安钢宽板坯连铸机达产实践

分析了安钢宽板坯连铸机在热试车期间出现的生产问题,总结出制约生产主要因素,制定针对性措施,使该连铸机在较短时间内实现达产创效.     

模拟退火算法用于蒸汽吞吐井生产能力的预测

模拟退火算法是一种利用统计力学观点求解优化问题全局最优解的方法,是目前解决优化问题的一种比较先进的方法。本文应用模拟退火算法对蒸汽吞吐注采参数进行优化设计,并确定出了6个吞吐周期的最优周期产油量和周期注蒸汽量,较实际周期产油量和实际周期注汽量均有明显增加。将各周期的优化累积产油量和优化累积注汽量画在累积产油量与累积注汽量的双对数坐标中,得出累积注汽量和累积采油量关系曲线(简称注采关系曲线)。将该注采关系曲线外推估算了该井未来周期的累积产油量和累积注汽量,从而达到对蒸汽吞吐井生产能力的预测。     

非化学计量LaNi5型储氢合金的性能

采用富La混合稀土与Ni、Co、Mg等元素组合，获得了一种非化学计量LaNi5型储氢合金、用金相、XRD和SEM-EDX等方法分析了该合金的组织结构，研究了合金的气相储氢特性以及电化学性能，结果表明：在1.6MPa氢压和温度29℃下，该合金的储氢量达到1.58%（质量分数），该合金的放电容量为380mAh/g。经300次循环后容量保持率为55%，该合金的基体是CaCu5型结构的LaNi5相，但有第二相（LaMg)Ni3析出，这种第二相的形成是导致该合金大容量的关键。     

Acidity in upland and hill soils: Cation exchange capacity,pH and lime requirement

For 30 acid upland and hill soils, with initial pH from 3.5 to 5.8, and loss on ignition from 14% to 94%, cation exchange capacity varied with pH according to the relationship CEC = m pH+C, where m and C are characteristic of each soil. The slope m depended on loss on ignition (LOI), and is given by: m=Δ CEC/Δ=0.22 LOI+1.92. Because of these relationships, CEC measured at the natural pH of the soil (in 0.025 M MgSO₄ solution) is more relevant to field conditions than a conventional measurement at pH7. An improved method for estimating lime requirement (LR) of these soils was developed, based on the relationship found between LR and the difference in CEC (ΔCEC) between that at the natural pH of the soil and that at the target pH of 5.5: LR=1.12 ΔCEC+1.48. Lime requirement can therefore also be estimated from loss on ignition using the earlier relationships, and is given by: LR=(0.25 LOI+2.15) Δ+1.48, where Δ is the difference between the natural pH (in 0.025 M MgSO₄) and the target pH. Predictions based on this agreed well with results for a further 10 soils.     

转向柱管承载能力的试验研究

在分析转向柱管花键部位应力集中情况的基础上,通过对某厂生产的转向柱管扭转破坏的试验研究,得到如下结论:①转向柱管的承载能力与其外花键齿与方向盘中心内花键齿之间的非接触区长度有关,以花键端部过渡圆弧的直径大小为宜;②安装方向盘总成时所施加在安装螺母上的拧紧力矩在70N.m左右时,转向柱管的承载能力最大。     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

渤中28－1（BZ28－1）油田N6H水平井动态分析

本文以渤中２８－１（ＢＺ２８－１）油田Ｎ６Ｈ水平井为例，从多方面对该井的动态和产能变化进行了系统分析，所用的方法对水平井动态分析有一定的指导意义。     

Zeolite synthesis from paper sludge ash with addition of diatomite

BACKGROUND: This study aimed to investigate the synthesis of zeolites from paper sludge ash (PSA) with added diatomite to remove both NH₄⁺ and PO₄^3? for water purification. The PSA had low Si and significant Ca contents. Four types of diatomite: white (T‐W) and brown (T‐B) from deposits of marine origin in Takanosu, and white (S‐W) and gray (S‐G) from lacustrine deposits in Shonai, were added to NaOH solution to increase the Si content and thereby synthesize zeolites with high cation exchange capacity (CEC). RESULTS: The order of the amounts of Si extracted from the diatomite to the alkali solution was S‐W > T‐W = T‐B > S‐G, which correlates with the amorphous SiO₂ content of diatomite. The original ash without addition of diatomite yielded hydroxysodalite with CEC of about 1.0 mmol g^?1. For all samples, the addition of diatomite to the solution yielded zeolite‐P with a higher CEC, but the addition of excess Si inhibited the synthesis of zeolite‐P, and the CEC of the product was low. A product with high CEC including zeolite‐P was obtained in a solution with around 500 mmol L^?1 of Si concentration, and had the ability to remove both NH₄⁺ and PO₄^3?. CONCLUSION: Diatomite has the potential for used as an additive for the synthesis of high CEC zeolite from PSA. The product with zeolite‐P exhibited relatively high CEC, capacity for NH₄⁺ uptake, and the ability to remove PO₄^3? by precipitation, which is preferable for water purification applications. Copyright © 2008 Society of Chemical Industry     

世界乙烯工业及其进展

阐述了世界乙烯产能需求现状，近扑扩能增产预测，乙烯原料分析以及乙烯生产的技术进展。     

Computation of Bearing Capacity Factor Nγ?Terzaghi’s Mechanism

A procedure based on K?tter’s equation is developed for the evaluation of bearing capacity factor Nγ with Terzaghi’s mechanism. Application of K?tter’s equation makes the analysis statically determinate, in which the unique failure surface is identified using force equilibrium conditions. The computed Nγ values are found to be higher than Terzaghi’s value in the range 0.25–20%, with a diverging trend for higher values of angle of soil internal friction. A fairly good agreement is observed with other solutions which are based on finite difference coupled with associated flow rule, limit analysis, and limit equilibrium. Finally, the comparison with available experimental results vis-à-vis other solutions shows that, computed Nγ values are capable of making a reasonably good prediction.