Reducing treatment zone diameter in orthokeratology and its effect on peripheral ocular refraction

PurposeTo determine whether orthokeratology (OK) induced treatment zone (TZ) diameter can be reduced by altering OK lens design, and if so the impact of modifying TZ diameter on relative peripheral refraction (RPR).Methods16 subjects (mean age 23.4 ± 1.5 years; 8 female) completed the study. Standard (Control) OK lens design (PJ, Capricornia, Australia) or a modified version (Test) where the back optic zone diameter was reduced, and back optic zone asphericity and intermediate lens curves were altered, were worn overnight only for 7-nights in a randomised double masked order, with a minimum 1-week wash out (no lens wear) between lens designs. Full correction of refractive error was targeted. Refraction; best corrected visual acuity (BCVA); RPR (Shin-Nippon NVision-k 5001) along the horizontal and vertical meridians; and corneal topography (Medmont E300) were measured before starting lens wear and in the morning after lens removal after the seventh night of lens wear for both lens designs. TZ diameter and decentration was calculated from corneal topography.ResultsAfter 7-nights of wear both lens designs created -2.00D refraction effect with no significant difference in refractive effect or change to BCVA between the designs. The Test design created a significantly smaller horizontal (4.78 ± 0.37 vs 5.70 ± 0.37 mm, p < 0.001) and vertical (5.09 ± 0.51 vs 5.92 ± 0.51 mm p < 0.001) TZ diameter. The TZ was decentered inferior temporal with no significant difference between designs. There was no significant difference between the lens designs in RPR along the horizontal and vertical meridians at any measurement period.ConclusionsOK induced TZ diameter can be reliably reduced by altering OK lens design without detrimentally effecting lens centration or refractive effect. Reducing TZ diameter did not alter RPR, though measurement artifacts could be responsible for masking an effect. Longitudinal studies are needed to assess whether smaller TZ OK lens designs increase efficacy for slowing progression of myopia.     

浅析火力发电厂汽水系统中内径管与外径管的设计选择

按照管道加工工艺的不同,管道可分为内径控制管和外径控制管。通过热轧工艺生产的外径控制无缝钢管,可满足火力发电厂汽水系统中绝大部分管道的使用要求。对于超(超)临界机组的主蒸汽和高温再热蒸汽管道采用的P91/P92材质的大口径厚壁无缝钢管,由于对材料性能和加工工艺有特殊要求,因此宜采用内径控制管。     

基于振动实测的非均质地层钻头失效分析与对策

四川盆地作为国内页岩气开发的重点区域,通过近几年的不断攻关和实践,机械钻速得到了提高,但由于受地层复杂、可钻性差、非均质性强等地质因素的影响,导致井下钻柱系统不良振动剧烈,容易出现钻头损坏严重、钻速较低等问题,严重影响了钻井时效。为了解决上述难题,以该盆地涪陵工区上二叠统龙潭组—中二叠统茅口组为例,采用井下振动高频测量工具的实测手段,测量了钻头—钻柱系统的动态振动加速度参数,结合地层的岩性和矿物组分分析,研究钻头失效原因与对策,并开展了现场试验。研究结果表明:①在非均质地层中钻进的钻头—钻柱系统产生了大于40 m/s~2的高幅值瞬时冲击振动,高幅值的瞬时冲击是导致钻头先期失效的主要原因;②提出了抑制高幅值的瞬时冲击振动采用"减振+增压"工具组合和避免井下工具共振的钻井参数;③采用钻井新参数的试验井比邻井的高幅值瞬时振动降低了17%,单只钻头进尺增加24%,钻头工作环境得到了较大的改善,钻头使用数量减少。结论认为,该研究成果能够有效地改善钻头—钻柱系统的振动状态,有利于达成延长钻头使用寿命的目标。     

空间红外大口径折射式低温镜头设计与验证

针对目标探测类空间红外相机大范围成像、高灵敏度探测、高精度定位等应用需求,文中提出采用像方远心光路和低温光学技术结合的解决方案,设计了物方视场角8°×8°、入瞳口径265 mm、工作温度200 K的像方远心折射式光学系统。镜头最大口径280 mm,采用多级分散的弹性支撑设计,解决大口径低温透镜装框、透镜组件支撑和镜头整体安装各环节的热应力卸载问题。在保证高刚度和低漏热的情况下,使低温下透镜的热应力对镜头能量集中度的影响降低到可接受范围内。镜头完成装调及室温下像质确认后,进行了力学振动试验,并将其制冷到200 K水平测试像质,测试结果表明,镜头能量集中度达到轴上75%,边缘视场72%。     

Does decision quality (always) increase with the size of information samples? Some vicissitudes in applying the law of large numbers.

Adaptive decision making requires that contingencies between decision options and their relative assets be assessed accurately and quickly. The present research addresses the challenging notion that contingencies may be more visible from small than from large samples of observations. An algorithmic account for such a seemingly paradoxical effect is offered within a satisficing-choice framework. Accordingly, a choice is only made when the sample contingency describing the relative evaluation of the 2 options exceeds a critical threshold. Small samples, because of the high dispersion of their sampling distribution, facilitate above-threshold contingencies. Across a broad range of parameters, the resulting small-sample advantage in terms of hits is stronger than their disadvantage in false alarms. Computer simulations and experiments support the model predictions. The relative advantage of small samples is most apparent when information loss is low, when the threshold is high relative to the ecological contingency, and when the sampling process is self-truncated. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

硫化物预处理方法研究及测定中的质量保证

针对水和废水中硫离子的特点,设计制作了测定硫化物的酸化—吹气—吸收预处理装置,并验证了该装置对硫化物的回收效果,简化了原来的预处理方法。总结分光测定过程中注意的若干事项,确定了最佳实验条件,使该方法具有更准确、简便、快速的特点。     

一种大尺度二维直线度精密测量的新方法

本文提出了一种远距离、大范围二维直线度测量的新方法．该方法采用特殊设计的十字线准直激光器及线阵CCD，通过特殊的光学系统结构设计，能在0-20m距离内连续测量，直线度范围可达70mm，精度优于0．1mm，实际测量结果表明，该方法可适应野外作业环境。     

电子天平示值误差测量结果的不确定度评定

一切测量结果都不可避免地具有不确定度，结合实际应用的情况，详细介绍了电子天平示值误差测量结果的不确定度评定方法。     

基于加速度计的坐标系匹配方法研究

为了提高加速度计应用中坐标系的匹配精度,提出了基于加速度计的坐标系匹配方法,介绍了其基本原理,并对加速度计的测角方法进行了深入研究.试验结果表明:该方法测量最大误差≤0.3°,满足实际应用要求,有效地解决了加速度计应用中的坐标系匹配问题.     

基于积分原理的低功耗超声波流量检测方法

文章通过对时差式超声波流量检测方法的分析，提出了基于过零检测技术及积分法的信号处理方法，避免了繁琐的信号处理，降低了整机功耗。结合工作时序的设计，提出了实现低功耗超声波液体流量检测的措施。