直接求解积分方程的结果一致 ,因此 MSAM是一种有效的计算轴对称二维井间电磁场的方法     

一维波动方程反演波阻抗的实现及效果

利用波动方程反演波阻抗，由于计算工作量大、稳定性差等原因，一直没有在地震勘探资料处理中得到实际应用。本文提出的一维波方程逐段折叠反演方法能较好地克服上述缺陷，具有计算量相对较小、精度高、稳定性好等特点。并在大庆长垣东部和西部的实际资料处理中见到了良好的效果。     

面向表面组装工艺技术的PCB焊盘设计

尽管电子设计类软件已相当先进和方便，而且更新速度也很快，但是仍然无法满足各个层次的设计人员的需求，特别是适合各种元素封装形式的焊盘设计库并不能让设计和制造者满意，为了在此方面对PCB设计有所帮助，从印制电路板焊盘的设计方法入手，针对表面组装工艺技术特点，分析了PCB焊盘对PCA可靠性的影响因素，并根据相关的质量要求提出了较为简便的设计方案。     

大口径管道带水抢修

包头地区1996年5月3日发生6.4级强烈地震,给包钢生产造成重大损失,地震发生后,包钢生产用动力系统发生多起事故.本文针对4#高炉工业回水管道(φ1220×10)震后发生断裂,如何在保证不停止生产的前提下,采取什么措施进行管道带水抢修进行了阐述,本文是经过现场抢修过程总结而来,对今后大口径管道带水抢修提供了宝贵的经验.     

Ti-23Al-14Nb-3V合金氩弧焊接头的显微组织及其力学性能

研究了预热对Ｔｉ－２３Ａｌ－１４Ｎｂ－３Ｖ合金焊接性，特别是对消除氩弧焊冷裂纹的作用以及对接头显微组织和力学性能的影响。结果表明，焊前预热可有效降低该合金的冷裂倾向。经预热处理后，焊缝区的结晶层状线消失，热影响区的硬度峰得到缓和，整个焊缝的显微硬度分布趋于均匀，但焊缝区的枝晶发生粗化，热影响区有所扩大。焊件接头的拉伸试验表明，预热可使焊缝区的接头强度系数增加，但无论预热与否，接头强度均低于母材强度，且不显示宏观塑性。     

三峡永久船闸结构缝渗漏处理技术

在三峡永久船闸结构缝处理过程中，认真分析了结构缝渗漏的原因，通过止水检查槽进行压水检查，确定了渗漏部位。结合渗漏具体情况，采取了结构缝表面嵌填止水材料和廊道周边止水检查槽灌浆相结合的处理方法。在实施过程中，采用了多种新材料和新工艺，取得了良好的效果。     

Suppression of void coalescence in thermal aging of tin-silver-copper-X solder joints

Addressing the potential for drop impact failure of Pb-free interconnects, the shear ductility after extensive aging of Sn-Ag-Cu (SAC) solders has been improved radically by Co or Fe modifications. Several other SAC+X candidates (X=Mn, Ni, Ge, Ti, Si, Cr, and Zn) now have been tested. Solder joint microstructures and shear strength results show that new SAC+X alloys also suppress void formation and coalescence at the Cu (substrate)/Cu₃Sn interface (and embrittlement) after aging at 150°C for up to 1,000 h. Microprobe measurements of 1,000 h aged samples suggest that Cu substitution by X is usually accentuated in the intermetallic layers, consistent with X=Co and Fe results.     

Multi-User MIMO Mobile CDMA Uplink System Employing Turbo Coding and Joint Detection Through a Multipath Rayleigh Fading Channel

In this paper, a generalized multiple-input multiple-output (MIMO) antenna system that can be fitted to the uplink of a wireless communication system is considered for the general case of multi-user. At the transmitter, the information bits are Turbo coded, then interleaved and passed through a serial-to-parallel converter. The channel is assumed bad urban suffering from multipath Rayleigh fading resulting in inter-symbol and multiple access interferences (ISI and MAI). At the front-end of the receiver, a number of receiving antennas are used followed by a joint multi-user estimator based on the Minimum Mean Square Error Block Linear Equalizer (MMSE-BLE).Computer simulations demonstrate a significant performance improvement in both single user and multi-user cases.This paper depends in parts on that presented at the 11th European Wireless Conference, Cyprus, Nicosia, pp. 187–192, April 2005. Yasmine A. Fahmy was born in Guiza, Egypt, on June 4, 1976. She received the B.Sc., M.Sc. and Ph.D. degrees in Communication and Electronics engineering from Cairo University, Egypt on 1999, 2001 and 2005 respectively. She is presently an assistant professor at Cairo University, Egypt. Her current field of interest is wireless communication and channel estimation. Hebat-Allah M. Mourad received her B.Sc., M. Sc. and Ph.D. degrees in electrical communication engineering from Cairo University, Egypt, in 1983, 1987 and 1994 respectively. Since 1983, she has been with the Department of Electronics and Communications, Faculty of Engineering, Cairo University, and is currently associate professor there. Her research interests include optical fiber communications, mobile and satellite communications. Emad K. Al-Hussaini received his B.Sc degree in Electrical Communication Engineering from Ain-Shams University, Cairo, Egypt, in 1964 and his M.Sc and Ph.D. degrees from Cairo University, Giza, Egypt, in 1974 and 1977, respectively. From 1964 to 1970, he was with the General Egyptian Aeroorganization. Since 1970, he has been with the Department of Electronics and Communications, Faculty of Engineering, Cairo University, and is currently professor there. He was a research fellow at Imperial College, London, UK, and at the Moore School of Electrical Engineering, University of Pennsylvania, Philadelphia, PA, USA, in the academic years 1976/1977 and 1981/1982, respectively. In 1990, he received the Egyptian national encouragement award for outstanding engineering research. He has written several papers for technical international journals and conferences. His research interests include signal processing, fading channel communication, modulation, and cellular mobile radio systems. Dr Al-Hussaini is a senior member of IEEE. He is listed in Marquis Whos Who in the World and in the IBC (International Biographical Center, Cambridge) for outstanding people of the 20th century.     

勘探地球物理技术最新进展——２００２年ＳＥＧ年会综述Ⅱ：解释与压力预测

根据2002年SEG年会部分论文编译而成，包括解释技术和压力预测技术。概要性地介绍了偏移成像技术；新属性技术；自动地震相分析技术；油气检测技术；储层反演技术和2种实用的压力预测技术。